|
|
PDF AV-56P585 Data sheet ( Hoja de datos )
| Número de pieza | AV-56P585 | |
| Descripción | (AV-48P575 / AV-56P5x5) Projection TV User Guide | |
| Fabricantes | JVC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de AV-56P585 (archivo pdf) en la parte inferior de esta página. Total 70 Páginas | ||
|
No Preview Available !
Projection Television Users Guide
For Models:
AV-56P585
AV-56P575
AV-48P575
www.DataSheet4U.com
Illustration of AV-56P575 and RM-C1257G
Important Note:
In the spaces below, enter the model and serial number of your television (located
at the rear of the television cabinet). Staple your sales receipt or invoice to the
inside cover of this guide. Keep this user’s guide in a convenient place for future
reference. Keep the carton and original packaging for future use.
Model Number:
Serial Number:
LCT1609-001A-A
0304TNH-II-IM
1 page  
PORTABLE CART WARNING
(Symbol provided by RETAC)
13 For added protection of the TV set during a lightning storm or when the TV set is to be left
unattended for an extended period of time, unplug it from the wall outlet and disconnect the
antenna. This will prevent damage to product due to lightning storms or power line surges.
14 A TV set and cart combination should be moved with care. Quick stops, excessive force,
and uneven surfaces may cause the TV set and cart combination to overturn.
Service
15 Unplug this TV set from the wall outlet and refer servicing to qualified service personnel
under the following conditions:
A. When the power cord or plug is damaged or frayed.
B. If liquid has been spilled into the TV set.
C. If the TV set has been exposed to rain or water.
D. If the TV set does not operate normally by following the operating instructions. Adjust
only those controls that are covered in the operating instructions as improper adjustment
of other controls may result in damage and will often require extensive work by a
qualified technician to restore the TV set to normal operation.
E. If the TV set has been dropped or damaged in any way.
F.www.DataSheet4U.comWhen the TV set exhibits a distinct change in performance — this indicates a need for
service.
16 Do not attempt to service this TV set yourself as opening or removing covers may
expose you to dangerous voltage or other hazards. Refer all servicing to qualified service
personnel.
17 When replacement parts are required, have the service technician verify in writing that the
replacement parts he uses have the same safety characteristics as the original parts. Use
of manufacturer’s specified replacement parts can prevent fire, shock, or other hazards.
18 Upon completion of any service or repairs to this TV set, please ask the service technician
to perform the safety check described in the manufacturer’s service literature.
19 When a TV set reaches the end of its useful life, improper disposal could result in a picture
tube implosion. Ask a qualified service technician to dispose of the TV set.
20 Note to CATV system installer.
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of
the NEC that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building, as close to the
point of cable entry as practical.
5
5 Page 
Quick Setup
Getting Started
Getting Started
These quick setup pages will provide you, in three easy steps, with the basic information you
need to begin using your new television right away.
If you have questions, or for more detailed information on any of these steps, please consult
other sections of this manual.
Step 1 – The Remote Control
Before you can operate your remote control, you first need to install the batteries (included).
�� ���� ��� ���
�����
Lift and pull the latch on the back of the remote
control to open. Insert two batteries (included)
carefully noting the “+” and “–” markings, placing
the “–” end in the unit first. Snap the cover back
������������
���� �����
����
into place.
������ ���� ������ �����
When you change the batteries, try to
complete the task within three minutes. If you
take longer than three minutes, the remote
control codes for your VCR, DVD, and/or
cable box/satellite receiver may have to be
������� � � �
�����������
�
�
�
reset. See pages 24 - 27.
�����
���
www.DataSheet4U.com
Key Feature Buttons
The four key feature buttons at the center of the remote can be
used for basic operation of the television. The top and bottom
buttons will scan forward and back through the available
channels. To move rapidly through the channels using
JVC’s Hyperscan feature, press and hold CH+ or CH–. The
channels will zip by at a rate of five channels per second. The
right and left buttons will turn the volume up or down. These
buttons are also marked with four arrows and are used with
JVC’s onscreen menu system. To use the onscreen menus,
press the MENU button.
������������ ����
� �������
����������� ������
�����
������
����
��
���
�
���
�
����
����
����
����������� �������
���������� ����� ������
Basic Operation
���
����
�� ���������� �������
��
����������
Turn the television on and off by pressing the POWER button at the top right corner
of the remote. If this is the first time you are turning on the TV, the i�n�te���ra����c��t�i��v��e������ �����������
plug-in menu appears.
���� ����� �� ������ �� ��� ���
• Make sure the TV/CATV switch is set to TV. Move the switch to CATV only��if�������
you need to operate a cable box.
�������� ���� ������ �����
������������
•
Slide the VCR/DVD selector switch to VCR to control a VCR. Slide to
DVD to control a DVD player. Please see pages 24 to 27
programming your remote control to operate a cable box,
fVoCr iRns�ot��rru�Dc��tVi�oDnsploany�e��r.
���� ���
�
���
�
�������
������ ���� �
�����������
�����
11� � �������������
���� �����
�
�������
�
� � ������� ���� ������ ���
�����������
11 Page | ||
| Páginas | Total 70 Páginas | |
| PDF Descargar | [ Datasheet AV-56P585.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| AV-56P585 | (AV-48P575 / AV-56P5x5) Projection TV User Guide | JVC |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |