|
|
HCNW139のメーカーはAvagoです、この部品の機能は「High Gain Optocouplers」です。 |
部品番号 | HCNW139 |
| |
部品説明 | High Gain Optocouplers | ||
メーカ | Avago | ||
ロゴ | |||
このページの下部にプレビューとHCNW139ダウンロード(pdfファイル)リンクがあります。 Total 14 pages
HCPL-0700, HCPL-0701, HCNW138, HCNW139,
6N139, 6N138,
Low Input Current, High Gain Optocouplers
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
These high gain series couplers use a Light Emitting
Diode and an integrated high gain photodetector to
provide extremely high current transfer ratio between
input and output. Separate pins for the photodiode
and output stage result in TTL compatible saturation
voltages and high speed operation. Where desired the
VCC and VO terminals may be tied together to achieve
conventional photodarlington operation. A base
access terminal allows a gain bandwidth adjustment to
be made.
The 6N139, HCPL-0701, and HCNW139 are for use in
CMOS, LSTTL or other low power applications. A 400%
minimum current transfer ratio is guaranteed over 0 to 70°C
operating range for only 0.5 mA of LED current.
The 6N138, HCPL-0700, and HCNW138 are designed for
use mainly in TTL applications. Current Transfer Ratio
(CTR) is 300% minimum over 0 to 70°C for an LED current
of 1.6 mA (1 TTL Unit load ). A 300% minimum CTR
enables operation with 1 TTL Load using a 2.2 kΩ
pull-up resistor.
Functional Diagram
NC 1
ANODE 2
CATHODE 3
NC 4
8 VCC
7 VB
6 VO
5 GND
TRUTH TABLE
LED VO
ON LOW
OFF HIGH
Features
• High current transfer ratio – 2000% typical (4500 %
typical for HCNW139/138)
• Low input current requirements – 0.5 mA
• TTL compatible output – 0.1 V VOL typical
• Performance guaranteed over temperature 0°C
to 70°C
• Base access allows gain bandwidth adjustment
• High output current – 60 mA
• Safetyapproval
- ULrecognized–3750Vrmsfor1 minuteand5000V
rms* for 1 minute per UL 1577
- CSA approved
- IEC/EN/DIN EN 60747-5-5 approved with VIORM =
1414 Vpeak for HCNW139 and HCNW138
• Available in 8-Pin DIP or SOIC-8 footprint or widebody
package
• MIL-PRF-38534 hermetic version available
(HCPL-5700/1)
Applications
• Ground isolate most logic families – TTL/TTL, CMOS/
TTL, CMOS/CMOS, LSTTL/TTL, CMOS/LSTTL
• Low input current line receiver
• High voltage insulation (HCNW139/138)
• EIA RS-232C line receiver
• Telephone ring detector
• 117 V ac line voltage status indicator – low input
power dissipation
• Low power systems – ground isolation
* 5000 V rms/1 minute rating is for HCNW139/138 and Option 020
(6N139/138) products only. A 0.1 µF bypass capacitor connected
between pins 8 and 5 is recommended.
CAUTION: It is advised that normal static precautions be taken in handling and assembly of this
component to prevent damage and/or degradation which may be induced by ESD. The components
featured in this datasheet are not to be used in military or aerospace applications or environments.
1 Page Ordering Information
6N138, 6N139, HCPL-0700 and HCPL-0701 are UL Recognized with 3750 Vrms for 1 minute per UL1577 and are ap-
proved under CSA Component Acceptance Notice #5, File CA 88324.
Part
Number
Option
RoHS non RoHS
Compliant Compliant
Package
Surface Gull
Mount Wing
Tape
& Reel
UL 5000 Vrms/
1 Minute IEC/EN/DIN
rating EN 60747-5-5 Quantity
6N138
6N139
-000E
-300E
no option
#300
XX
50 per tube
50 per tube
-500E
#500
XX
X
1000 per reel
-020E
-320E
-520E
#020
#320
#520
300 mil
DIP-8
X
X
X
X
X
X
X
X
50 per tube
50 per tube
1000 per reel
-060E
#060
X 50 per tube
-360E
#360
XX
X 50 per tube
-560E
#560
XX
X
X 1000 per reel
HCPL-0700
HCPL-0701
-000E
-500E
-060E
no option
#500
#060
SO-8
X
X
X
X
100 per tube
1500 per reel
X 100 per tube
-560E
#560
XX
X 1500 per reel
HCNW138
HCNW139
-000E
-300E
-500E
no option
#300
#500
400 mil
Widebody
DIP-8
X
X
X
X
X
42 per tube
42 per tube
750 per reel
To order, choose a part number from the part number column and combine with the desired option from
the option column to form an order entry.
Example 1:
6N138-560E to order product of 300 mil DIP Gull Wing Surface Mount package in Tape and Reel packaging
with IEC/EN/DIN EN 60747-5-5 Safety Approval and RoHS compliant.
Example 2:
HCPL-0700 to order product of 300 mil DIP package in Tube packaging and non RoHS compliant.
Option datasheets are available. Contact your Avago sales representative or authorized distributor for information.
Remarks: The notation ‘#XXX’ is used for existing products, while (new) products launched since July 15, 2001 and
RoHS compliant will use ‘–XXXE.’
3
3Pages 8-Pin Widebody DIP Package with Gull Wing Surface Mount Option 300 (HCNW139/HCNW138)
LAND PATTERN RECOMMENDATION
87 6 5
9.00 ± 0.15
(0.354 ± 0.006)
13.56
(0.534)
1234
11.23 ± 0.15
(0.442 ± 0.006)
1.55
(0.061)
MAX.
4.00
(0.158)
MAX.
1.80 ± 0.15
(0.071 ± 0.006)
2.54
(0.100)
BSC
0.75 ± 0.25
(0.030 ± 0.010)
DIMENSIONS IN MILLIMETERS (INCHES).
LEAD COPLANARITY = 0.10 mm (0.004 INCHES).
NOTE: FLOATING LEAD PROTRUSION IS 0.25 mm (10 mils) MAX.
1.3
(0.051)
2.29
(0.09)
12.30 ± 0.30
(0.484 ± 0.012)
11.00
(0.433)
MAX.
1.00 ± 0.15
(0.039 ± 0.006)
7° NOM.
0.254
+ 0.076
- 0.0051
(0.010
+ 0.003)
- 0.002)
6
6 Page | |||
ページ | 合計 : 14 ページ | ||
|
PDF ダウンロード | [ HCNW139 データシート.PDF ] |
データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。 |
部品番号 | 部品説明 | メーカ |
HCNW135 | Single Channel/ High Speed Optocouplers | Agilent(Hewlett-Packard) |
HCNW135 | High Speed Optocouplers | AVAGO |
HCNW136 | Single Channel/ High Speed Optocouplers | Agilent(Hewlett-Packard) |
HCNW136 | High Speed Optocouplers | AVAGO |