|
|
Número de pieza | SX05 | |
Descripción | (SX01 / SX05) Silicon Pressure Sensor | |
Fabricantes | ETC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de SX05 (archivo pdf) en la parte inferior de esta página. Total 6 Páginas | ||
No Preview Available ! Silicon Pressure Sensors
SX 0 psi to 1 psi to 0 psi to 150 psi
SX Series
FEATURES
• Low Cost
• High-Impedance Bridge
• Absolute and
• Differential (Gauge)
• Low Noise
• Low Power Consumption
for Battery Power
TYPICAL APPLICATIONS
• Medical
www.DataSheet4U.•comInstrumentation
• Barometric
• Measurement
• Pneumatic Controls
• Battery Powered
Equipment
EQUIVALENT CIRCUITS
GENERAL DESCRIPTION
The SX Series pressure sensors provide the lowest cost components for
measuring pressures up to 150 psi. These sensors are designed for use with
non-corrosive, non-ionic media, such as air and dry gases. Convenient
pressure ranges are available to measure differential, gauge, and absolute
pressures from 0 psi to 1 psi (SX01) up to 0 psi to 150 psi (SX150).
Button, Nipple and N Packages
The Absolute (A) devices have an internal vacuum reference and an output
voltage proportional to absolute pressure. The differential (D) devices allow
application of pressure to either side of the diaphragm and can be used for
gauge or differential pressure measurements.
DIP Packages
WARNING
PERSONAL INJURY
DO NOT USE these products
as safety or emergency stop
devices or in any other
application where failure of
the product could result in
personal injury.
Failure to comply with
these instructions could
result in death or serious
injury.
This product is packaged in either the standard low cost chip carrier “button”
package, a plastic ported “N” package, or a DIP package. All packages are
designed for applications where the sensing element is integral to the OEM
equipment. These packages can be o-ring sealed, epoxied, and/or clamped
onto a pressure fitting. A closed-bridge four pin SIP configuration is provided
for electrical connection to the “Button” or “N” Package. The DIP Package
mounts on a PC board like a standard IC with through-hole pins. This
extremely small size package enables the use of multiple sensors in
applications with limited space.
WARNING
MISUSE OF DOCUMENTATION
• The information presented in this product sheet is for reference
only. Do not use this document as a product installation guide.
• Complete installation, operation, and maintenance information is
provided in the instructions supplied with each product.
Failure to comply with these instructions could result in death or
serious injury.
Sensing and Control
1 page Silicon Pressure Sensors
SX 0 psi to 1 psi to 0 psi to 150 psi
D2 DIP Package
SX Series
www.DataSheet4U.com
DD4 DIP Package
AD4 DIP Package
Honeywell • Sensing and Control 5
5 Page |
Páginas | Total 6 Páginas | |
PDF Descargar | [ Datasheet SX05.PDF ] |
Número de pieza | Descripción | Fabricantes |
SX01 | (SX01 / SX05) Silicon Pressure Sensor | ETC |
SX01 | (SX01 / SX05) Pressure Sensor | Sensym |
SX041 | (SX041 - SX043) Spread Spectrum Baseband Controllers | AMI |
SX042 | (SX041 - SX043) Spread Spectrum Baseband Controllers | AMI |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |