DataSheet.jp

HIP5063 の電気的特性と機能

HIP5063のメーカーはIntersil Corporationです、この部品の機能は「Power Control IC Single Chip Power Supply」です。


製品の詳細 ( Datasheet PDF )

部品番号 HIP5063
部品説明 Power Control IC Single Chip Power Supply
メーカ Intersil Corporation
ロゴ Intersil Corporation ロゴ 




このページの下部にプレビューとHIP5063ダウンロード(pdfファイル)リンクがあります。
Total 4 pages

No Preview Available !

HIP5063 Datasheet, HIP5063 PDF,ピン配置, 機能
HIP5063®
No ROeBcSomOLmEeTnEdePdRROeDpUlaCcTement
August 1998
File Number 3209.2
Power Control IC Single Chip Power
Supply
The HIP5063 is a complete power control IC, incorporating
both the high power DMOS transistor, CMOS logic and low
level analog circuitry on the same Intelligent Power IC.
This IC allows the user maximum flexibility in implementing
high frequency current controlled power supplies and other
power sources.
Special power transistor current sensing circuitry is
incorporated that minimizes losses due to the monitoring
circuitry. Over-temperature detection circuitry is incorporated
within the IC to monitor the chip temperature.
As a result of the power DMOS transistor’s current and
voltage capability (10A and 60V), power supplies with output
power capability up to 100 watts are possible.
Ordering Information
PART NUMBER
HIP5063DY
HIP5063DW
TEMPERATURE RANGE
0oC to +85oC
0oC to +85oC
PACKAGE
21 Pad Chip
Wafer
Features
• Single Chip Current Mode Control IC
• 60V, 10A On-chip DMOS Transistor
• Thermal Protection
• 1MHz Operation - External Clock
• Output Rise and Fall Times ~ 3ns
• Simple Implementation of High-Speed Current Mode Con-
trolled Regulators and Power Amplifiers
• Designed for 10V to 45V Operation
Applications
• Single Chip Power Supplies
• Current Mode PWM Applications
• Distributed Power Supplies
• Multiple Output Converters
• Wideband Power Amplifiers for Motor
Control
Chip
VDDP (21)
(12) VDDP
NOTE: Unused pads are for trim and test.
122 mils x 126 mils (3.1mm x 3.2mm)
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2002. All Rights Reserved

1 Page





HIP5063 pdf, ピン配列
HIP5063
Absolute Maximum Ratings
Thermal Information
DMOS Drain Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 60V
DMOS Drain Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20A
DC Logic Supply. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to 16V
Output Voltage, Logic Outputs . . . . . . . . . . . . . . . . . . . -0.3V to 16V
Input Voltage, Analog and Logic. . . . . . . . . . . . . . . . . . -0.3V to 16V
Operating Junction Temperature Range . . . . . . . . . .0oC to +110oC
Storage Temperature Range . . . . . . . . . . . . . . . . . -55oC to +150oC
Thermal Resistance
(Solder Mounted to . . . . . . . . . . . . . . . . . . . . . . . . .
3oC/θWJCMax
0.050” Thick Copper Heat Sink)
Maximum Junction Temperature. . . . . . . . . . . . . . . . . . . . . . +110oC
(Controlled By Thermal Shutdown Circuit)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Electrical Specifications VDDA = VDDD = VDDP = 12V, TJ = 0oC to +110oC; Unless Otherwise Specified
SYMBOL
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
UNITS
DEVICE PARAMETERS
I+ Supply Current
External Clock Input = 1MHz
- 14 - mA
DMOS TRANSISTORS
rDS(on)
Drain-Source On-State Resis-
tance
I Drain = 5A, TJ = +25oC
-
- 0.13
IDSS
Drain-Source Leakage Current Drain to Source Voltage = 60V
-
1 100 µA
CURRENT CONTROLLED PWM
|VIO|
VCMP
IGAIN
RIRFI
tRS
Buffer Offset Voltage
(VCMP - VIRFO)
IPEAK (DMOSDRAIN)/IIRFI
IRFI Resistance to GND
Current Comparator Response
Time (Note 1)
IRFO = 0mA to -5mA,
VCMP = 0.2V to 7.6V
I (DMOSDRAIN)/t = 1A/ms
IRFI = 2mA
I (DMOSDRAIN)/t > 1A/ms
- - 125 mV
3.8 - 4.9 A/mA
150 - 360
- 30 -
ns
MCPW
Minimum Controllable Pulse
Width (Note 1)
25 50 100 ns
MCPI
Minimum Controllable DMOS
Peak Current (Note 1)
200 400 800
mA
CLOCK
VTH CLCK CLCK Input Threshold Voltage
VTH FLLN FLLN Input Threshold Voltage
IFLLN
FLLN Pull-Up Current
THERMAL MONITOR
VFLLN = 0V
TEMP
Substrate Temperature for
TMON pin open
Thermal Monitor to Trip (Note 1)
4-8
4-8
-70 -50 -30
105 - 135
V
V
µA
oC
ILEAK COOL
VCOOL
COOL Leakage Current
COOL Low-State Voltage
VCOOL = 12V
ICOOL = 2mA, TJ > +125oC
NOTE:
1. Determined by design, not a measured parameter.
- - 1 µA
-
- 0.4
V
3


3Pages





ページ 合計 : 4 ページ
 
PDF
ダウンロード
[ HIP5063 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
HIP5060

Power Control IC Single Chip PowerSupply

Intersil Corporation
Intersil Corporation
HIP5061

7A/ High Efficiency Current Mode Controlled PWM Regulator

Intersil Corporation
Intersil Corporation
HIP5061DS

7A/ High Efficiency Current Mode Controlled PWM Regulator

Intersil Corporation
Intersil Corporation
HIP5062

Power Control IC Single Chip Dual Switching Power Supply

Intersil Corporation
Intersil Corporation


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap