|
|
PDF LP395Z Data sheet ( Hoja de datos )
| Número de pieza | LP395Z | |
| Descripción | Ultra Reliable Power Transistor | |
| Fabricantes | National Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LP395Z (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
April 1998
LP395
Ultra Reliable Power Transistor
General Description
The LP395 is a fast monolithic transistor with complete over-
load protection. This very high gain transistor has included
on the chip, current limiting, power limiting, and thermal
overload protection, making it difficult to destroy from almost
any type of overload. Available in an epoxy TO-92 transistor
package this device is guaranteed to deliver 100 mA.
Thermal limiting at the chip level, a feature not available in
discrete designs, provides comprehensive protection against
overload. Excessive power dissipation or inadequate heat
sinking causes the thermal limiting circuitry to turn off the de-
vice preventing excessive die temperature.
The LP395 offers a significant increase in reliability while
simplifying protection circuitry. It is especially attractive as a
small incandescent lamp or solenoid driver because of its
low drive requirements and blowout-proof design.
The LP395 is easy to use and only a few precautions need
be observed. Excessive collector to emitter voltage can de-
stroy the LP395 as with any transistor. When the device is
used as an emitter follower with a low source impedance, it
is necessary to insert a 4.7 kΩ resistor in series with the
base lead to prevent possible emitter follower oscillations.
Also since it has good high frequency response, supply
by-passing is recommended.
Areas where the LP395 differs from a standard NPN transis-
tor are in saturation voltage, leakage (quiescent) current and
in base current. Since the internal protection circuitry re-
quires voltage and current to function, the minimum voltage
across the device in the on condition (saturated) is typically
1.6 Volts, while in the off condition the quiescent (leakage)
current is typically 200 µA. Base current in this device flows
out of the base lead, rather than into the base as is the case
with conventional NPN transistors. Also the base can be
driven positive up to 36 Volts without damage, but will draw
current if driven negative more than 0.6 Volts. Additionally, if
the base lead is left open, the LP395 will turn on.
The LP395 is a low-power version of the 1-Amp LM195/
LM295/LM395 Ultra Reliable Power Transistor.
The LP395 is rated for operation over a −40˚C to +125˚C
range.
Features
n Internal thermal limiting
n Internal current and power limiting
n Guaranteed 100 mA output current
n 0.5 µA typical base current
n Directly interfaces with TTL or CMOS
n +36 Volts on base causes no damage
n 2 µs switching time
Connection Diagram
TO-92 Package
Typical Applications
Fully Protected Lamp Driver
DS005525-1
Order Number LP395Z
See NS Package Z03A
DS005525-3
© 1999 National Semiconductor Corporation DS005525
www.national.com
1 page  
Physical Dimensions inches (millimeters) unless otherwise noted
Order Number LP395Z
NS Package Z03A
LIFE SUPPORT POLICY
NATIONAL’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT
DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT AND GENERAL
COUNSEL OF NATIONAL SEMICONDUCTOR CORPORATION. As used herein:
1. Life support devices or systems are devices or
systems which, (a) are intended for surgical implant
into the body, or (b) support or sustain life, and
whose failure to perform when properly used in
accordance with instructions for use provided in the
labeling, can be reasonably expected to result in a
significant injury to the user.
2. A critical component is any component of a life
support device or system whose failure to perform
can be reasonably expected to cause the failure of
the life support device or system, or to affect its
safety or effectiveness.
National Semiconductor
Corporation
Americas
Tel: 1-800-272-9959
Fax: 1-800-737-7018
Email: [email protected]
www.national.com
National Semiconductor
Europe
Fax: +49 (0) 1 80-530 85 86
Email: [email protected]
Deutsch Tel: +49 (0) 1 80-530 85 85
English Tel: +49 (0) 1 80-532 78 32
Français Tel: +49 (0) 1 80-532 93 58
Italiano Tel: +49 (0) 1 80-534 16 80
National Semiconductor
Asia Pacific Customer
Response Group
Tel: 65-2544466
Fax: 65-2504466
Email: [email protected]
National Semiconductor
Japan Ltd.
Tel: 81-3-5639-7560
Fax: 81-3-5639-7507
National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet LP395Z.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LP395 | Ultra Reliable Power Transistor | National Semiconductor |
| LP395 | Ultra Reliable Power Transistor | National Semiconductor |
| LP395 | LP395 Ultra Reliable Power Transistor (Rev. C) |  Texas Instruments |
| LP3950 | LP3950 Color LED Driver with Audio Synchronizer (Rev. C) | Texas Instruments |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |