DataSheet.es    


PDF SY88289AL Data sheet ( Hoja de datos )

Número de pieza SY88289AL
Descripción CML Low-Power Limiting Post Amplifier
Fabricantes Micrel Semiconductor 
Logotipo Micrel Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de SY88289AL (archivo pdf) en la parte inferior de esta página.


Total 9 Páginas

No Preview Available ! SY88289AL Hoja de datos, Descripción, Manual

SY88289AL
3.3V, 3.2Gbps CML Low-Power Limiting
Post Amplifier with TTL Loss-of-Signal
General Description
Features
The SY88289AL low-power limiting post amplifier is
designed for use in fiber-optic receivers. The device
connects to typical transimpedance amplifiers (TIAs).
The linear signal output from TIAs can contain
significant amounts of noise and may vary in amplitude
over time. The SY88289AL quantizes these signals and
outputs CML-level waveforms.
Single 3.3V power supply
125Mbps to 3.2Gbps operation
Low-noise CML data outputs
Chatter-free open-collector TTL Loss-of-signal (LOS)
output with internal 4.75kpull-up resistor
TTL /EN input
The SY88289AL operates from a single +3.3V power
supply, over temperatures ranging from –40oC to +85oC.
With its wide bandwidth and high gain, signals with data
rates up to 3.2Gbps, and as small as 10mVP-P, can be
amplified to drive devices with CML inputs or AC-
Internal 50input termination
Programmable LOS level set (LOSLVL)
Ideal for multi-rate applications
Available in a tiny 3mmx3mm 16-pin MLF® package
coupled CML/PECL inputs.
Applications
The SY88289AL generates a loss-of-signal (LOS) open-
collector TTL output. A programmable loss-of-signal
level-set pin (LOSLVL) sets the sensitivity of the input
amplitude detection. LOS asserts high if the input
APON, BPON, EPON, GEPON, and GPON
Gigabit Ethernet
Fibre Channel
amplitude falls below the threshold set by LOSLVL and SONET/SDH:OC-3/12/24/48 – STM 1/4/8/16
de-asserts low otherwise. The enable bar input (/wEwNw.D)ataSheet4U.comHigh-gain line driver and line receiver
de-asserts the true output signal without removing the
input signal. The LOS output can be fed back to the /EN Markets
input to maintain output stability under a loss-of-signal Optical transceivers
condition. Typically, 3.5dB LOS hysteresis is provided to
prevent chattering.
Datacom/telecom
All support documentation can be found on Micrel’s web
site at www.micrel.com.
Typical Application
MLF and MicroLeadFrame are registered trademarks of Amkor Technology, Inc.
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
February 2007
M9999-021207-B
[email protected] or (408) 955-1690

1 page




SY88289AL pdf
Micrel, Inc.
Typical Operating Characteristics
SY88289AL
February 2007
5 M9999-021207-B
[email protected] or (408) 955-1690

5 Page










PáginasTotal 9 Páginas
PDF Descargar[ Datasheet SY88289AL.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
SY88289ALCML Low-Power Limiting Post AmplifierMicrel Semiconductor
Micrel Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar