DataSheet.jp

TNY277 の電気的特性と機能

TNY277のメーカーはPower Integrationsです、この部品の機能は「(TNY274 - TNY280) Energy Efficient / Off-Line Switcher」です。


製品の詳細 ( Datasheet PDF )

部品番号 TNY277
部品説明 (TNY274 - TNY280) Energy Efficient / Off-Line Switcher
メーカ Power Integrations
ロゴ Power Integrations ロゴ 




このページの下部にプレビューとTNY277ダウンロード(pdfファイル)リンクがあります。

Total 24 pages

No Preview Available !

TNY277 Datasheet, TNY277 PDF,ピン配置, 機能
www.DataSheet4U.com
TNY274-280
TinySwitch®-III Family
Energy Efficient, Off-Line Switcher with
Enhanced Flexibility and Extended Power Range
Product Highlights
+
+
Lowest System Cost with Enhanced Flexibility
• Simple ON/OFF control, no loop compensation needed
• Selectable current limit through BP/M capacitor value
- Higher current limit extends peak power or, in open
frame applications, maximum continuous power
- Lower current limit improves efficiency in enclosed
adapters/chargers
- Allows optimum TinySwitch-III choice by swapping
devices with no other circuit redesign
Wide-Range
HV DC Input
D
TinySwitch-III
S
-
EN/UV
BP/M
DC
Output
-
PI-4095-082205
• Tight I2f parameter tolerance reduces system cost
Figure 1. Typical Standby Application.
- Maximizes MOSFET and magnetics power delivery
- Minimizes max overload power, reducing cost of
transformer, primary clamp & secondary components
OUTPUT POWER TABLE
• ON-time extension – extends low line regulation range/
230 VAC ±15%
85-265 VAC
hold-up time to reduce input bulk capacitance
Self-biased: no bias winding or bias components
Frequency jittering reduces EMI filter costs
Pin-out simplifies heatsinking to the PCB
PRODUCT3
DataSheet4U.com
Peak or
Peak or
Adapter1 Open Adapter1 Open
Frame2
Frame2
DataShee
• SOURCE pins are electrically quiet for low EMI
TNY274 P or G 6 W 11 W 5 W 8.5 W
TNY275 P or G 8.5 W 15 W 6 W 11.5 W
Enhanced Safety and Reliability Features
• Accurate hysteretic thermal shutdown protection with
automatic recovery eliminates need for manual reset
TNY276 P or G 10 W 19 W
TNY277 P or G 13 W 23.5 W
7W
8W
15 W
18 W
• Improved auto-restart delivers <3% of maximum power
TNY278 P or G 16 W 28 W 10 W 21.5 W
in short circuit and open loop fault conditions
TNY279 P or G 18 W 32 W 12 W 25 W
• Output overvoltage shutdown with optional Zener
• Line under-voltage detect threshold set using a single
TNY280 P or G 20 W 36.5 W 14 W 28.5 W
optional resistor
• Very low component count enhances reliability and
enables single-sided printed circuit board layout
• High bandwidth provides fast turn on with no overshoot
and excellent transient load response
Table 1. Notes: 1. Minimum continuous power in a typical non-
ventilated enclosed adapter measured at 50 °C ambient. Use of an
external heatsink will increase power capability 2. Minimum peak
power capability in any design or minimum continuous power in an
open frame design (see Key Application Considerations). 3. Packages:
P: DIP-8C, G: SMD-8C. See Part Ordering Information.
• Extended creepage between DRAIN and all other pins
improves field reliability
EcoSmart®– Extremely Energy Efficient
• Easily meets all global energy efficiency regulations
• No-load <150 mW at 265 VAC without bias winding,
<50 mW with bias winding
• ON/OFF control provides constant efficiency down to
very light loads – ideal for mandatory CEC regulations
and 1 W PC standby requirements
Applications
• Chargers/adapters for cell/cordless phones, PDAs, digital
cameras, MP3/portable audio, shavers, etc.
DataSheet4U.com
• PC Standby and other auxiliary supplies
• DVD/PVR and other low power set top decoders
• Supplies for appliances, industrial systems, metering, etc.
Description
TinySwitch-III incorporates a 700 V power MOSFET, oscillator,
high voltage switched current source, current limit (user
selectable) and thermal shutdown circuitry. The IC family uses
an ON/OFF control scheme and offers a design flexible solution
with a low system cost and extended power capability.
February 2006
DataSheet4 U .com
DataSheet4U.com

1 Page





TNY277 pdf, ピン配列
www.DataSheet4U.com
TNY274-280
MOSFET is controlled by this pin. MOSFET switching is
terminated when a current greater than a threshold current is
drawn from this pin. Switching resumes when the current being
pulled from the pin drops to less than a threshold current. A
modulation of the threshold current reduces group pulsing. The
threshold current is between 60 µA and 115 µA.
The EN/UVpin also senses line under-voltage conditions through
an external resistor connected to the DC line voltage. If there is
no external resistor connected to this pin, TinySwitch-III detects
its absence and disables the line under-voltage function.
minadxicimateusmthdeubtyegciyncnleinsgigonfaela(cDhCcMyAcXle) .and the clock signal that
The oscillator incorporates circuitry that introduces a small
amount of frequency jitter, typically 8 kHz peak-to-peak, to
minimize EMI emission. The modulation rate of the frequency
jitter is set to 1 kHz to optimize EMI reduction for both average
and quasi-peak emissions. The frequency jitter should be
measured with the oscilloscope triggered at the falling edge of
the DRAIN waveform. The waveform in Figure 4 illustrates
the frequency jitter.
SOURCE (S) Pin:
Enable Input and Current Limit State Machine
This pin is internally connected to the output MOSFET source
The enable input circuit at the EN/UV pin consists of a low
for high voltage power return and control circuit common.
impedance source follower output set at 1.2 V. The current
through the source follower is limited to 115 µA. When the
TinySwitch-III Functional
Description
current out of this pin exceeds the threshold current, a low
logic level (disable) is generated at the output of the enable
circuit, until the current out of this pin is reduced to less than
TinySwitch-III combines a high voltage power MOSFET switch
with a power supply controller in one device. Unlike conventional
PWM (pulse width modulator) controllers, it uses a simple
ON/OFF control to regulate the output voltage.
the threshold current. This enable circuit output is sampled
at the beginning of each cycle on the rising edge of the clock
signal. If high, the power MOSFET is turned on for that cycle
(enabled). If low, the power MOSFET remains off (disabled).
Since the sampling is done only at the beginning of each cycle,
et4U.com
The controller consists of an oscillator, enable circuit (sense and
logic), current limit state machine, 5.85 V regulator, BYPASS/
subsequent changes in the EN/UV pin voltage or current during
the remainder of the cycle are ignored.
MccMlofiuuunnnUOrr-errtcLeeSiutmnniTnFottdeIEnl-leiaTFiemrml.U-xvbiTitNtteoliocnnslCticeysarTkilScgoeIwuedcnOitii,stitaN,eocaglnhnenprs-aadiceIndmIi,Iifruanrcwniuegundtqiicoeettuohr-dreyr-rgetnv,phescoooetyblvratamlraeajttgrie,no-teastks,tedteiaornamd.ivmpgdeFpt,irpiieatvvgiornooeuardlntsrttaueawaanrlg7iet2ect0cfipcesr0hircharioVunctotuDiugwetprircaectosyt,sytiwaa.otfcnhoeSnldeerr,heet4TdsraaeUawnunih.isddacseicbteirorcbeslcehmeldutteehuirenrecavneemetoenhsniftoestftheeuslaiec.nmtuttotTidrsivathidaenbeestslsttelfaewsiogtrtfreiamrhtmetctemiqhenluoriameneaflcgntadhuhccsixfenyhrwdeeilrneqoharneuaenesdengdminteucTyco.oci,ynTniennyisahdtcSboeitltwohurilsovdeoitneiwctnchhtaueghe-nrrtIerhdIcseIaeeunauiqartsddrsuejlliseuiionokmnstcretciilasleatiynmttbgheotiyodeeft
DataShee
Oscillator
current limit level accordingly in discrete amounts.
The typical oscillator frequency is internally set to an average
of 132 kHz. Two signals are generated from the oscillator: the
Under most operating conditions (except when close to no-load),
the low impedance of the source follower keeps the voltage on
600 the EN/UV pin from going much below 1.2 V in the disabled
500
VDRAIN
state. This improves the response time of the optocoupler that
is usually connected to this pin.
400
5.85 V Regulator and 6.4 V Shunt Voltage Clamp
300 The 5.85 V regulator charges the bypass capacitor connected
to the BYPASS pin to 5.85 V by drawing a current from the
200 voltage on the DRAIN pin whenever the MOSFET is off. The
100
BYPASS/MULTI-FUNCTION pin is the internal supply voltage
node. When the MOSFET is on, the device operates from the
0
136 kHz
energy stored in the bypass capacitor. Extremely low power
consumption of the internal circuitry allows TinySwitch-III to
128 kHz
operate continuously from current it takes from the DRAIN
pin. A bypass capacitor value of 0.1 µF is sufficient for both
high frequency decoupling and energy storage.
0 5 10
Time (µs)
DataSheet4FUig.ucroem4. Frequency Jitter.
3E
2/06
DataSheet4 U .com
DataSheet4U.com


3Pages


TNY277 電子部品, 半導体
www.DataSheet4U.com
TNY274-280
VEN
CLOCK
DCMAX
IDRAIN
VDRAIN
200
100
V
DC-INPUT
0
10
5
V
BYPASS
0
400
200 V
DRAIN
0
01 2
Time (ms)
Figure 11. Power-Up Without Optional External UV Resistor
Connected to EN/UV Pin.
Figure 9. Operation at Very Light Load.
PI-2661-082305
200
100
V
DC-INPUT
At near maximum load, TinySwitch-III will conduct during
0
et4U.com
nearly all of its clock cycles (Figure 6). At slightly lower load,
it will “skip” additional cycles in order to maintain voltage
400
regulation at the
loads, cycles will
power supply
be skipped and
othuetpcuutrr(eFnitgluimreit7w).illAbtemrDeedaduticauemSdheet4U30.0com
(Figure 8). At very light loads, the current limit will be reduced
200
even further (Figure 9). Only a small percentage of cycles will
occur to satisfy the power consumption of the power supply.
100
V
DRAIN
The response time of the ON/OFF control scheme is very fast
compared to PWM control. This provides tight regulation and
excellent transient response.
200
0
0 .5
Time (s)
Figure 12. Normal Power-Down Timing (without UV).
1
100
V
DC-INPUT
0
200
100
V
DC-INPUT
10
5
V
BYPASS
0
400
0 300
400
200
0
0
VDRAIN
1
Time (ms)
2
Figure 10. Power-Up with Optional External UV Resistor (4 M)
DataSheet4U.com Connected to EN/UV Pin.
6E
2/06
200
V
DRAIN
100
0
0 2.5 5
Time (s)
Figure 13. Slow Power-Down Timing with Optional External
(4 M) UV Resistor Connected to EN/UV Pin.
DataSheet4 U .com
DataSheet4U.com
DataShee

6 Page



ページ 合計 : 24 ページ
 
PDF
ダウンロード
[ TNY277 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
TNY274

(TNY274 - TNY280) Energy Efficient / Off-Line Switcher

Power Integrations
Power Integrations
TNY274G

(TNY274 - TNY280) Energy Efficient / Off-Line Switcher

Power Integrations
Power Integrations
TNY274P

(TNY274 - TNY280) Energy Efficient / Off-Line Switcher

Power Integrations
Power Integrations
TNY275

(TNY274 - TNY280) Energy Efficient / Off-Line Switcher

Power Integrations
Power Integrations


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap