DataSheet.jp

33186 の電気的特性と機能

33186のメーカーはFreescale Semiconductorです、この部品の機能は「H-Bridge Driver」です。


製品の詳細 ( Datasheet PDF )

部品番号 33186
部品説明 H-Bridge Driver
メーカ Freescale Semiconductor
ロゴ Freescale Semiconductor ロゴ 




このページの下部にプレビューと33186ダウンロード(pdfファイル)リンクがあります。

Total 21 pages

No Preview Available !

33186 Datasheet, 33186 PDF,ピン配置, 機能
www.DataSheet4U.com
Freescale Semiconductor
Technical Data
H-Bridge Driver
The 33186 is a monolithic H-Bridge ideal for fractional horsepower
DC-motor and bi-directional thrust solenoid control. The IC
incorporates internal control logic, charge pump, gate drive, and low
RDS(ON) MOSFET output circuitry. The 33186 is able to control
continuous inductive DC load currents up to 5.0 A. Output loads can
be pulse width modulated (PWM-ed) at frequencies up to 10 kHz.
The 33186 is parametrically specified over a temperature range of
-40°C TA 125°C, 5.0 V V+ 28 V. The IC can also be operated
up to 40 V with de-rating of the specifications. The IC is available in a
surface mount power package with exposed pad for heat sinking.
Features
• Overtemperature, Short-Circuit Protection, and Overvoltage
Protection against Transients up to 40 V at VBAT Typical
• RDSon = 150 mfor each output Transistor at 25°C
• Continuous DC Load Current 5 A (TC < 100°C)
• Output Current Limitation at typ 6,5 A +/- 20%
• Short-Circuit Shutdown for Output Currents over 8 A
• Logic Inputs TTL/CMOS Compatible
• Operating Frequency up to 20 kHz
• Undervoltage Disable Function
• Diagnostic Output, 2 Disable Input
• Coding Input for Alternative Functions
• Stable Operation with an External Capacitance of Maximum 47 µF
at VBAT
• Pb-Free Packaging Designated by Suffix Code VW
Document Number: MC33186
Rev. 6.0, 10/2006
33186
H-BRIDGE MOTOR DRIVER
DH SUFFIX
VW SUFFIX (PB-FREE)
PLASTIC PACKAGE
98ASH70702A
20-PIN HSOP
ORDERING INFORMATION
Device
Temperature
Range (TA)
Package
MC33186DH1/R2
MC33186VW1/R2
-40°C to 125°C
20 HSOP
5.0 V
MCU
or
DSP
33186
CP VBAT
VPWR
OUT1
SF
MOTOR
IN1
IN2 OUT2
DI1
DI2 PGND
Figure 1. 33186 Simplified Block Diagram
Freescale Semiconductor, Inc. reserves the right to change the detail specifications,
as may be required, to permit improvements in the design of its products.
© Freescale Semiconductor, Inc., 2007. All rights reserved.

1 Page





33186 pdf, ピン配列
PIN CONNECTIONS
PIN CONNECTIONS
PIN CONNECTIONS
AGND 1
20 NC
SF 2
1 9 IN2
IN1 3
1 8 DI1
VBAT 4
1 7 CP
VBAT 5
1 6 VBAT
OUT1 6
1 5 OUT2
OUT1 7
1 4 OUT2
COD 8
1 3 DI2
PGND 9
1 2 PGND
PGND 10
1 1 PGND
Metal slug is connected to power ground
(Top View)
Figure 3. 33186 Pin Locations
Table 1. 33186 Pin Description
Pin Name
Description
9, 10, 11, 12
Metal slug
1
PGND
AGND
Power Ground. All the ground are connected together, they should be connected as short as
possible on the PCB.
Analog ground. All the ground are connected together, they should be connected as short as
possible on the PCB.
2
3,13
18, 19
8
Output
Status flag (SF)
Inputs IN1, IN2,
DI1, DI2, COD
COD
Open drain output, active low. Is set according to the truth table. When a fault appears, SF changes
typically in less than 100 ms.
Voltage controlled inputs with hysteresis
When not connected or connected to GND, a stored failure will be reset by change of the voltage-
level on DI1 or DI2.
When connected to VCC, the disable Pin DI1 and DI2 are inactive. A stored failure will be reset by
change of the voltage-level on IN1 or IN2.
6, 7, 14, 15
OUT1, OUT2 H-Bridge outputs with integrated free-wheeling diodes.
Analog Integrated Circuit Device Data
Freescale Semiconductor
33186
3


3Pages


33186 電子部品, 半導体
ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. STATIC ELECTRICAL CHARACTERISTICS
Characteristic noted under conditions -40°C to +125 °C, VBAT from 5 V to 28 V, unless otherwise note. Typical values reflect
approximate mean at 25°C, nominal VCC, at time of device characterization.
Characteristics
Symbol
Min Typ Max
Unit
POWER SUPPLY
Operating Range:
Static
Dynamic (t < 500 ms)
Stand-by current
f = 0 to 10 KHz; IOUT = 0 A
VBAT-undervoltage switch-off (without load)
Switch-off Voltage
Switch-on Voltage
Hysteresis
CHARGE-PUMP SUPPLY
VBAT
VBAT
I VBAT
5.0 28
40
– 35
4.15 4.4 4.65
4.5 4.75 5.0
150 –
V
V
mA
V
V
mV
VBAT = 4.15 V
VBAT < 40 V
LOGIC INPUTS
Input High
Input Low
Input Hysteresis
Input Pull Up Current (IN1, IN2, DI1)
UIN = 0.0 V
Input Pull Down Current (DI2,COD)(3)
UDI2 = 5.0 V
VCP - VBAT
VCP - VBAT
VINH
VINL
U
I
IDI2
3.35
3.4
0.7
- 200
1.0
- 80
25
20
1.4
100
V
V
V
V
V
µA
µA
POWER OUTPUTS: OUT1, OUT2
Switch on resistance:
ROUT - VBAT; ROUT - GND
VBAT = 5 to 28 V; CCP = 0 to 33 nF
Switch-off Current during Current Limitation
on Low Sides
Switch-off Time during Current Limitation on
Low Sides
Blanking Time during Current Limitation on
Low Sides
(IOUT) MAX
tA
tB
– – 300
5.2 6.5 7.8
15 20.5 26
12 16.5 21
m
A
µs
µs
Notes
3. In case of negative voltage at OUT2 (respectively OUT1) this maximum pull down current at DI2 (respectively COD) Pin can be
exceeded. This happens during recirculation when the current is flowing in the low side. See curve 22.
33186
6
Analog Integrated Circuit Device Data
Freescale Semiconductor

6 Page



ページ 合計 : 21 ページ
 
PDF
ダウンロード
[ 33186 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
33186

H-Bridge Driver

Freescale Semiconductor
Freescale Semiconductor


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap