|
|
MCR01のメーカーはROHM Semiconductorです、この部品の機能は「Thick film rectangular」です。 |
部品番号 | MCR01 |
| |
部品説明 | Thick film rectangular | ||
メーカ | ROHM Semiconductor | ||
ロゴ | |||
このページの下部にプレビューとMCR01ダウンロード(pdfファイル)リンクがあります。 Total 6 pages
Resistors
Thick film rectangular
MCR01 (1005 size : 1 / 16W)
MCR01
zFeatures
1) Extremely small light
Area ratio is 60% smaller than that of chip 1608, while weight ratio has been cut 75%.
2) Highly reliable chip resistor
Ruthenium oxide dielectric offers superior resistance to the elements.
3) Electrodes not corroded by soldering
Thick film makes the electrodes very strong.
4) Flat surface further facilitates mounting
Mounting can also be automated.
5) ROHM resistors have approved ISO–9001 certification.
Design and specifications are subject to change without notice. Carefully check the specification sheet supplied with the
product before using or ordering it.
zRatings
Item
Rated power
Conditions
Power must be derated according to the power derating curve in
Figure 1 when ambient temperature exceeds 70°C.
100
Specifications
0.063W (1 / 16W)
at 70°C
80
60
40
20
0
−55
0 70 100 125
AMBIENT TEMPERATURE (°C)
Fig.1
155
Rated voltage
The voltage rating is calculated by the following equation.
If the value obtained exceeds the limiting element voltage,
the voltage rating is equal to the maximum operating voltage.
E= P×R
E: Rated voltage (V)
P: Rated power (W)
R: Nominal resistance (Ω)
Nominal resistance
See Table 1.
Operating temperature
Limiting element voltage 50V
−55°C to +155°C
Rev.A
1/5
1 Page Resistors
zExternal dimensions (Unit : mm)
0.2±0.1
1
0.25
+0.05
−0.1
1.0±0.05
5
MCR01
2
3 No.
Material
1 Thick dielectric glaze of oxide metal (only silver used for jumper)
4 2 Thick film of silver for electrode
3 Nickel-coated electrode
4 External electrode coated with Sn
5 Alumina substrate
6 Overcoating
6
zPackaging
Reel
A BD
C
A
φ180
0
−1.5
B
φ60
+1
0
C
9
+1.0
0
Taping
P0
P2
A0
B0
φD0
E
FW
Label
EIAJ ET-7200B compliant
(Unit : mm)
D
φ13±0.2
P1
Heat crimp cover/Tape
Thick paper (Underside paper tape) Chip resistor Square punchout hole
mount
T2
(Unit : mm)
W F E A0 B0
8.0±0.3 3.5±0.05 1.75±0.1 0.7±0.1 1.2±0.1
D0
φ1.5
+0.1
0
P0
4.0±0.1
P1 P2 T2
2.0±0.05 2.0±0.05 Max. 1.1
Rev.A
3/5
3Pages Appendix
Notes
No technical content pages of this document may be reproduced in any form or transmitted by any
means without prior permission of ROHM CO.,LTD.
The contents described herein are subject to change without notice. The specifications for the
product described in this document are for reference only. Upon actual use, therefore, please request
that specifications to be separately delivered.
Application circuit diagrams and circuit constants contained herein are shown as examples of standard
use and operation. Please pay careful attention to the peripheral conditions when designing circuits
and deciding upon circuit constants in the set.
Any data, including, but not limited to application circuit diagrams information, described herein
are intended only as illustrations of such devices and not as the specifications for such devices. ROHM
CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any
third party's intellectual property rights or other proprietary rights, and further, assumes no liability of
whatsoever nature in the event of any such infringement, or arising from or connected with or related
to the use of such devices.
Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or
otherwise dispose of the same, no express or implied right or license to practice or commercially
exploit any intellectual property rights or other proprietary rights owned or controlled by
ROHM CO., LTD. is granted to any such buyer.
Products listed in this document are no antiradiation design.
The products listed in this document are designed to be used with ordinary electronic equipment or devices
(such as audio visual equipment, office-automation equipment, communications devices, electrical
appliances and electronic toys).
Should you intend to use these products with equipment or devices which require an extremely high level of
reliability and the malfunction of with would directly endanger human life (such as medical instruments,
transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other
safety devices), please be sure to consult with our sales representative in advance.
About Export Control Order in Japan
Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control
Order in Japan.
In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause)
on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction.
Appendix1-Rev1.1
6 Page | |||
ページ | 合計 : 6 ページ | ||
|
PDF ダウンロード | [ MCR01 データシート.PDF ] |
データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。 |
部品番号 | 部品説明 | メーカ |
MCR004 | (MCR Series) Thick Film Chip Resistors | ROHM Semiconductor |
MCR006 | Thick film rectangular | ROHM Semiconductor |
MCR01 | Thick film rectangular | ROHM Semiconductor |
MCR01 | (MCR Series) Thick Film Chip Resistors | ROHM Semiconductor |