|
|
PDF ED-205 Data sheet ( Hoja de datos )
| Número de pieza | ED-205 | |
| Descripción | AV Surround Processor | |
| Fabricantes | Onkyo | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ED-205 (archivo pdf) en la parte inferior de esta página. Total 20 Páginas | ||
|
No Preview Available !
AV Surround Processor
ED-205
Instruction Manual
AV SURROUND PROCESSOR
STANDBY/ON
STANDBY
POWER
ON OFF
EFFECT
MODE
MASTER VOLUME
MULTICHINPUT LINE VIDEO-1/2
ED-205
Thank you for purchasing the ONKYO AV Surround
Processor.
Please read this manual thoroughly before making
connections and turning on the power.
Following the instructions in this manual will enable you
to obtain optimum performance and listening enjoyment
from your new AV Surround Processor.
Please retain this manual for future reference.
www.DataSheet4U.com
Contents
Before using
Important Safeguards ........................... 2
Precautions ........................................... 3
Features ................................................ 4
Supplied accessories ............................ 4
Before using this unit ........................... 5
Preparation
Connecting the amplifier and video
equipment ........................................... 6
Connecting equipment with 5.1-
channel audio output .......................... 7
Speaker placement and connection ...... 8
Connecting the z remote control
cables................................................ 10
Connecting the power ........................ 10
Operation
Using the remote controller ............... 11
Using the Surround modes ................. 12
Playing a source ................................. 14
A few important notes
Troubleshooting ................................. 17
Control positions and names .............. 18
Specifications ..................................... 20
1 page  
Before operating this unit
www.DataSheet4U.com
1 Installing the remote controller batteries
1 Remove the battery compartment cover by pressing the tab
and lifting up the cover.
2 Insert two AA (R6- or UM-3)-size batteries into the battery
compartment. Carefully follow the polarity diagram (positive
(+) and negative (-) symbols) inside the battery compartment.
2 3 After batteries are installed and seated correctly, replace the
compartment cover.
Notes:
• Do not mix new batteries with old batteries or different kinds
of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from
3 corrosion. If the remote controller doesn’t operate smoothly,
replace both the batteries at the same time.
• The life of the batteries supplied is about six months but this
will vary depending on usage.
Amplifier
30°
30°
5m
Remote control
sensor
ED-205
Using the remote controller
Point the remote controller toward the remote control sensor.
Notes:
• Place the unit away from strong light such as direct sunlight
or inverted fluorescent light which can prevent proper
operation of the remote controller.
• Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared
rays may cause operational interference.
• Do not put any object such as a book on the remote controller.
The buttons of the remote controller may be pressed by
mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper remote
controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
5
5 Page 
Using the remote controller
www.DataSheet4U.com
Buttons that become operative once the z
remote control cables are connected
(See page 10 for how to connect the z
cables.)
1 Amplifier operation buttons
Point the remote controller toward the amplifier’s remote
control sensor.
POWER : Turns the power on or off.
SLEEP : Sets the time (in units of10 minutes) until the
power is automatically shut off. Setting range:
90 to 10 minutes
1
POWER SLEEP LINE-1 LINE-2
LINE-1 : Selects the component connected to the
TUNER
PRESET
FM
AM
4 amplifier's LINE-1 jack.
LINE-2 : Selects the component connected to the
5DVD
amplifier's LINE-2 jack.
2 MD
2 MD recorder operation buttons
3 TAPE
Point the remote controller toward the MD recorder’s remote
control sensor.
DISC
CD
q
: Jumps to the beginning of the current track
6
(when playing) or previous track (when
stopped).
w
: Jumps to the beginning of the next track.
EFFECT MULTI CH LINE VIDEO
e : Stops playing the MD.
MODE CH SEL
DELAY TEST
TIME TONE
LEVEL
VOLUME
s : Plays the MD.
* 3 Tapedeck operation buttons
Point the remote controller toward the amplifier’s remote
CENTER
MODE MUTING
control sensor.
d
: Fast-rewinds the tape.
f
: Fast-forwards the tape.
RC-394S
REMOTE CONTROLLER
a : Plays the reverse side of the tape.
s : Plays the tape.
e : Stops playing, recording, or fast-forwarding.
4 Tuner operation buttons
Point the remote controller toward the amplifier’s remote
control sensor.
aPRESETs :
FM :
AM :
Selects preset radio stations.
Selects FM broadcasts.
Selects AM broadcasts.
5 DVD player operation buttons
Point the remote controller toward the DVD player’s remote
control sensor.
q
: Jumps to the beginning of the current chapter
or track (when playing) or previous chapter or
track (when stopped).
w
: Jumps to the beginning of the next chapter or
track.
e : Stops playing the DVD.
s : Plays the DVD.
6 CD player operation buttons
Point the remote controller toward the amplifier’s remote
control sensor.
d f : Fast-returns or fast-forwards the CD.
DISC
: Selects the disc to play (when using a CD
changer).
q w : Jumps to the beginning of the current track
(when playing), the previous track (when
stopped), or the next track.
e : Stops playing the CD.
s : Plays the CD.
* The operation buttons for the ED-205 are explained on page
12 and later. (Point the remote controller toward the ED-205’s
remote control sensor.)
11
11 Page | ||
| Páginas | Total 20 Páginas | |
| PDF Descargar | [ Datasheet ED-205.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ED-205 | AV Surround Processor | Onkyo |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |