|
|
Número de pieza | AMIS-710224-A6 | |
Descripción | 200dpi CIS Module | |
Fabricantes | AMI SEMICONDUCTOR | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de AMIS-710224-A6 (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
No Preview Available ! AMIS-710224-A6: 200dpi CIS Module
Data Sheet
1.0 General Description
The AMIS-710224-A6 (PI224-MC-A6) is a contact imaging sensor (CIS) module composed of 13 AMIS-720033 (PI3020) image sensor
chips. The AMIS-720033 is a 200 dots per inch (dpi) solid-state line imaging array, also a product of AMI Semiconductor. This imaging
device is fabricated using MOS imaging sensor technology for high-speed performance and high sensitivity. The AMIS-710224-A6 is
suitable for scanning A6 size (104mm) documents with 8 dots per millimeter (dpm) resolution. Applications include ticket, check and
card scanners, variety of mark readers, and other automation equipment.
2.0 Key Features
• Light source, lens and sensor are integrated into a single module
• 8dpm resolution, 104mm scanning length
• High speed page scan - up to 167µsec/line @ 5MHz pixel rate
• Wide dynamic range
• Analog output
• Ultra bright Yellow-Green light source
• Compact size ≅ 14mm x 19mm x 120mm
• Low power
• Light weight
3.0 Functional Description
The AMIS-710224-A6 imaging array consists of 13 sensors that are cascaded to provide 832 photo-detectors with their associated
multiplex switches and a digital shift register that controls its sequential readout. Mounted in the module is one-to-one graded indexed
micro lens array that focuses the scanned documents to image onto its sensing plane. The on-board amplifier processes the video
signal to produce a sequential stream of video at the video output pin of the AMIS-710224-A6 module.
wwIlwlu.mDaintaaStihoeneti4sUa.cocmomplished by means of an integrated LED light source. All components are housed in a small plastic housing which
has a cover glass which acts as the focal point for the object being scanned and protects the imaging array, micro lens assembly and
LED light source from dust. I/O to the module is the 10-pin connector located on one end of the module. The cross section of the
AMIS-710224-A6 is shown in Figure 1 and the block diagram in Figure 2.
AMI Semiconductor – May 06, M-20542-001
www.amis.com
1
1 page AMIS-710224-A6: 200dpi CIS Module
6.0 Switching Characteristics (25°C)
Data Sheet
Figure 3: Clock and Start Pulse Timing Diagram
The switching characteristics for the I/O clocks are shown in Figure 3. Its corresponding definition for the timing symbols are given in
Table 6.
www.DataSheet4U.com
Table 6: Symbol Definition for the Above Timing Diagram
Item
Symbol
Clock cycle time
to
Clock pulse width
tw
Clock duty cycle
Prohibit crossing time of Start Pulse
tprh
Data setup time
tds
Data hold time
tdh
Signal delay time
tdl
Signal settling time
tsh
Min.
0.2
50
25
15
20
20
50
120
Typ.
Max.
4.0
75
Units
µs
ns
%
ns
ns
ns
ns
ns
AMI Semiconductor – May 06, M-20542-001
www.amis.com
5
5 Page |
Páginas | Total 7 Páginas | |
PDF Descargar | [ Datasheet AMIS-710224-A6.PDF ] |
Número de pieza | Descripción | Fabricantes |
AMIS-710224-A6 | 200dpi CIS Module | AMI SEMICONDUCTOR |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |