|
|
PDF TB731P Data sheet ( Hoja de datos )
| Número de pieza | TB731P | |
| Descripción | IN-DASH WIDE COLOR LCD TV Manual | |
| Fabricantes | clarion | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de TB731P (archivo pdf) en la parte inferior de esta página. Total 18 Páginas | ||
|
No Preview Available !
Owner’s manual & Installation manual
IN-DASH WIDE 7" COLOR LCD TV
2003/3 (A·C)
Clarion Co., Ltd.
All Rights Reserved. Copyright © 2003: Clarion Co., Ltd.
QZ7532K
280-7960-00
1 page  
5. CAUTIONS ON HANDLING
For a longer service life, be sure to read the
following cautions.
• Be sure to store the LCD panel inside the
source unit when parking the car outdoors
for long periods of time.
The LCD panel will operate properly in a
temperature range of 0 to 60°C.
• Don’t allow any liquids on the set from
drinks, umbrellas etc. Doing so may damage
the internal circuitry.
• Do not disassemble or modify the set in any
way. Doing so may result in damage.
• Do not draw the LCD panel out and use it as
a tray. Also, subjecting the LCD panel to
shocks may result in breakage, deformation
or other damage.
• Do not let cigarettes burn the display. Doing
so may damage or deform the cabinet.
• Do not insert objects into the video input
jack.
• If a problem should occur, have the set
inspected at your store of purchase.
• Do not insert objects or poke in the space
between the LCD panel and the source unit
when the panel is tilted.
• Do not place anything on the display when
the LCD panel is tilted.
• Do not hold on the screen when adjusting
the angle of the LCD panel. Doing so may
damage it.
• The remote controller may not work if the
remote control sensor is exposed to direct
sunlight.
• The fluorescent light used behind the screen
eventually wears out. It should be replaced if
the picture becomes extremely dark or
flickers.
• The LCD panel may stop temporarily when it
is opened or closed when the engine is
stopped or when it is cold. This is not a
malfunction. If this happens, repeat the
operation.
Concerning the LCD screen
• Do not leave droplets of water on the LCD
panel since they can cause discoloration
and stains. In addition, entry of moisture
inside the unit can cause malfunctioning.
Any drops of water on the panel should be
removed immediately using absorbent
cotton or a soft cloth.
• In extremely cold weather, the movement of
the picture may be slow and the screen may
be dark, but this is not a malfunction. The
set will work normally once the temperature
increases.
• Small black and shiny dots inside the LCD
panel are normal for LCD products.
Cleaning
• Cleaning the cabinet
Use a soft, dry cloth and gently wipe off the
dirt.
For tough dirt, apply some neutral detergent
diluted in water to a soft cloth, wipe off the
dirt gently, then wipe again with a dry cloth.
Do not use benzene, thinner, car cleaner,
etc., as these substances may damage the
cabinet or cause the paint to peel. Also,
leaving rubber of plastic products in contact
with the cabinet for long periods of time may
cause stains.
• Cleaning the LCD panel
The LCD panel tends to collect dust, so wipe
it off occasionally with a soft cloth.
The surface is easily scratched, so do not
rub it with hard objects.
Concerning the wide
screen
• A wide-screen TV comes with a function for
selecting various screen modes. If you
select a screen mode that differs from the
picture ratio of the TV program or other
software media, you will not be able to view
the original pictures as was originally
intended. Bear this point in mind when
selecting the screen mode.
TB731P/TB732P/TB733W
7
5 Page 
Problem
Cause
Measure
The image is not The parking brake is not
displayed.
pulled.
Check that the parking brake is applied.
The display is
dark.
The brightness control is too Adjust the brightness properly.
low.
The operating condition is
not good.
The temperature inside the vehicle may be 0˚C or
less. Set to an appropriate temperature (25˚C or so)
and check it again.
The headlight of the vehicle The display is made dark at night to prevent the
is lit.
glare (When the headlight of the vehicle is lit in the
daytime, the display gets dark).
The color of the
display is light or
a shade of color
is not good.
The color is not adjusted
adequately.
Check that COL and HUE are adjusted properly.
When the VTR is
connected, the
image is
disturbed.
Improper NTSC/PAL setting
Set the NTSC/PAL properly according to the VTR.
The image gets Bad receiving condition
unclear.
A radio wave may not reach sufficiently due to
obstruction of mountains or buildings. Check it again
at a place where a radio wave can be received
properly.
The TV tuner has Bad receiving condition
a double or triple
image.
It may be under the influence of radio wave reflected
by mountains or buildings. Check it again after
changing place or direction.
The TV tuner has Presence of jamming
spots or stripes in
the image.
It may be under the influence from automobiles,
streetcar, power cable, neon sign, and so forth.
Check it again after changing place.
There are red,
green, and blue
points in the
display.
This is not a failure, but a phenomenon peculiar to a
liquid crystal panel (The LCD panel is produced
according to technology with very high precision.
Note that, though there are effective pixels of
99.99% or more, pixel missing or normally lit pixels
account for 0.01%).
9. SPECIFICATIONS
LCD Monitor
Screen size: 7-inch wide type (152 mm
Width ✕ 85 mm Height)
Display method: Transmission type TN liquid
crystal display
Drive method: TFT(thin-film transistor) active
matrix driving
Pixels:
336.960 (1440 ✕ 234)
TV Tuner
Tuning system: PLL synthesizer system
Reception channels:
• TB731P
VHF: CCIR
2 to 12 ch
(47 to 230 MHz)
NEW ZEALAND 1 to 11 ch
(44 to 230 MHz)
AUSTRALIA
0 to 11ch
(45 to 222 MHz)
UHF: CCIR
21 to 69 ch
(470 to 862 MHz)
NEW ZEALAND 21 to 69 ch
(470 to 862 MHz)
AUSTRALIA
28 to 69ch
• TB732P
(526 to 820 MHz)
VHF: 1 to 12 ch (48.5 to 223 MHz)
UHF: 13 to 57 ch (470 to 870 MHz)
• TB733W
VHF: 2 to 13 ch (54 to 216 MHz)
UHF: 14 to 69 ch (470 to 806 MHz)
Antenna input: 75 Ω unbalanced
Input/Output
Video input:
1.0 ± 0.2 Vp-p (input impedance 75 Ω)
Audio input:
130 ± 60 mVrms (input impedance 45 kΩ or
greater)
Video output:1.0 V ± 0.2 Vp-p (output
impedance 75 Ω)
Audio output:
HIGH 230 ± 100 mV (at VTR Input 130 mV)
LOW 125 ± 50 mV (at VTR Input 130 mV)
(LOAD RESISTANCE 10 kΩ)
General
Power source voltage: DC13.2 V
(10.8 to 15.6 V)
Ground:
Negative
Current consumption: Less than 2.0 A
Weight:
1.75 kg
Dimensions:
178 mm Width ✕
50 mm Height ✕
165 mm Depth
172
178 50
Dimentions of Remote Control Unit:
44 mm Width ✕
27.2 mm Height ✕
110 mm Depth
Weight of the Remote Control Unit: 50 g
Note:
• Specifications and design are subject to change
without notice for further improvement.
18
TB731P/TB732P/TB733W
TB731P/TB732P/TB733W
19
11 Page | ||
| Páginas | Total 18 Páginas | |
| PDF Descargar | [ Datasheet TB731P.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| TB731P | IN-DASH WIDE COLOR LCD TV Manual | clarion |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |