![]() |
|
Número de pieza | ST62E01C | |
Descripción | (ST62T00C / ST62T01C / ST62T03C / ST62E01C) 8-BIT OTP/EPROM MCUs | |
Fabricantes | ST Microelectronics | |
Logotipo | ![]() |
|
Hay una vista previa y un enlace de descarga de ST62E01C (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available !
ST62T00C/T01C
ST62T03C/E01C
8-BIT OTP/EPROM MCUs WITH A/D CONVERTER,
OSCILLATOR SAFEGUARD, SAFE RESET AND 16 PINS
s 3.0 to 6.0V Supply Operating Range
s 8 MHz Maximum Clock Frequency
s -40 to +125°C Operating Temperature Range
s Run, Wait and Stop Modes
s 5 Interrupt Vectors
s Look-up Table capability in Program Memory
s Data Storage in Program Memory:
User selectable size
s Data RAM: 64bytes
s User Programmable Options
s 9 I/O pins, fully programmable as:
– Input with pull-up resistor
– Input without pull-up resistor
– Input with interrupt generation
– Open-drain or push-pull output
– Analog Input (except ST62T03C)
s 3I/O lines can sink up to 20mA to drive LEDs or
TRIACs directly
s 8-bit Timer/Counter with 7-bit programmable
prescaler
s Digital Watchdog
s Oscillator Safe Guard
s Low Voltage Detector for Safe Reset
s 8-bit A/D Converter with up to 4 analog inputs
s On-chip Clock oscillator can be driven by Quartz
Crystal Ceramic resonator or RC network
s Power-on Reset
s One external Non-Maskable Interrupt
s ST626x-EMU2 Emulation and Development
System (connects to an MS-DOS PC via a
parallel port)
DEVICE SUMMARY
DEVICE
ST62T00C
ST62T01C
ST62T03C
ST62E01C
OTP
(Bytes)
1036
1836
1036
-
EPROM
(Bytes)
-
-
-
1836
I/O Pins
9
9
9
9
Analog
inputs
4
4
None
4
PDIP16
PSO16
SSOP16
CDIP16W
(See end of Datasheet for Ordering Information)
August 1999
Rev. 2.8
1/70
1
1 page ![]() ![]() ST62T00C/T01C ST62T03C/E01C
1.2 PIN DESCRIPTIONS
VDD and VSS. Power is supplied to the MCU via
these two pins. VDD is the power connection and
VSS is the ground connection.
OSCin and OSCout. These pins are internally
connected to the on-chip oscillator circuit. A quartz
crystal, a ceramic resonator or an external clock
signal can be connected between these two pins.
The OSCin pin is the input pin, the OSCout pin is
the output pin.
RESET. The active-low RESET pin is used to re-
start the microcontroller. Internal pull-up is provid-
ed at this pin.
TEST/VPP. The TEST must be held at VSS for nor-
mal operation. If TEST pin is connected to a
+12.5V level during the reset phase, the EPROM
programming Mode is entered.
NMI. The NMI pin provides the capability for asyn-
chronous interruption, by applying an external non
maskable interrupt to the MCU. The NMI input is
falling edge sensitive. The user can select as op-
tion the availability of an on-chip pull-up at this pin.
PA1-PA3. These 3 lines are organized as one I/O
port (A). Each line may be configured under soft-
ware control as inputs with or without internal pull-
up resistors, interrupt generating inputs with pull-
up resistors, open-drain or push-pull outputs. PA1-
PA3 can also sink 20mA for direct LED driving.
PB0..PB1,PB3,PB5-PB7. These 6 lines are or-
ganized as one I/O port (B). Each line may be con-
figured under software control as inputs with or
without internal pull-up resistors, interrupt generat-
ing inputs with pull-up resistors, open-drain or
push-pull outputs. PB3,PB5..-PB7 can be used as
analog inputs for the A/D converter on the
ST62T00C, T01C and E01C.
Figure 2. ST62T03C,T00C, T01C, and E01C Pin
Configuration
VDD
OSCin
OSCout
NMI
VPP/T EST
RESET
Ain*/PB7
Ain*/PB6
1
2
3
4
5
6
7
8
16 VSS
15 PA1/20 mA Sink
14 PA2/20 mA Sink
13 PA3/20 mA Sink
12 PB0
11 PB1
10 PB3/Ain*
9 PB5/Ain*
*Analog input availability depend on device
5/70
5
5 Page ![]() ![]() ST62T00C/T01C ST62T03C/E01C
PROGRAMMING MODES (Cont’d)
1.4.2 Program Memory
EPROM/OTP programming mode is set by a
+12.5V voltage applied to the TEST/VPP pin. The
programming flow of the ST62T00C,T01C,T03C
and E01C is described in the User Manual of the
EPROM Programming Board.
Table 2. ST62T00C, T03C Program Memory Map
Device Address
0000h-0B9Fh
0BA0h-0F9Fh
0FA0h-0FEFh
0FF0h-0FF7h
0FF8h-0FFBh
0FFCh-0FFDh
0FFEh-0FFF h
Description
Reserved
User ROM
Reserved
Interrupt Vectors
Reserved
NMI Interrupt Vector
Reset Vector
Table 3. ST62T01C,E01C Program Memory Map
Device Address
0000h-087Fh
0880h-0F9Fh
0FA0h-0FEFh
0FF0h-0FF7h
0FF8h-0FFBh
0FFCh-0FFDh
0FFEh-0FFF h
Description
Reserved
User ROM
Reserved
Interrupt Vectors
Reserved
NMI Interrupt Vector
Reset Vector
Note: OTP/EPROM devices can be programmed
with the development tools available from STMi-
croelectronics (ST62E2X-EPB or ST622X-KIT).
1.4.3 EPROM Erasing
The EPROM of the windowed package of the
MCUs may be erased by exposure to Ultra Violet
light. The erasure characteristic of the MCUs is
such that erasure begins when the memory is ex-
posed to light with a wave lengths shorter than ap-
proximately 4000Å. It should be noted that sun-
lights and some types of fluorescent lamps have
wavelengths in the range 3000-4000Å.
It is thus recommended that the window of the
MCUs packages be covered by an opaque label to
prevent unintentional erasure problems when test-
ing the application in such an environment.
The recommended erasure procedure of the
MCUs EPROM is the exposure to short wave ul-
traviolet light which have a wave-length 2537A.
The integrated dose (i.e. U.V. intensity x exposure
time) for erasure should be a minimum of 30W-
sec/cm2. The erasure time with this dosage is ap-
proximately 30 to 40 minutes using an ultraviolet
lamp with 12000µW/cm2 power rating. The
ST62E01C should be placed within 2.5cm (1Inch)
of the lamp tubes during erasure.
11/70
11
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet ST62E01C.PDF ] |
Número de pieza | Descripción | Fabricantes |
ST62E01C | (ST62T00C / ST62T01C / ST62T03C / ST62E01C) 8-BIT OTP/EPROM MCUs | ![]() ST Microelectronics |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
![]() Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
![]() Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |