|
|
UPC1251のメーカーはNECです、この部品の機能は「SINGLE POWER SUPPLY DUAL OPERATIONAL AMPLIFIERS」です。 |
部品番号 | UPC1251 |
| |
部品説明 | SINGLE POWER SUPPLY DUAL OPERATIONAL AMPLIFIERS | ||
メーカ | NEC | ||
ロゴ | |||
このページの下部にプレビューとUPC1251ダウンロード(pdfファイル)リンクがあります。 Total 12 pages
DATA SHEET
BIPOLAR ANALOG INTEGRATED CIRCUIT
μ PC1251GR-9LG, μ PC1251MP-KAA, μ PC358GR-9LG
www.datasheet4u.com SINGLE POWER SUPPLY DUAL OPERATIONAL AMPLIFIERS
<R> DESCRIPTION
The μ PC1251GR-9LG, μ PC1251MP-KAA, μ PC358GR-9LG are dual operational amplifiers which are designed to
operate for a single power supply. It includes features of low-voltage operation, a common-mode input voltage that
range from V− (GND) level, an output from a V− (GND) level that is determined by the output stage of class C push-
pull circuit and a 50 μA(TYP.) constant current, and a low current consumption.
In addition, this can operate at both positive and negative power supply and it can be extensively used in various
amplifier circuits.
The μ PC1251GR-9LG, μ PC1251MP-KAA which expands temperature type is suited for wide operating ambient
temperature use, and μ PC358GR-9LG is used for general purposes.
A DC parameter selection that is compatible to operational amplifiers is also available.
μ PC451GR-9LG, μ PC324GR-9LG which are quad types with the same circuit configuration are also available as
series of operational amplifiers.
<R> FEATURES
• Input Offset Voltage
±2 mV (TYP.)
• Internal frequency compensation
• Input Offset Current
±5 nA (TYP.)
• Output short-circuit protection
• Large Signal Voltage Gain 100000 (TYP.)
• Small Package
The mounting area is reduced to 40% or 66% compared to the conventional 8-pin plastic SOP as shown in the
following diagram.
Package
Subject part number
Outline comparison
Standard SOP
μ PC1251G2,
μ PC358G2
TSSOP
μ PC1251GR-9LG,
μ PC358GR-9LG
TSSOP (2.8 x 2.9)
μ PC1251MP-KAA
(Mounting area ratio)
6.5 4.4
6.4
5.2
(100%)
3.15
(60%)
2.8 4.0
2.9
(34%)
The information in this document is subject to change without notice. Before using this document, please
confirm that this is the latest version.
Not all products and/or types are available in every country. Please check with an NEC Electronics
sales representative for availability and additional information.
Document No. G17929EJ3V0DS00 (3rd edition)
Date Published December 2007 NS
2006, 2007
Printed in Japan
The mark <R> shows major revised points.
The revised points can be easily searched by copying an "<R>" in the PDF file and specifying it in the "Find what:" field.
1 Page μ PC1251GR-9LG, μ PC1251MP-KAA, μ PC358GR-9LG
EQUIVALENT CIRCUIT (1/2 Circuit)
<R> PIN CONFIGURATION (Marking side)
+ Q2
www.datasheetI4I u.coQm1
−
IN
Q8
6 μA 6 μA
Q3
Q4
CC
100 μA
V+
Q5
Q6
Q7
RSC
OUT
Q11 Q13
Q10
Q12
Q9 50 μA
V−
OUT1 1
II1 2
IN1 3
V− 4
1
−+
2
+−
8 V+
7 OUT2
6 II2
5 IN2
<R> ABSOLUTE MAXIMUM RATINGS (TA = 25°C)
Parameter
Voltage between V+ and V− Note1
Symbol
V+ − V−
μ PC1251GR-9LG,
μ PC1251GR(5)-9LG
μ PC1251MP-KAA,
μ PC1251MP(5)-KAA
−0.3 to +32
μ PC358GR-9LG,
μ PC358GR(5)-9LG
Unit
V
Differential Input Voltage
Input Voltage Note2
Output applied Voltage Note3
Total Power Dissipation Note4
Output Short Circuit Duration Note5
VID
VI
VO
PT
tS
±32
V− − 0.3 to V− + 32
V− − 0.3 to V+ + 0.3
440
Indefinite
V
V
V
mW
s
Operating Ambient Temperature
TA
−40 to +125
−40 to +85
°C
Storage Temperature
Tstg
−55 to +150
−55 to +125
°C
Note1. Note that reverse connections of the power supply may damage ICs.
2. The input voltage is allowed to input without damage or destruction independent of the magnitude of V+. Either
input signal is not allowed to go negative by more than 0.3 V. In addition, the input voltage that operates
normally as an operational amplifier is within the Common Mode Input Voltage range of an electrical
characteristic.
3. A range where input voltage can be applied to an output pin externally with no deterioration or damage to the
feature (characteristic). The input voltage can be applied regardless of the electric supply voltage. This
specification which includes the transition state such as electric power ON/OFF must be kept.
4. This is the value of when the glass epoxy substrate (size: 100 mm x 100 mm, thickness: 1 mm, 15% of the
substrate area where only one side is copper foiled is filling wired) is mounted.
Note that restrictions will be made to the following conditions for each product, and the derating ratio
depending on the operating ambient temperature.
μ PC1251GR-9LG: Derate at −5.5 mW/°C when TA > 69°C.
(Junction − ambient thermal resistance Rth(J-A) = 183°C/W)
μ PC1251MP-KAA: Derate at −4.8 mW/°C when TA > 58°C.
(Junction − ambient thermal resistance Rth(J-A) = 208°C/W)
μ PC358GR-9LG: Derate at −5.5 mW/°C when TA > 44°C.
(Junction − ambient thermal resistance Rth(J-A) = 183°C/W)
5. Short circuits from the output to V+ can cause destruction. Pay careful attention to the total power dissipation
not to exceed the absolute maximum ratings, Note 4.
Data Sheet G17929EJ3V0DS
3
3Pages μ PC1251GR-9LG, μ PC1251MP-KAA, μ PC358GR-9LG
70
60
www.datasheet4u.com
50
IO SHORT vs. TA
− IO SHORT
+
AV vs. V+
160
RL = 20 kΩ
120
2 kΩ
80
40 40
30
-20
0
20 40 60
80
TA - Operating Ambient Temperature - °C
0
0 10 20 30 40
V+ - Power Supply Voltage - V (V− = GND)
AV, φ vs. f
140
120 V± = ±15 V
100
±7.5 V
80
±2.5 V
60
AV
40
20
0
0.1
1
10 100 1 k
f - Frequency - Hz
±15 V
φ
±7.5 V
±2.5 V
10 k 100 k 1 M
VO vs. f
20
100 kΩ
1 kΩ +15 V
15 − VO
+7 V +
VIN 2 kΩ
10
5
0
1k
3 5 10 k 30 50 100 k 3005001 M
f - Frequency - Hz
120
100
80
60
40
20
0
100
CMR vs. f
1 k 10 k 100 k
f - Frequency - Hz
1M
6 Data Sheet G17929EJ3V0DS
6 Page | |||
ページ | 合計 : 12 ページ | ||
|
PDF ダウンロード | [ UPC1251 データシート.PDF ] |
データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。 |
部品番号 | 部品説明 | メーカ |
UPC1251 | Low Power Dual Operational Amplifier | ETC |
UPC1251 | Bipolar Analog Integrated Circuit | Renesas |
UPC1251 | SINGLE POWER SUPPLY DUAL OPERATIONAL AMPLIFIERS | NEC |
UPC1251C | Low Power Dual Operational Amplifier | ETC |