|
|
Número de pieza | ETK2011 | |
Descripción | Digital audio power amplifier IC | |
Fabricantes | Etek Microelectronics | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de ETK2011 (archivo pdf) en la parte inferior de esta página. Total 2 Páginas | ||
No Preview Available ! General Description
ETK2011 is a digital audio power amplifier IC with maximum output of 2.5W (RL=4Ω)×1ch.
ETK2011 has a “Pure Pulse Direct Speaker Drive Circuit” which directly drives speakers while reducing distortion of pulse
output signal and reducing noise on the signal, and realizes the highest standard low distortion rate characteristics and
low noise characteristics among digital amplifier ICs for mobile use.
In addition, circuit design with fewer external parts can be made depend on the condition of use because corresponds to
filter less.
The ETK2011 features nonclip output control function which detects output signal clip due to the over level input signal
and suppress the output signal clip automatically. Also the nonclip output control function can adapt the output clip
caused by power supply voltage down with battery. This is the difference from the traditional AGC (Auto Gain Control) or
ALC (Auto Level Control) circuit.
ETK2011 has the powerdown function which can minimize the power consumption in the standby state.
As for protection function, over current protection function for speaker output terminal, over temperature protection
function for inside of the device, and low supply voltage malfunction preventing function are prepared.
Features
Maximum output
2.5W×1ch (VDD=5.0V, RL=4Ω, THD+N=10%)
1.3W×1ch (VDD=3.6V, RL=8Ω, THD+N=10%)< /li>
Distortion Rate (THD+N)
0.03% (VDD=3.6V, RL=8Ω, PO=0.4W, 1kHz)
Residual Noise
45µVrms (VDD=3.6V, Av=18dB)
Efficiency
84% (VDD=3.6V, RL=8Ω, PO=600mW)
78% (VDD=3.6V, RL=8Ω, PO=100mW)< /li>
S/N Ratio
94dB (VDD=3.6V, Av=18dB)
Overcurrent Protection function
Thermal Protection function
Low voltage Malfunction Prevention function
Pop noise reduction function
Powerdown control function
Powerdown High speed Recovery function
Package: WLCSP
Pin Configuration
1 page |
Páginas | Total 2 Páginas | |
PDF Descargar | [ Datasheet ETK2011.PDF ] |
Número de pieza | Descripción | Fabricantes |
ETK2011 | Digital audio power amplifier IC | Etek Microelectronics |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |