DataSheet.jp

MOC-3021 の電気的特性と機能

MOC-3021のメーカーはMotorola Semiconductorsです、この部品の機能は「6-Pin DIP Random-Phase Optoisolators Triac Driver Output」です。


製品の詳細 ( Datasheet PDF )

部品番号 MOC-3021
部品説明 6-Pin DIP Random-Phase Optoisolators Triac Driver Output
メーカ Motorola Semiconductors
ロゴ Motorola Semiconductors ロゴ 




このページの下部にプレビューとMOC-3021ダウンロード(pdfファイル)リンクがあります。

Total 6 pages

No Preview Available !

MOC-3021 Datasheet, MOC-3021 PDF,ピン配置, 機能
MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
GlobalOptoisolator
6-Pin DIP Random-Phase
Optoisolators Triac Driver Output
(400 Volts Peak)
The MOC3020 Series consists of gallium arsenide infrared emitting diodes,
optically coupled to a silicon bilateral switch.
To order devices that are tested and marked per VDE 0884 requirements, the
suffix ”V” must be included at end of part number. VDE 0884 is a test option.
They are designed for applications requiring isolated triac triggering.
Recommended for 115/240 Vac(rms) Applications:
Solenoid/Valve Controls
Lamp Ballasts
Interfacing Microprocessors to 115 Vac Peripherals
Motor Controls
Static ac Power Switch
Solid State Relays
Incandescent Lamp Dimmers
MAXIMUM RATINGS (TA = 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
INFRARED EMITTING DIODE
Reverse Voltage
Forward Current — Continuous
Total Power Dissipation @ TA = 25°C
Negligible Power in Triac Driver
Derate above 25°C
VR 3 Volts
IF 60 mA
PD 100 mW
1.33 mW/°C
OUTPUT DRIVER
Off–State Output Terminal Voltage
Peak Repetitive Surge Current
(PW = 1 ms, 120 pps)
VDRM
ITSM
400
1
Volts
A
Total Power Dissipation @ TA = 25°C
Derate above 25°C
PD 300 mW
4 mW/°C
TOTAL DEVICE
Isolation Surge Voltage(1)
(Peak ac Voltage, 60 Hz, 1 Second Duration)
VISO
7500
Vac(pk)
Total Power Dissipation @ TA = 25°C
Derate above 25°C
PD 330 mW
4.4 mW/°C
Junction Temperature Range
Ambient Operating Temperature Range(2)
Storage Temperature Range(2)
TJ – 40 to +100
TA – 40 to +85
Tstg – 40 to +150
°C
°C
°C
Soldering Temperature (10 s)
TL 260 °C
1. Isolation surge voltage, VISO, is an internal device dielectric breakdown rating.
1. For this test, Pins 1 and 2 are common, and Pins 4, 5 and 6 are common.
2. Refer to Quality and Reliability Section in Opto Data Book for information on test conditions.
Preferred devices are Motorola recommended choices for future use and best overall value.
GlobalOptoisolator is a trademark of Motorola, Inc.
REV 1
©MMoottoorroolal,aInOc.p1t9o9e5lectronics Device Data
Order this document
by MOC3020/D
MOC3021
[IFT = 15 mA Max]
MOC3022
[IFT = 10 mA Max]
MOC3023*
[IFT = 5 mA Max]
*Motorola Preferred Device
STYLE 6 PLASTIC
61
STANDARD THRU HOLE
CASE 730A–04
SCHEMATIC
16
25
34
1. ANODE
2. CATHODE
3. NC
4. MAIN TERMINAL
5. SUBSTRATE
5. DO NOT CONNECT
6. MAIN TERMINAL
1

1 Page





MOC-3021 pdf, ピン配列
1.4
1.3
1.2
1.1
1
0.9
0.8
0.7
0.6
–40 –20 0 20 40 60 80 100
TA, AMBIENT TEMPERATURE (°C)
Figure 3. Trigger Current versus Temperature
MOC3021 MOC3022 MOC3023
25
q20 NORMALIZED TO:
PWin 100 µs
15
10
5
0
12
5 10 20
50 100
PWin, LED TRIGGER WIDTH (µs)
Figure 4. LED Current Required to Trigger
versus LED Pulse Width
12
STATIC dv/dt
10 CIRCUIT IN FIGURE 7
8
6
4
2
0
25 30
40 50 60 70 80
TA, AMBIENT TEMPERATURE (°C)
90
Figure 5. dv/dt versus Temperature
100
100
10
1
– 40 – 30 – 20 –10 0 10 20 30 40 50 60 70 80
TA, AMBIENT TEMPERATURE (°C)
Figure 6. Leakage Current, IDRM
versus Temperature
+400
Vdc
PULSE
INPUT
RTEST
MERCURY
WETTED
RELAY
APPLIED VOLTAGE
WAVEFORM
252 V
0 VOLTS
tRC
R = 10 k
CTEST
D.U.T.
X100
SCOPE
PROBE
1. The mercury wetted relay provides a high speed repeated
pulse to the D.U.T.
2. 100x scope probes are used, to allow high speeds and
voltages.
3. The worst–case condition for static dv/dt is established by
triggering the D.U.T. with a normal LED input current, then
removing the current. The variable RTEST allows the dv/dt to be
gradually increased until the D.U.T. continues to trigger in
response to the applied voltage pulse, even after the LED
current has been removed. The dv/dt is then decreased until
the D.U.T. stops triggering. tRC is measured at this point and
recorded.
Vmax = 400 V
ń + +dv dt
0.63 Vmax
tRC
252
tRC
Figure 7. Static dv/dt Test Circuit
Motorola Optoelectronics Device Data
3


3Pages


MOC-3021 電子部品, 半導体
MOC3021 MOC3022 MOC3023
–A–
64
–B–
13
F 4 PL
–T–
SEATING
PLANE
E 6 PL
N
C
L
GK
D 6 PL
0.13 (0.005) M T A M
BM
NOTES:
1. DIMENSIONING AND TOLERANCING PER ANSI
Y14.5M, 1982.
2. CONTROLLING DIMENSION: INCH.
3. DIMENSION L TO CENTER OF LEAD WHEN
FORMED PARALLEL.
INCHES
MILLIMETERS
DIM MIN MAX MIN MAX
A 0.320 0.350 8.13 8.89
B 0.240 0.260 6.10 6.60
C 0.115 0.200 2.93 5.08
D 0.016 0.020 0.41 0.50
E 0.040 0.070 1.02 1.77
F 0.010 0.014 0.25 0.36
G 0.100 BSC
2.54 BSC
J 0.008 0.012 0.21 0.30
K 0.100 0.150 2.54 3.81
L 0.400 0.425 10.16 10.80
J N 0.015 0.040 0.38 1.02
*Consult factory for leadform
option availability
CASE 730D–05
ISSUE D
Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding
the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit,
and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters can and do vary in different
applications. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does
not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in
systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of
the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such
unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless
against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death
associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part.
Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer.
How to reach us:
USA / EUROPE: Motorola Literature Distribution;
P.O. Box 20912; Phoenix, Arizona 85036. 1–800–441–2447
JAPAN: Nippon Motorola Ltd.; Tatsumi–SPD–JLDC, Toshikatsu Otsuki,
6F Seibu–Butsuryu–Center, 3–14–2 Tatsumi Koto–Ku, Tokyo 135, Japan. 03–3521–8315
MFAX: [email protected] – TOUCHTONE (602) 244–6609 HONG KONG: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park,
INTERNET: http://Design–NET.com
51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298
6
*MOC3020/D*Motorola OptoelectronicsMDOeCvi3c0e20D/Data

6 Page



ページ 合計 : 6 ページ
 
PDF
ダウンロード
[ MOC-3021 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
MOC-3021

6-Pin DIP Random-Phase Optoisolators Triac Driver Output

Motorola Semiconductors
Motorola Semiconductors


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap