|
|
PDF LA8175M Data sheet ( Hoja de datos )
| Número de pieza | LA8175M | |
| Descripción | Broadband Amplifier | |
| Fabricantes | Sanyo Electric | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de LA8175M (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
Ordering number : ENN*8131
LA8175M Monolithic Linear IC
Broadband Amplifier
Overview
The LA8175M is a broadband general purpose, low cost, high linearity RF amplifier IC.
The device offers 7 dB gain, 4.5 dB noise figure and achieves an input third order intercept point of +24 dBm.
The device is suitable to design tuner applications.
Features
• 7 dB Gain
• 4.5 dB Noise Figure
• Typical IIP3 is +24 dBm
• Single +5 V supply
Applications
• Set top box
• Cable splitters
• Antenna System
Specitications
Absolute Maximum Ratings at Ta = 25 °C
Parameter
Maximum Supply voltage
Allowable power dissipation
Symbol
VCC max
Pd max
Operating temperature
Storage temperature
Topr
Tstg
Conditions
Ta ≤ 75°C
When mounted on printed circuit board
Ratings
5.5
TBD
-20 to +75
-40 to +150
Unit
V
W
°C
°C
Recommended Operating Conditions at Ta = 25 °C
Parameter
Supply voltage
Operating supply voltage range
Symbol
VCC
VCC op
Conditions
Ratings
5.0
4.5 to 5.25
Unit
V
V
D2404 TN PC No.8131-1/5
1 page  
www.DataSheet4U.com
LA8175M
S11,S22 - Frequency
0
Supply Current - Supply Voltage
120
-5
S11
-10
-15
-20
100
80
Icc
60
-25
S22
-30
-35 Ta = Room Temp, VCC = 5 V,
-40 Zsource = Zload = 50 Ω
10 100
frequency - MHz
1000
IIP3 - Supply Current
30
100MHz
25
850MHz
20
40
20
Ta = Room Temp, VCC = 5 V,
0 Zsource = Zload = 50 Ω
3.5 4 4.5 5
Supply Voltage - V
5.5
6
15
10
5 Input = -9 dBm 2tone each, f2 - f1 = 6 MHz
Ta = Room Temp, VCC = 5 V
0 Zsource = Zload = 50 Ω
30 40 50 60 70
80
Supply Current - mA
90
100
n Specifications of any and all SANYO products described or contained herein stipulate the performance,
characteristics, and functions of the described products in the independent state, and are not guarantees of
the performance, characteristics, and functions of the described products as mounted in the customer's
products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,
the customer should always evaluate and test devices mounted in the customer's products or equipment.
n SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all
semiconductor products fail with some probability. It is possible that these probabilistic failures could give
rise to accidents or events that could endanger human lives, that could give rise to smoke or fire, or that
could cause damage to other property. When designing equipment, adopt safety measures so that these
kinds of accidents or events cannot occur. Such measures include but are not limited to protective circuits
and error prevention circuits for safe design, redundant design, and structural design.
n In the event that any or all SANYO products (including technical data, services) described or contained
herein are controlled under any of applicable local export control laws and regulations, such products must
not be exported without obtaining the export license from the authorities concerned in accordance with the
above law.
n No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system, of
otherwise, without the prior written permission of SANYO Electric Co., Ltd.
n Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification" for
the SANYO product that you intend to use.
n Information (including circuit diagrams and circuit parameters) herein is for example only; it is not
guaranteed for volume production. SANYO believes information herein is accurate and reliable, but no
guarantees are made or implied regarding its use or any infringements of intellectual property rights or other
rights of third parties.
This catalog provides information as of December, 2004. Specifications and information herein are subject to
change without notice.
PS No.8131-5/5
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet LA8175M.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| LA8175M | Broadband Amplifier | Sanyo Electric |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |