IRUH50P333B1M Datasheet PDF - International Rectifier
| Part Number | IRUH50P333B1M | |
| Description | Ultra Low Dropout Fixed Positive Linear Regulator | |
| Manufacturers | International Rectifier | |
| Logo |  |
|
|
There is a preview and IRUH50P333B1M download ( pdf file ) link at the bottom of this page. Total 7 Pages | ||
Preview 1 page No Preview Available !
PD-97027
Ultra Low Dropout
Fixed Positive Linear Regulator
IRUH50P333B1M
+5.0Vin to +3.3Vout at 3.0A
Product Summary
Part Number Dropout
IO
Vin Vout
IRUH50P333B1M
0.4V
3.0A
5.0V
3.3V
MO-078AA
The IRUH50P333B1M is a space qualified, ultra low
dropout linear regulator designed specifically for space
applications. This product has been characterized to a total
ionizing dose of 1.0 Mrad(Si) per MIL-STD-883, Method
1019 at both high and low dose rates under biased and
unbiased conditions to account for ELDRS effects in bipolar
devices. The ultra low dropout voltage of 0.4V@ 3A makes
the part particularly useful for applications requiring low
noise and higher efficiency.
Features:
n Total dose to 1.0 Mrad(Si) and low dose
capability to 500 Krad(Si) allows use in
space applications
n Single Event latchup Immune
LET = 84 MeV/(mg/cm2)
Fluency = 1 x 109 Ions/cm2
n Low noise, higher efficiency
n Ultra low dropout voltage of 0.4V@ 3A out
significantly reduces power consumption
n Remote shutdown permits power
sequencing to be easily implemented
n Hermetic MO-078AA (TO-258AA)
pack ensures higher reliability
n Space Level Screened
n This part is also available in 8- Lead Flat Pack
Package as IRUH50P333A1M
Absolute Maximum Ratings
Parameter
Output Current
Input Voltage
Power Dissipation, TC = 25°C
Thermal Resistance, Junction to Case
Operating Temperature Range
Storage Temperature Range
Lead Temperature
Symbol
IO
VIN
PTOT
RTHJC
TJ
TS
TL
Value
3.5
7.0
19
6.5
-55 to +125
-65 to +150
300
Units
A
V
W
°C/W
°C
www.irf.com
1
11/15/05
www.DataSheet.in
|
| |
 
IRUH50P333B1M
Vin
100uF 16V
Tantalum
Vin Vout
IRUH50P333B1M
SHDN
GND
Vout
1.0uFx10
Ceramic X 7R
1000uF 6.3V
Low ESR Tantalum
Ground
Fig 2. Typical Application Circuit
Input Capacitance
Recommended input capacitance for a generic application is a 100µF, 16V tantalum capacitor. However, the
input capacitance is not critical to the stability of the regulator and is therefore application dependant. In
designs with a clean bus voltage that is situated close to the input of the regulator, only a small ceramic
capacitor will be needed to decouple high frequency noise. On the other hand , in designs with a noisy bus,
a larger capacitor will be needed. Care should be taken to ensure that the input to the regulator is sufficiently
free of noise and disturbances.
Output Capacitance
Like most ultra low dropout voltage regulators, IRUH50P333B1M requires the use of output capacitors as
part of the device frequency compensation. The device requires a minimum of 220µF tantalum to ensure
stability.
Many different types of capacitor are available and have widely varying characteristics. These capacitors
differ in capacitor tolerance, equivalent series resistance (ESR), equivalent series inductance and capacitance
temperature coefficient. The IRUH50P333B1M frequency compensation optimizes frequency response with
low ESR capacitors. In general, use capacitors with an ESR of less than 50mΩ for heavy load applications.
High quality bypass capacitors must be also be used to limit the high frequency noise generated by the load.
Multiple small ceramic capacitors are typically required to limit parasitic inductance (ESL) and ESR in the
capacitors to acceptable levels.
The upper limit of the capacitance is governed by the delayed over-current latch function of the regulator. The
regulator has a protection circuit that will latch the device off in the event of a short circuit. However, since it is
known that the regulator will draw a large in-rush current upon startup, the latch-off is delayed by about 10ms
to allow the outout capacitors to charge to a steady state without shutting down. During this period, the
regulator will have an output current at its maximum of around 5A typical. Therefore, the maximum output
capacitance can be as high as 20,000µF without causing device to latch-off during start-up.
www.irf.com
5
www.DataSheet.in
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for IRUH50P333B1M electronic component. |
| Information | Total 7 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ IRUH50P333B1M.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| IRUH50P333B1M | The function is Ultra Low Dropout Fixed Positive Linear Regulator. International Rectifier | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
IRUH
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||