DataSheet.jp

1N5360BE の電気的特性と機能

1N5360BEのメーカーはMCCです、この部品の機能は「(1N5348BE - 1N5388BE) 5 Watt Zener Diode」です。


製品の詳細 ( Datasheet PDF )

部品番号 1N5360BE
部品説明 (1N5348BE - 1N5388BE) 5 Watt Zener Diode
メーカ MCC
ロゴ MCC ロゴ 




このページの下部にプレビューと1N5360BEダウンロード(pdfファイル)リンクがあります。

Total 6 pages

No Preview Available !

1N5360BE Datasheet, 1N5360BE PDF,ピン配置, 機能
www.DataSheet4U.com
MCC
TM
Micro Commercial Components
  omponents
20736 Marilla Street Chatsworth

  !"#
$ %    !"#
Features
Built Strain Relief
Case Material: Molded Plastic. UL Flammability
Classification Rating 94V-0
For Available Tolerances—See Note 1
Marking : 1N5348~1N5388 part number and Cathode Band
Maximum Ratings:
Operating Temperature: -55°C to +150°C
Storage Temperature: -55°C to +150°C
5 Watt DC Power Dissipation
Maximum Forward Voltage @ 1A: 1.2 Volts
Power Derating: 40 mW/Above 75
Mechanical Characteristics
Case: JEDEC DO-201AE.
Terminals: Solder plated , solderable per MIL-STD-750,
Method 2026.
Standard Packaging: 52mm tape
Weight: 0.04 ounces , 1.1 gram (approx)
1N5348BE
THRU
1N5388BE
5 Watt
Zener Diode
11 to 200 Volts
DO-201AE
D
A
Cathode
Mark
B
D
C
DIM
A
B
C
D
DIMENSIONS
INCHES
MM
MIN MAX MIN MAX
0.285 0.375 7.20
9.50
0.190 0.210 4.80
5.30
0.037 0.043 0.94
1.07
1.000
----- 25.40
-----
NOTE
Revision: 6
www.mccsemi.com
1 of 6
2006/05/28

1 Page





1N5360BE pdf, ピン配列
1N5348BE THRU 1N5388BE
ELECTRICAL CHARACTERISTICS
MCC
TM
Micro Commercial Components
3. SURGE CURRENT (Ir) - Surge current is specified as the maximum allowable peak, non-recurrent square-wave
current with a pulse width, PW, of 8.3 ms. The data given in Figure 5 may be used to find the maximum surge
current for a quare wave of any pulse width between 1 ms and 1000ms by plotting the applicable points on
logarithmic paper. Examples of this, using the 6.8v and 200V zeners, are shown in Figure 6. Mounting
contact located as specified in Note 3. (TA=25 ).
4. VOLTAGE REGULATION (Vz) - Test conditions for voltage regulation are as follows: Vz measurements are made
at 10% and then at 50% of the Iz max value listed in the electrical characteristics table. The test currents are the
same for the 5% and 10% tolerance devices. The test current time druation for each Vz measurement is 40 10 ms.
(TA=25 ). Mounting contact located as specified in Note2.
5. MAXIMUM REGULATOR CURRENT (IZM) - The maximum current shown is based on the maximum voltage of a
5% type unit. Therefore, it applies only to the B-suffix device. The actual IZM for any device may not exceed the
value of 5 watts divided by the actual Vz of the device. TL=75 at maximum from the device body.
APPLICATION NOTE:
Since the actual voltage available from a given zener
diode is temperature dependent, it is necessary to
determine junction temperature under any set of
operating conditions in order to calculate its value. The
following procedure is recommended:
Lead Temperature, TL, should be determined from:
TL =th LAPD + TA
th LA is the lead-to-ambient thermal resistance ( /W)
and PD is the power dissipation.
Junction Temperature, TJ , may be found from:
TJ = TL + TJL
TJL is the increase in junction temperature above the
lead temperature and may be found from Figure 3 for a
train of power pulses or from Figure 4 for dc power.
T JL = JLPD
For worst-case design, using expected limits of Iz, limits
of PD and the extremes of TJ(TJ) may be estimated.
Changes in voltage, Vz, can then be found from:
, the zener voltage temperature coefficient, is fount
from Figures 2.
Under high power-pulse operation, the zener voltage will
vary with time and may also be affected significantly be
the zener resistance. For best regulation, keep current
excursions as low as possible.
Data of Figure 3 should not be used to compute surge
capability. Surge limitations are given in Figure 5. They
are lower than would be expected by considering only
junction temperature, as current crowding effects cause
temperatures to be extremely high in small spots resulting
in device degradation should the limits of Figure. 5 be
exceeded.
Revision: 6
www.mccsemi.com
3 of 6
2006/05/28


3Pages


1N5360BE 電子部品, 半導体
MCC
TM
Micro Commercial Components
***IMPORTANT NOTICE***
Micro Commercial Components Corp . reserves the right to make changes without further notice to any
product herein to make corrections, modifications , enhancements , improvements , or other changes .
Micro Commercial Components Corp . does not assume any liability arising out of the application or
use of any product described herein; neither does it convey any license under its patent rights ,nor
the rights of others . The user of products in such applications shall assume all risks of such use
and will agree to hold Micro Commercial Components Corp . and all the companies whose
products are represented on our website, harmless against all damages.
***APPLICATIONS DISCLAIMER***
Products offer by Micro Commercial Components Corp . are not intended for use in Medical,
Aerospace or Military Applications.
Revision: 6
www.mccsemi.com
6 of 6
2006/05/28

6 Page



ページ 合計 : 6 ページ
 
PDF
ダウンロード
[ 1N5360BE データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
1N5360B

5 WATT ZENER REGULATOR DIODES 3.3-200 VOLTS

Motorola  Inc
Motorola Inc
1N5360B

SILICON 5 WATT ZENER DIODES

Microsemi Corporation
Microsemi Corporation
1N5360B

5W ZENER DIODE

Diodes Incorporated
Diodes Incorporated
1N5360B

5 Watt Surmetic 40 Silicon Zener Diodes

Boca Semiconductor Corporation
Boca Semiconductor Corporation


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap