DataSheet.es    


PDF AL8807BQ Data sheet ( Hoja de datos )

Número de pieza AL8807BQ
Descripción AUTOMOTIVE GRADE 30V 1.3A PWM DIMMABLE BUCK LED DRIVER
Fabricantes Diodes 
Logotipo Diodes Logotipo



Hay una vista previa y un enlace de descarga de AL8807BQ (archivo pdf) en la parte inferior de esta página.


Total 18 Páginas

No Preview Available ! AL8807BQ Hoja de datos, Descripción, Manual

AL8807BQ
AUTOMOTIVE GRADE 30V 1.3A PWM DIMMABLE BUCK LED DRIVER
Description
The AL8807BQ is a step-down DC/DC converter designed to drive
LEDs with a constant current. The device can drive up to 9 LEDs,
depending on the forward voltage of the LEDs, in series from a
voltage source of 6V to 30V. Series connection of the LEDs provides
identical LED currents resulting in uniform brightness and eliminating
the need for ballast resistors. The AL8807BQ switches at frequency
up to 1MHz with controlled rise and fall times to reduce EMI. This
allows the use of small size external components, hence minimizing
the PCB area needed.
Maximum output current of AL8807BQ is set via an external resistor
connected between the VIN and SET input pins. Dimming is
achieved by applying a PWM signal at the CTRL input pin. An input
voltage of 0.4V or lower at CTRL switches off the output MOSFET
simplifying PWM dimming.
Pin Assignments
SET
GND
GND
CTRL
(Top View)
MSOP-8EP
Applications
Automotive Lamps
VIN
N/C
SW
SW
Features
LED driving current up to 1.3A
Better than 5% accuracy
High efficiency up to 96%
Optimally controlled switching speeds
Operating input voltage from 6V to 30V
PWM input for dimming control
Open-Circuit LED protection
LED Chain Short Circuited
Over-Temperature Protection
MSOP-8EP Available in “Green” Molding Compound (No Br, Sb)
with lead Free Finish/ RoHS Compliant
Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2)
Halogen and Antimony Free. “Green” Device (Note 3)
Automotive Grade
Qualified to AEC-Q100 Standards for High Reliability
PPAP Capable (Note 4)
Notes:
1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS) & 2011/65/EU (RoHS 2) compliant.
2. See http://www.diodes.com/quality/lead_free.html for more information about Diodes Incorporated’s definitions of Halogen- and Antimony-free, "Green"
and Lead-free.
3. Halogen- and Antimony-free "Green” products are defined as those which contain <900ppm bromine, <900ppm chlorine (<1500ppm total Br + Cl) and
<1000ppm antimony compounds.
4. Automotive products are AEC-Q100 qualified and are PPAP capable. Automotive, AEC-Q100 and standard products are electrically and thermally the
same, except where specified. For more information, please refer to http://www.diodes.com/quality/product_compliance_definitions/.
Typical Application Circuit
AL8807BQ
Document number: DS37011 Rev. 1 - 2
1 of 18
www.diodes.com
October 2014
© Diodes Incorporated

1 page




AL8807BQ pdf
Typical Performance Characteristics (cont.) (@TA = +25°C, unless otherwise specified.)
AL8807BQ
Figure 7 ILED vs. PWM Duty Cycle
Figure 8. Duty Cycle vs. Input Voltage
Figure 9. Efficiency vs. Input Voltage
Figure 10. On-time vs. Input Voltage
Figure. 11 SW Output Rise Time
AL8807BQ
Document number: DS37011 Rev. 1 - 2
5 of 18
www.diodes.com
Figure. 12 SW Output Fall Time
October 2014
© Diodes Incorporated

5 Page





AL8807BQ arduino
AL8807BQ
Applications Information (cont.)
Figures 35 and 36 show the PWM dimming performance of the AL8807BQ with a range of PWM frequencies with a nominal switching frequency
of 530kHz.
Figure 35 PWM Dimming at 530kHz nominal switching frequency
Looking at difference between duty cycle and percentage of full scale LED current yields a “Linearity Error”:
Figure 36 PWM Dimming Non-Linearity at 530kHz nominal switching frequency
The accuracy of the PWM dimming is affected by both the PWM frequency and also the switching frequency of the AL8807BQ. For best
accuracy/resolution the switching frequency should be increased while the PWM frequency should be reduced.
The CTRL pin is designed to be driven by both 3.3V and 5V logic levels directly from a logic output with either an open drain output or push pull
output stage.
AL8807BQ
Document number: DS37011 Rev. 1 - 2
11 of 18
www.diodes.com
October 2014
© Diodes Incorporated

11 Page







PáginasTotal 18 Páginas
PDF Descargar[ Datasheet AL8807BQ.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
AL8807BHIGH EFFICIENCY 36V 1.3A PWM DIMMABLE BUCK LED DRIVERDiodes
Diodes
AL8807BQAUTOMOTIVE GRADE 30V 1.3A PWM DIMMABLE BUCK LED DRIVERDiodes
Diodes

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar