DataSheet.es    


PDF ISL59913 Data sheet ( Hoja de datos )

Número de pieza ISL59913
Descripción (ISL59910 / ISL59913) Triple Differential Receiver/Equalizer
Fabricantes Intersil Corporation 
Logotipo Intersil Corporation Logotipo



Hay una vista previa y un enlace de descarga de ISL59913 (archivo pdf) en la parte inferior de esta página.


Total 12 Páginas

No Preview Available ! ISL59913 Hoja de datos, Descripción, Manual

®
Data Sheet
ISL59910, ISL59913
December 15, 2006
FN6406.0
Triple Differential Receiver/Equalizer
The ISL59910 and ISL59913 are triple channel differential
receivers and equalizers. They each contain three high speed
differential receivers with five programmable poles. The
outputs of these pole blocks are then summed into an output
buffer. The equalization length is set with the voltage on a
single pin. The ISL59910 and ISL59913 output can also be
put into a high impedance state, enabling multiple devices to
be connected in parallel and used in multiplexing application.
The gain can be adjusted up or down on each channel by 6dB
using its VGAIN control signal. In addition, a further 6dB of gain
can be switched in to provide a matched drive into a cable.
The ISL59910 and ISL59913 have a bandwidth of 150MHz
and consume just 108mA on ±5V supply. A single input
voltage is used to set the compensation levels for the
required length of cable.
The ISL59910 is a special version of the ISL59913 that
decodes syncs encoded onto the common modes of three
pairs of CAT-5 cable by the EL4543. (Refer to the EL4543
datasheet for details.)
The ISL59910 and ISL59913 are available in a 28 Ld QFN
package and are specified for operation over the full -40°C to
+85°C temperature range.
Pinouts
ISL59910
(28 LD QFN)
TOP VIEW
Features
• 150MHz -3dB bandwidth
• CAT-5 compensation
- 100MHz @ 600 ft
- 135MHz @ 300 ft
• 108mA supply current
• Differential input range 3.2V
• Common mode input range -4V to +3.5V
• ±5V supply
• Output to within 1.5V of supplies
• Available in 28 Ld QFN package
• Pb-free plus anneal available (RoHS compliant)
Applications
• Twisted-pair receiving/equalizer
• KVM (Keyboard/Video/Mouse)
• VGA over twisted-pair
• Security video
ISL59913
(28 LD QFN)
TOP VIEW
VSMO_B 1
VOUT_B 2
VSPO_B 3
VSPO_G 4
VOUT_G 5
VSMO_G 6
VSMO_R 7
VOUT_R 8
THERMAL
PAD
22 VSP
21 VINM_B
20 VINP_B
19 VINM_G
18 VINP_G
17 VINM_R
16 VINP_R
15 VSM
VSMO_B 1
VOUT_B 2
VSPO_B 3
VSPO_G 4
VOUT_G 5
VSMO_G 6
VSMO_R 7
VOUT_R 8
THERMAL
PAD
22 VSP
21 VINM_B
20 VINP_B
19 VINM_G
18 VINP_G
17 VINM_R
16 VINP_R
15 VSM
EXPOSED DIEPLATE SHOULD BE CONNECTED TO -5V
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2006. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.

1 page




ISL59913 pdf
ISL59910, ISL59913
Pin Descriptions (Continued)
PIN
NUMBER PIN NAME
ISL59910
PIN FUNCTION
26 X2 Logic signal for x1/x2 output gain setting
27 ENABLE Chip enable logic signal
28 0V 0V reference for output voltage
Thermal Pad
Must be connected to -5V
PIN NAME
X2
ENABLE
0V
ISL59913
PIN FUNCTION
Logic signal for x1/x2 output gain setting
Chip enable logic signal
0V reference for output voltage
Typical Performance Curves
5
X2=LOW
VGAIN=0V
3 VCTRL=0V
RLOAD=150
1
-1
-3
-5
1M
10M
100M 200M
FREQUENCY (Hz)
FIGURE 1. FREQUENCY RESPONSE OF ALL CHANNELS
X2=HIGH
VGAIN=0.35V
VCTRL=0V
RLOAD=150Ω
FIGURE 2. GAIN vs FREQUENCY ALL CHANNELS
X2=LOW
VS=±5V
RL=150Ω
VGAIN=0V
VCTRL=0.1V STEPS
Source=-20dBm
VCTRL=1V
VCTRL=0V
FIGURE 3. GAIN vs FREQUENCY FOR VARIOUS VCTRL
X2=LOW
VS=±5V
RL=150Ω
Source=-20dBm
VCTRL=0V
VGAIN=0V
VCTRL=0.25V
VGAIN=0.25V
VCTRL=0V
VGAIN=0.25V
FIGURE 4. GAIN vs FREQUENCY FOR VARIOUS VCTRL AND
VGAIN
5 FN6406.0
December 15, 2006

5 Page





ISL59913 arduino
ISL59910, ISL59913
Where
θJA=
(---T----j---–----T-----a----)
PD
=
50.4 C W
(EQ. 3)
Tj is the maximum junction temperature (+150°C)
Ta is the maximum ambient temperature (+85°C)
For a QFN 28 package in a properly layout PCB heatsinking
copper area, +37°C/W θJA thermal resistance can be
achieved. To disperse the heat, the bottom heatspreader
must be soldered to the PCB. Heat flows through the
heatspreader to the circuit board copper then spreads and
converts to air. Thus the PCB copper plane becomes the
heatsink. This has proven to be a very effective technique. A
separate application note details the 28 Ld QFN. PCB
design considerations are available.
All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.
Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without
notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
11 FN6406.0
December 15, 2006

11 Page







PáginasTotal 12 Páginas
PDF Descargar[ Datasheet ISL59913.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
ISL59910(ISL59910 / ISL59913) Triple Differential Receiver/EqualizerIntersil Corporation
Intersil Corporation
ISL59911250MHz Triple Differential Receiver/ EqualizerIntersil
Intersil
ISL59913(ISL59910 / ISL59913) Triple Differential Receiver/EqualizerIntersil Corporation
Intersil Corporation

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar