DataSheet.jp

GM5862H の電気的特性と機能

GM5862HのメーカーはSTMicroelectronicsです、この部品の機能は「(GM5862H / GM5868H) LCD monitor controllers」です。


製品の詳細 ( Datasheet PDF )

部品番号 GM5862H
部品説明 (GM5862H / GM5868H) LCD monitor controllers
メーカ STMicroelectronics
ロゴ STMicroelectronics ロゴ 




このページの下部にプレビューとGM5862Hダウンロード(pdfファイル)リンクがあります。

Total 6 pages

No Preview Available !

GM5862H Datasheet, GM5862H PDF,ピン配置, 機能
GM5862H, GM5868H
LCD monitor controllers with RTC up to WUXGA
Data Brief
Features
Triple ADC and PLL up to 205 MHz
Integrated Ultra-Reliable DVI® receiver up to
165 MHz (GM5862 and GM5822)
Integrated HDMI 1.1 receiver up to 165 MHz
(GM5868H and GM5828H)
HDCP supported with GM58xxH versions
ITU656 video input
ITU601 (16-bit) video input
Response Time Compensation (RTC) with
single 1Mx16 SDR SDRAM up to UXGA panels
Optional Frame Rate Conversion (FRC) using
two 1Mx16 SDR SDRAM up to SXGA 75 Hz
Panoramic scaling for wide output resolutions
TV color controls using ACC and ACM-3D
Versatile OSD controller for high quality
bitmap-like TV OSD
Embedded x86 microprocessor with external
SPI Flash ROM
Dual LVDS transmitter for direct interconnect to
LCD panels up to WUXGA 60 Hz
Package: 256-pin PQFP
Applications
LCD monitors with RTC up to WUXGA
resolutions
Video
16-bit TTL Input
HDMI
YPrPb /
RGB Inputs
H Sync
V Sync
General Purpose
Input /Outputs
ITU656
VBI Parsing
ITU601
(FLI5962 only)
HDMI Rx
HDCP
Test Pattern
Generator
Analog Front End
Tripple ADC
Sync Slicer
VBI Processing
Test Pattern
Generator
Embedded
Micro-processor
Sync
Processor
Internal Micro-
processor Bus
Optional PIP
Channel
Input Processor
Input
Format
Measurement
Main Channel
Input Processor
ROM
RAM
PIP Image Processing
Separate H & V
Scaling
3x3 Matrix
External
SDR Memory Interface
Memory
Controller
De-interlacer
Image Enhancement
ACC/ACM-II or
ACM-3D
3x3 Matrix
Display Processing
Separate H & V
Scaling
Variable Zoom
Scaling
Horizontal Edge
Enhancement
(HEM)
Aspect Ratio
Conversion
Response Time
Compensation
GPIO's
Clock
Generation
SPI Serial PROM Interface
Low
Bandwidth
ADC
Low Bandwidth Analog Inputs
HDMI Audio
Interface
(gm5868/28
only)
SPDIF Four I2C
PWM
PWM
Interface
Two-wire
Serial
Master 1
Two-wire
Interface
OSD
Controller
Two-wire
Serial
Master 2
Two-wire
Interface
Dual
LVDS
Tx
LVDS
Output
Output
Formatter
24-bit
TTL Output
DDC2bi
Slave 1
DDC2bi
Slave 2
DDC2bi
Interface
DDC2bi
Interface
September 2008
Rev 1
For further information contact your local STMicroelectronics sales office.
1/6
www.st.com
6
Free Datasheet http://www.datasheet4u.com/

1 Page





GM5862H pdf, ピン配列
GM5862H, GM5868H
2 Feature attributes
Feature attributes
Dual analog input
– Operation up to 205 MHz
– Dual RGB inputs
– Single RGB and single YPbPr up to 1080i inputs
– Bi-level and tri-level analog sync support and Macrovision™ support
– Dual HSYNC, VSYNC, and SOG inputs
Ultra-Reliable DVI/HDMI 1.1 input
– HDMI 1.1, DVI 1.0, and HDCP 1.1—operates up to 165 MHz
– Receives and outputs 2 to 8 channels of digital audio up to 192 KHz. Four
programmable I2S and one SPDIF output
Digital video input
– ITU656 video input support for commercially available video decoder
– ITU601 (16-bit) video input support for external MPEG2 decoder, DVI Rx, and
ADC
High quality advanced scaling engine
– Independent and programmable horizontal and vertical scaling factors
– Panoramic scaling (non-linear)
– Variable sharpness settings
Optional Picture-in-Picture (PIP)
– Variable PIP window size up to 640 x 480
– Video PIP on Graphics or Graphics PIP on Video
– Independent PIP window color controls
– Requires two 1Mx16 SDR SDRAM
Optional frame rate conversion
– 16-bit/32-bit data path to support single or dual 1Mx16 SDR SDRAM
– Full frame rate conversion up to SXGA 75 Hz
Response time compensation
– Compensates motion blur that results from slow response time of LCD panels
resulting in motion image that is clean and crisp
OSD controller
– Up to 4 windows
– 1, 2 or 4-bits per pixel color
– Blinking, transparency, blending, and proportional fonts support
Output support up to WUXGA 60 Hz
– Dual-channel LVDS transmitters with pin swap for flexibility in PCB layout
– Optional 24-bit TTL output
System-on-chip integration for lower BOM
– On-chip reset circuit with integrated Schmitt trigger for HSYNC and VSYNC
– Embedded x86 MCU with serial interface
– General purpose low bandwidth ADC
– Integrated gamma and 3x3 LUT for sRGB compliance
– ESM® and boundary scan support
3/6
Free Datasheet http://www.datasheet4u.com/


3Pages


GM5862H 電子部品, 半導体
GM5862H, GM5868H
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2008 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
6/6
Free Datasheet http://www.datasheet4u.com/

6 Page



ページ 合計 : 6 ページ
 
PDF
ダウンロード
[ GM5862H データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
GM5862H

(GM5822H / GM5862H) highly integrated mixed signal LCD controller

Genesis
Genesis
GM5862H

(GM5862H / GM5868H) LCD monitor controllers

STMicroelectronics
STMicroelectronics


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap