DataSheet.jp


Datasheet PTC000x-01 PDF ( 特性, スペック, ピン接続図 )

部品番号 PTC000x-01
部品説明 LAN 10/100 Base T Low Profile Rj45 Jack
メーカ YCL
ロゴ YCL ロゴ 
プレビュー
Total 5 pages
		
11

No Preview Available !

PTC000x-01 Datasheet, PTC000x-01 PDF,ピン配置, 機能
PTC000X-01
LAN 10/100BASE T Low Profile RJ45 Jack With Magnetic module
Description
Feature
The PTC000X-01 modular Jack has been
specifically designed for implementation of
fast Ethernet NIC Application .
These modular consist of the isolation
transformer. Common mode choke, termination
resistors and high voltage capacitor termination
to the shield.
With high voltage isolation, optimized rise time,
wide bandwidth and stable inductance, the
transformer integrated the module provide
excellent performance as an analog interface.
Common mode choke have been designed to
significantly reduce common mode noise level
which may contribute EMI emission.
PTC000X-01 modular jack provide the system
designer the opportunity of reducing pcb space.
Designed for network interface card application.
Designed to meet IEEE802.3u requirement.
Available in all turn ratios used by LAN IC
manufactures.
Primary center taps available for additional EMI
reduction.
Simplest magnetic component to place and
route on PCB.
Contains termination resistors , magnetic
and connector.
Conserves PCB space.
Specifications
Turn Ratio
Parameter
Inductance,
Insertion loss
Return loss
Cross talk
CMRR(TX/RX)
Voltage isolation
Operating temp.
Condition
*note1
@1-100MHz
@1-30MHz
@30-60MHz *note2
@60-80MHz
@1-60MHz
@60-100MHz
@1-60MHz
@60-100MHz
Min. Max unit
350 µH
1.0 dB
16 dB
dB
10 dB
40 dB
38 dB
45/40
dB
40/35
dB
1500 vrms
0 70 0C
Part No.:
PTC0001-01
PTC0002-01
PTC0003-01
PTC0004-01
PTC0006-01
PTC0007-01
PTC0008-01
Note 1 : measured at 8mAdc over operating temperature 0-700C
Note 2: Greater than (16-20 log(f/30 MHz)) dB
Schematic
TX
1CT : 1CT
1.414CT : 1CT
2CT : 1CT
1.25CT : 1CT
1CT : 1.414CT
1CT : 1.25CT
1CT : 2CT
RX
1CT : 1CT
1CT : 1CT
1CT : 1CT
1CT : 1CT
1CT : 1CT
1CT : 1CT
1CT : 1CT
SHIELD
P8
P6
P7
P2
P3
P1
0.001uF
75
RX
75
TX
75 75
J8
J7
J6
JJ45
J3
J2
J1
Data sheet subject to change without notice
EDPS-PTC003(R5)01/25/2002
SHEET 1 OF 5

1 Page



PTC000x-01 pdf, ピン配列
Test Requirements and Procedures
NO ITEM
Requirement
Printed circuit Module Jack should not
7 board retention dislodge from p.c.b
PTC000X-01
Test or inspection Method
Apply load of 20 LBS to modular Jack
which is mounted on a printed circuit
board of 1.6mm thickness, at a rate of
25mm per minute.
Plug retention in Plug shall not dislodge from
8 Jack.
Jack and shall maintain
electrical continuity.
Apply axial Load of 20 LBS to modular
plug which is mated to a modular Jack at
a rate of 25mm per minute.
9 Vibration.
No discontinuities and show
no
evidence of physical damage.
Subject Modular Jack and Modular Plug to
sinusoidal vibration along each of 3
mutually perpendicular axes.10 Cycles at a
Level of 50m/s 2 from 10-500Hz at a rate
of 1 octave/minute.
(Duration approx. 3 x 2 hours )
Ref: IEC 68-2-6,test Fc.
10 Durability.
11 Insertion force
Contact resistance ,plug
Retention and pcb retention
shall
meet each specified
requirement
Insertion force should
not exceed 5 pounds
Mate and unmate Plug and Jack For 500
cycles total at a maximum rate of 500
cycles/hour.
Ref: IEC 512-5,test 9a.
Measure force necessary to mate Plug and
Jack at a rate of 25mm per minute
Ref:IEC512-7,test 13b.
12 Thermal shock.
Contact resistance,
Subject mated Plug and Jack to 25 cycles
Insulation resistance shall meet between –400C and 700C.The duration at
each specified requirement . the extreme temperature shall be 30
minutes.
Ref: IEC 58-2-14, test N.
13
Temperature-
humidity cycling.
Contact resistance,
Subject mated plug and Jack to10
Insulation resistance shall meet temperature – humidity cycles between
each specified requirement . 250C and 550C at 95% RH.
Ref.: IEC 68-2-30, test Db.
Data sheet subject to change without notice
EDPS-PTC003(R5)01/25/2002
SHEET 3 OF 5


3Pages







ページ 合計 : 5 ページ
PDF
ダウンロード
[ PTC000x-01.PDF ]

共有リンク

Link :

おすすめデータシート

部品番号部品説明メーカ
PTC000x-01

There is a function of LAN 10/100 Base T Low Profile Rj45 Jack.

YCL
YCL

多くを見つけるデータシート

部品番号部品説明メーカ
82S129

The 82S126 and 82S129 are field programmable, which means that custom patterns are immediately available by following the Signetics Generic fusing procedure. 1K-bit TTL Bipolar PROM, Address access time : 50ns max.

NXP
NXP
D1695

This part is a darlington connection NPN silicon epitaxial transistor. The 2SD1695 is a Darlington connection transistor and incorporates a dumper diode between the collector and emitter and a constant voltage diode and protection elements between the collector and base. This transistor is ideal for drives in solenoid and actuators.

NEC
NEC
FDMS86368

N-Channel Power Trench, 80V, 80A, 4.5mΩ.

Fairchild
Fairchild
2SC2456

Here is a Color TV Horizontal Driver, Vceo=300V, TO-126 Package.

Toshiba
Toshiba

www.DataSheet.jp    |   2018   |  メール    |   最新    |   Sitemap