DataSheet.es    


PDF APE8953 Data sheet ( Hoja de datos )

Número de pieza APE8953
Descripción 3A ULTRA LOW DROPOUT LINEAR REGULATOR
Fabricantes Advanced Power Electronics 
Logotipo Advanced Power Electronics Logotipo



Hay una vista previa y un enlace de descarga de APE8953 (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! APE8953 Hoja de datos, Descripción, Manual

Advanced Power
Electronics Corp.
APE8953
3A ULTRA LOW DROPOUT LINEAR REGULATOR
FEATURES
Ultra Low Dropout Voltage 250mV at 3A Output Current
Low ESR Output Capacitor (MLCC) Applicable
0.8V Reference Voltage
Fast Transient Response
Current Limit and Thermal Shutdown Protection
Adjustable Output Voltage by External Resistors
Power-on-Reset Monitoring on Both VCNTL and
VIN Pins
Under Voltage Protection
Power OK Output with a Delay Time
Internal Soft-Start
SOP-8 with Exposed Pad Package
RoHS Compliant & Halogen Free
DESCRIPTION
The APE8953 is a 3A ultra low dropout linear regulator.
The product is specifically designed to provide well supply
voltage for front side bus termination on motherboard and
NB applications. The IC needs two supply voltages, a
voltage for the circuitry and a main supply voltage for power
conversion to reduce power dissipation and provide
extremely low dropout. The APE8953 integrates many
functions. A Power-on-Reset(POR) circuit monitors both
supply voltage to prevent wrong operations. A thermal
shutdown and current limit functions protect the device
against thermal and current over-load. A POK indicates the
output status with time delay which is set internally. It can
control other converter for power sequence. The APE8953
can be enabled by other power system. Pulling and holding
the EN pin below 0.4V shuts off the output.
The APE8953 is available in ESOP-8 package which
features small size as SO-8 and exposed pad to reduce the
junction-to-case resistance, being applicable in 2~3W
applications.
TYPICAL APPLICATION
VCNTL=5V
C1
1uF
R3
1K
6
VCNTL
5
VIN
7
POK
8
EN
4
VOUT
APE8953
3
VOUT
1
GND
2
FB
VIN=1.5V
VCNTL=5V
C2
100uF
C3
0.1uF
R1
1K C6
12~48nF
R2
2K
V O UT=1 .2 V /3 A
C4
220uF
C5
0.1uF
C1
1uF
R3
1K
6
VCNTL
5
V IN
7
POK
8
EN
4
VOUT
APE8953
3
VOUT
1
GND
2
FB
VOUT=VFB x (1+R1/R2)
VFB=0.8V
C2
22uF
V IN= 1 .5 V
R1
39K
R2
78K
V O UT=1 .2 V /3 A
C4
56pF
C3
22uF
Figure 1. Output Capacitor with ESR > 20mΩ
Figure 2. Output Capacitor is MLCC
PACKAGE ORDERING INFORMATION
APE8953
Package type
MP : ESOP-8
Data and specifications subject to change without notice
1
20080828A

1 page




APE8953 pdf
Advanced Power
Electronics Corp.
FUNCTION DESCRIPTION(Cont.)
APE8953
Output Voltage Regulation
An error amplifier working with a temperature compensated 0.8V reference and
an output NMOS regulates output to the preset voltage. The error amplifier designed with
high bandwidth and DC gain provides very fast transient response and less load
regulation. It compares the reference with the feedback voltage and amplifies the
difference to drive the output NMOS which provides load current from VIN to VOUT.
www.DataSheet4U.comUnder Voltage Protection (UVP)
The APE8953 monitors the voltage on FB pin after soft-start process is finished.
Therefore the UVP is disabling during soft-start. When the voltage on FB pin falls
below the under-voltage threshold, the UVP circuit shuts off the output immediately.
After a while, the APE8953 starts a new soft-start to regulate output.
Thermal Shutdown
A thermal shutdown circuit limits the junction temperature of APE8953. When the
junction temperature exceeds +150°C, a thermal sensor turns off the output NMOS,
allowing the device to cool down. The regulator regulates the output again through
initiation of a new soft-start cycle after the junction temperature cools by 50°C, resulting
in a pulsed output during continuous thermal overload conditions.
5

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet APE8953.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
APE89511.5A ULTRA LOW DROPOUT LINEAR REGULATORAdvanced Power Electronics
Advanced Power Electronics
APE89533A ULTRA LOW DROPOUT LINEAR REGULATORAdvanced Power Electronics
Advanced Power Electronics
APE89555A ULTRA LOW DROPOUT LINEAR REGULATORAdvanced Power Electronics
Advanced Power Electronics
APE89577A ULTRA LOW DROPOUT LINEAR REGULATORAdvanced Power Electronics
Advanced Power Electronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar