|
|
FSP3127のメーカーはFOSLINK SEMICONDUCTORです、この部品の機能は「150KHZ 500MA STEP DOWN VOLTAGE REGULATOR」です。 |
部品番号 | FSP3127 |
| |
部品説明 | 150KHZ 500MA STEP DOWN VOLTAGE REGULATOR | ||
メーカ | FOSLINK SEMICONDUCTOR | ||
ロゴ | |||
このページの下部にプレビューとFSP3127ダウンロード(pdfファイル)リンクがあります。 Total 8 pages
www.DataSheet4U.com
150KHZ 500MA STEP DOWN VOLTAGE REGULATOR
FEATURES
z 3.3V, 5V, 12V, and adjustable output versions
z Adjustable version output voltage range, 1.2V to
37V ±4% max over line and load conditions
z Available in 8-pin surface mount and DIP-8
package
z Guaranteed 0.5A output current
z Input voltage range up to 40V
z Requires only 4 external components
z 150 kHz fixed frequency internal oscillator
z TTL Shutdown capability
z Low power standby mode, IQ typically 85 µA
z High Efficiency
z Uses readily available standard inductors
z Thermal shutdown and current limit protection
Typical Application
z Simple high-efficiency step-down (buck)
regulator
z Efficient pre-regulator for linear regulators
z On-card switching regulators
z Positive to Negative convertor
PIN ASSIGNMENT
(Top View)
*1
*2
*3
FB 4
8 OUTPUT
7 VIN
6 GND
5 ON/OFF
FSP3127
GENERAL DESCRIPTION
The FSP3127 series of regulators are monolithic
integrated circuits that provide all the active functions
for a step-down (buck) switching regulator, capable
of driving a 0.5A load with excellent line and load
regulation. These devices are available in fixed
output voltages of 3.3V, 5V, 12V, and an adjustable
output version, and are packaged in a 8-lead DIP and
a 8-lead surface mount package.
Requiring a minimum number of external
components, these regulators are simple to use and
feature internal frequency compensation, a
fixed-frequency oscillator, and improved line and
load regulation specifications.
The FSP3127 series operates at a switching
frequency of 150 kHz thus allowing smaller sized
filter components than what would be needed with
lower frequency switching regulators. Because of its
high efficiency, the copper traces on the printed
circuit board are normally the only heat sinking
needed.
A standard series of inductors (both through hole and
surface mount types) are available from several
different manufacturers optimized for use with the
FSP3127 series. This feature greatly simplifies the
design of switch-mode power supplies.
Other features include a guaranteed ±4% tolerance
on output voltage under all conditions of input
voltage and output load conditions, and ±15% on the
oscillator frequency. External shutdown is included,
featuring typically 85 µA stand-by current. Self
protection features include a two stage frequency
reducing current limit for the output switch and an
over temperature shutdown for complete protection
under fault conditions.
*: Pin 1,2,3 No internal connection, but should be soldered to PC board for best heat transit
ABSOLUTE MAXIMUM RATINGS(NOTE1)
Parameter
Value
Unit
Maximum Supply Voltage
45 V
ON/OFF Pin Input Voltage
-0.3 to 25
V
Feedback Pin Voltage
– 0.3 to 25
V
Output Voltage to Ground(Steady State)
-1 V
Power Dissipation
Internally limited
Maximum Junction Temperature
+150
°C
ESD Susceptibility(Note 2)
2000
V
Storage Temperature
-65 to 150
°C
Lead Temperature (SOP8L)
Vapor Phase (60 sec.)
Infrared (15 sec.)
215
220
°C
Lead Temperature (PDIP8L) (Soldering, 10 sec)
260
°C
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating
Ratings indicate conditions for which the device is intended to be functional, but do not guarantee specific
performance limits. For guaranteed specifications and test conditions, see the Electrical Characteristics.
Note 2: The human body model is a 100 pF capacitor discharged through a 1.5k resistor into each pin.
1/8 2007-4-9
1 Page www.DataSheet4U.com
150KHZ 500MA STEP DOWN VOLTAGE REGULATOR
FUNCTIONAL BLOCK DIAGRAM
FSP3127
FUNCTIONAL DESCROPTION
Pin Functions
VIN
This is the positive input supply for the IC switching regulator. A suitable input bypass capacitor must be present at
this pin to minimize voltage transients and to supply the switching currents needed by the regulator.
Ground
Circuit ground.
Output
Internal switch. The voltage at this pin switches between (VIN - VSAT) and approximately +0.5V, with a duty cycle of
VOUT/VIN. To minimize coupling to sensitive circuitry, the PC board copper area connected to this pin should be kept to
a minimum.
Feedback
Senses the regulated output voltage to complete the feedback loop.
ON/OFF
Allows the switching regulator circuit to be shut down using logic level signals thus dropping the total input supply
current to approximately 80 mA. Pulling this pin below a threshold voltage of approximately 1.3V turns the regulator
on, and pulling this pin above 1.3V (up to a maximum of 25V) shuts the regulator down. If this shutdown feature is not
needed, the ON/OFF pin can be wired to the ground pin or it can be left open, in either case the regulator will be in the
ON condition.
TYPICAL APPLICATION CIRCUIT
3/8 2007-4-9
3Pages www.DataSheet4U.com
150KHZ 500MA STEP DOWN VOLTAGE REGULATOR
TYPICAL CHARACTERISTICS (CONTINUED)
FSP3127
ORDER INFORMATION
Package:
S: SOP8L
N: PDIP8L
FSP3127XXXX
Output Voltage: Packing:
Temperature Grade:
Blank: ADJ
Blank: Tube or Bulk E: -40~125℃
33: 3.3V
A: Tape & Reel
50: 5.0V
12: 12V
MARKING INFORMATION
(1) SOP8L
(2) PDIP8L
3127-VV
YYWWXX
Logo
Part number:
3127-ADJ: ADJ
3127-33: 3.3V
3127-50: 5.0V
3127-12: 12V
Internal code
Date code:
YY: Year (01=2001)
WW: Nth week (01~52)
3127-VV
YYWWXX
Logo
Part number:
3127-ADJ: ADJ
3127-33: 3.3V
3127-50: 5.0V
3127-12: 12V
Internal code
Date code:
YY: Year (01=2001)
WW: Nth week (01~52)
6/8 2007-4-9
6 Page | |||
ページ | 合計 : 8 ページ | ||
|
PDF ダウンロード | [ FSP3127 データシート.PDF ] |
データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。 |
部品番号 | 部品説明 | メーカ |
FSP3122 | 150KHZ 3A PWM BUCK DC/DC CONVERTER | FOSLINK SEMICONDUCTOR |
FSP3123 | 150KHZ 3A PWM BUCK DC/DC CONVERTER | FOSLINK SEMICONDUCTOR |
FSP3124 | 150KHZ 3A PWM BUCK DC/DC CONVERTER | FOSLINK SEMICONDUCTOR |
FSP3125 | 150KHZ 2A PWM BUCK DC/DC CONVERTER | FOSLINK SEMICONDUCTOR |