DataSheet.es    


PDF IRUH50PA23A1M Data sheet ( Hoja de datos )

Número de pieza IRUH50PA23A1M
Descripción Ultra Low Dropout Positive Adjustable Linear Regulator
Fabricantes International Rectifier 
Logotipo International Rectifier Logotipo



Hay una vista previa y un enlace de descarga de IRUH50PA23A1M (archivo pdf) en la parte inferior de esta página.


Total 7 Páginas

No Preview Available ! IRUH50PA23A1M Hoja de datos, Descripción, Manual

PD-97032A
Ultra Low Dropout
Positive Adjustable Linear Regulator
IRUH50PA23A1M
+5.0Vin at 3.0A
Product Summary
Part Number Dropout
IRUH50PA23A1M
0.4V
IO
3.0A
Vin
5.0V
Vout
1.265V To (VIN - 0.4V)
8-LEAD FLAT PACK
The IRUH50PA23A1M is a space qualified, ultra low
dropout linear regulator designed specifically for space
applications. This product has been characterized to a total
ionizing dose of 1.0Mrad(Si) per MIL-STD-883, Method
1019 at both high and low dose rates under biased and
unbiased conditions to account for ELDRS effects in bipolar
devices. The ultra low dropout voltage of 0.4V @ 3A makes
the part particularly useful for applications requiring low
noise and higher efficiency.
Features:
n Total dose to 1.0Mrad(Si) and low dose
capability to 500 Krad(Si) allows use in
space applications
n Single Event latchup Immune
LET = 84 MeV/(mg/cm2)
Fluency = 1 x 109 Ions/cm2
n Low noise, higher efficiency
n Ultra low dropout voltage of 0.4V@ 3A out
significantly reduces power consumption
n Remote shutdown permits power
sequencing to be easily implemented
n Hermetic 8-lead flat pack ensures higher
reliability
n Space Level Screened
n This part is also available in MO-078 Package
as IRUH50PA23B1M
Absolute Maximum Ratings
Parameter
Output Current
Input Voltage
Output Voltage
Power Dissipation, TC = 25°C
Thermal Resistance, Junction to Case
Operating Temperature Range
Storage Temperature Range
Lead Temperature
Symbol
IO
VIN
VOUT
PTOT
RTHJC
TJ
TS
TL
Value
3.5
7.0
1.265V To (VIN - 0.4V)
19
6.5
-55 to +125
-65 to +150
300
Units
A
V
W
°C/W
°C
www.irf.com
1
01/09/06
www.DataSheet.in

1 page




IRUH50PA23A1M pdf
Vin
100uF 16V
Tantalum
IRUH50PA23A1M
Vin Vout
IRUH50PA23A1M
SHDN
GND
ADJUST
RESISTOR
R1
1.0uFX10
CeramicX7R
Vout
1000uF 6.3V
Low ESR Tantalum
Ground
Vout = Vref X ( 1+ R1/1000 )
Fig 2. Typical Application Circuit
Input Capacitance
Recommended input capacitance for a generic application is a 100µF, 16V tantalum capacitor. However, the
input capacitance is not critical to the stability of the regulator and is therefore application dependant. In
designs with a clean bus voltage that is situated close to the input of the regulator, only a small ceramic
capacitor will be needed to decouple high frequency noise. On the other hand , in designs with a noisy bus,
a larger capacitor will be needed. Care should be taken to ensure that the input to the regulator is sufficiently
free of noise and disturbances.
Output Capacitance
Like most ultra low dropout voltage regulators, IRUH50PA23A1M requires the use of output capacitors as
part of the device frequency compensation. The device requires a minimum of 220µF tantalum to ensure
stability.
Many different types of capacitor are available and have widely varying characteristics. These capacitors
differ in capacitor tolerance, equivalent series resistance (ESR), equivalent series inductance and capacitance
temperature coefficient. The IRUH50PA23A1M frequency compensation optimizes frequency response with
low ESR capacitors. In general, use capacitors with an ESR of less than 50mfor heavy load applications.
High quality bypass capacitors must be also be used to limit the high frequency noise generated by the load.
Multiple small ceramic capacitors are typically required to limit parasitic inductance (ESL) and ESR in the
capacitors to acceptable levels.
The upper limit of the capacitance is governed by the delayed over-current latch function of the regulator. The
regulator has a protection circuit that will latch the device off in the event of a short circuit. However, since it is
known that the regulator will draw a large in-rush current upon startup, the latch-off is delayed by about 10ms
to allow the outout capacitors to charge to a steady state without shutting down. During this period, the
regulator will have an output current at its maximum of around 5A typical. Therefore, the maximum output
capacitance can be as high as 20,000µF without causing device to latch-off during start-up.
www.irf.com
5
www.DataSheet.in

5 Page










PáginasTotal 7 Páginas
PDF Descargar[ Datasheet IRUH50PA23A1M.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
IRUH50PA23A1MUltra Low Dropout Positive Adjustable Linear RegulatorInternational Rectifier
International Rectifier

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar