|
|
PDF FM-3528WNS-460R Data sheet ( Hoja de datos )
| Número de pieza | FM-3528WNS-460R | |
| Descripción | TOP LED | |
| Fabricantes | NATIONSTAR OPTOELECTRONICS | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de FM-3528WNS-460R (archivo pdf) en la parte inferior de esta página. Total 15 Páginas | ||
|
No Preview Available !
佛山市国星光电股份有限公司
FOSHAN NATIONSTAR OPTOELECTRONICS CO., LTD
产品规格书
S P E C I F I C AT I O N
顾客名称
Customer
顾客部品号
Customer No.
产品名称
Product
产品型号
Type
TOP LED
FM-3528WNS-460R
顾客确认
APPROVED SIGNATURES
地址：广东省佛山市禅城区华宝南路 18 号
Add: NO.18 South Huabao Rd,Foshan,Guangdong,China
电话（Tel）：0086-0757-83985604,83985605,83985607
传真（Fax）：0086-0757-82100221,82100223
邮编（Zip）：528000
http://www.nationstar.com
研究开发中心
Research & Development Center
批准
审核
制定
APPROVE
CHECK
DRAW
版本号（Version NO）：A3
首次发放日期 (Release Date)：2011-05-04
1 page  
TOP 发光二极管
可靠性试验
Reliability Test Items And Conditions
试验项目
Test Items
可焊性试验
Solderability
温度快速变化继之以
循环湿热
Thermal Shock Followed by
High Temperature And High
Humidity Cyclic
耐焊接热试验
Resistance For Soldering Heat
电耐久性试验
DC Operating Life
高温贮存试验
High Temperature Storage
循环湿热
High Temperature And High
Humidity Cyclic
试验条件
Test Conditions
焊接温度（Solder Temperature）：300℃
焊接时间（Solder Duration）：（3.5±0.5）sec.
5 次循环
5 Cycles
-40℃ 10 min.
转移
Shift
(2~3) min.
100℃ 10 min.
25℃~55℃
（90%~95%）RH
2 次循环 48 hrs.，恢复 2 hrs.
2 Cycles for 48 hrs. Recover for 2 hrs.
红外回流焊法
Reflow Soldering
1000 hrs.
正向电流：25mA
Forward Current：25mA
100℃ 1000 hrs.
25℃~55℃
（90%~95%）RH
6 次循环 144 hrs.，恢复 2 hrs.
6 Cycles for 144 hrs. Recover for 2 hrs.
试验数量
Quantity
15
11
15
22
15
11
判断标准
Judging Criteria
湿润良好
上锡面积在 95%以上
Solderable Area
Over 95%
C=0 & II
C=0 & II
C=0 & I
C=0 & I
C=0 & I
失效判断标准 Criteria For Judging Damage
测试项目
Items
符号
Symbol
测试条件
Test Conditions
正向电压
Forward Voltage
VF
IF=20mA
反向电流
Reverse Current
IR
VR=5V
光强
Luminous Intensity
IV
IF=20mA
* USL：标准值上限值，**LSL：标准值下限值
失效判断标准 I
Criteria For Judging Damage I
≥USL*×1.2
失效判断标准 II
Criteria For Judging Damage II
≥USL
≥USL×2.0
≥USL
≤LSL**×0.5
≤LSL
* USL: Upper Standard Level, **LSL: Lower Standard Level
4
5 Page 
TOP 发光二极管
使用注意事项（1）
Precautions (1)
1. 贮存：
Storage
· 本产品使用密封防潮抗静电袋包装，并附有干燥剂，未开封的产品有一年的保存时间。
Moisture proof and anti-electrostatic package with moisture absorbent material is used, to keep moisture to a
minimum.
· 开封前，产品须存放在温度不高于 30℃，湿度不高于 60%RH 的环境中。
Before opening the package, the product should be kept at 30℃ or less and humidity less than 60% RH, and be
used within a year.
· 开封后，产品须存放在温度不高于 30℃，湿度不高于 10%RH 的环境中，且应该在 24 小时（1 天）内使用
完。建议工作环境为温度不高于 30℃，湿度不高于 60%RH。
After opening the package, the product should be stored at 30℃ or less and humidity less than 10%RH, and be
soldered within 24 hours (1 day). It is recommended that the product be operated at the workshop condition of
30℃ or less and humidity less than 60%RH.
· 对于尚未焊接的 LED，如果吸湿剂或包装失效，或者产品没有符合以上有效存储条件，烘焙可以起到一定
的性能恢复效果。烘焙条件：（80±5）℃，持续 24 小时。
If the moisture absorbent material has fade away or the LEDs have exceeded the storage time, baking treatment
should be performed based on the following condition: (80±5)℃ for 24 hours.
2. 静电：
Static Electricity
静电和电涌会导致产品特性发生改变，例如正向电压降低等，如果情况严重甚至会损毁产品。所以在使用
时必须采取有效的防静电措施。
所有相关的设备和机器都应该正确接地，同时必须采取其他防止静电和电涌的措施。
使用防静电手环，防静电垫子，防静电工作服、工作鞋、手套，防静电容器，都是有效的防止静电和电涌
的措施。
Static electricity or surge voltage damages the LEDs. Damaged LEDs will show some unusual characteristic such
as the forward voltage becomes lower, or the LEDs do not light at the low current. even not light.
All devices, equipment and machinery must be properly grounded. At the same time, it is recommended that wrist
bands or anti-electrostatic gloves, anti-electrostatic containers be used when dealing with the LEDs.
10
11 Page | ||
| Páginas | Total 15 Páginas | |
| PDF Descargar | [ Datasheet FM-3528WNS-460R.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| FM-3528WNS-460R | TOP LED | NATIONSTAR OPTOELECTRONICS |
| FM-3528WNS-460T | TOP LED | NATIONSTAR OPTOELECTRONICS |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |