|
|
PDF HO4001-1 Data sheet ( Hoja de datos )
| Número de pieza | HO4001-1 | |
| Descripción | 1000.0 MHz SAW Oscillator | |
| Fabricantes | RF Monolithics | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de HO4001-1 (archivo pdf) en la parte inferior de esta página. Total 2 Páginas | ||
|
No Preview Available !
( DataSheet : www.DataSheet4U.com )
Preliminary
• SAW Frequency Stabilization
• Fundamental-Mode Oscillation at 1000.0 MHz
• A Rugged, Compact General-Purpose Oscillator
The frequency of this oscillator is stabilized by surface-acoustic-wave (SAW) technology. This results in ex-
cellent performance from a compact, rugged, oscillator operating at the fundamental frequency of 1000.0
MHz. The highly-reliable HO4001-1 makes it suitable for general purpose use in a wide variety of applications
HO4001-1
1000.0 MHz
SAW
Oscillator
Dip 16-8 Case
Characteristic
Operating Frequency Absolute Frequency
Tune Range
Tune Voltage
Tuning Linearity
RF Output Power
Discrete Spurious
Second Harmonics
Third and Higher Harmonics
Nonharmonic
SSB Phase Noise
1 kHz Offset
10 kHz Offset
RF Impedance
100kHz Offset
Nominal Impedance
DC Power Supply
Operating Load VSWR
Operating Voltage
Operating Current
Operating Ambient Temperature
Lid Symbolization (YY=Year, WW=Week)
Sym
fO
Notes
1, 7
PO 3, 6
2, 3, 4
2, 3, 4
ZO
GL
VCC
ICC
TA
3
3, 5
3, 6
3, 6
CAUTION: Electrostatic Sensitive Device. Observe precautions for
handling. COCOM CAUTION: Approval by the U.S. Department of
Commerce is required prior to export of this device.
Notes:
1. One or more of the following United States patents apply: 4,616,197; 4,610,681; and
4,761,616.
2. Unless noted otherwise, all specifications are listed at TA = +25°C ±2°C, VCC = nom-
inal voltage ±0.01 VDC, and load impedance = 50 Ω with VSWR ≤ 1.5:1.
3. The design, manufacturing process , and specification of this device are subject to
change without notice.
4. Applies to oscillator only and not to sidebands caused by external electrical or
mechanical sources. (Dedicated external voltage regulation with low-frequency filter-
ing for the DC power supply and proper circuit board layout are recommended for
optimum spectral purity.)
5. For specified maximum operating load VSWR (any angle) at FO. (No instability or
damage will occur for any passive load impedance.)
6. For any combination of VCC and TA within the specified operating ranges.
7. Applies for any combination of Note 5 and 6 conditions.
Minimum
999.850
0
+7
Typical
1000.0
3:1
+10
-80
-100
-130
-150
50
4.75 5.0
-20
RFM HO4001-1 YYWW
BLOCK DIAGRAM
V CC
Maximum
1000.150
+5
4:1
-15
-20
-95
-125
2:1
5.25
45
+70
Units
MHz
MHz
VDC
dBm
dBc
dBc/Hz
Ω
VDC
mA
°C
SAW Oscillator
RF OUTPUT
Buffer Amplifier
ELECTRICAL CONNECTIONS
VCC 1
Case Ground 2
Vtune
15 Case Ground
Top
View
Case Ground 7
RF Output 8
10 Case Ground
9 VCC
RF Monolithics, Inc. Phone: (972) 233-2903
Fax: (972) 387-9148
RFM Europe
Phone: 44 1963 251383
Fax: 44 1963 251510
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
www.DataSheet4U.com
E-mail: [email protected]
http://www.rfm.com
HO4001-1-062001
Page 1 of 2
1 page | ||
| Páginas | Total 2 Páginas | |
| PDF Descargar | [ Datasheet HO4001-1.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| HO4001-1 | 1000.0 MHz SAW Oscillator | RF Monolithics |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |