DataSheet.es    


PDF SP5748KG Data sheet ( Hoja de datos )

Número de pieza SP5748KG
Descripción 2.4GHz Very Low Phase Noise PLL
Fabricantes Mitel Networks 
Logotipo Mitel Networks Logotipo



Hay una vista previa y un enlace de descarga de SP5748KG (archivo pdf) en la parte inferior de esta página.


Total 15 Páginas

No Preview Available ! SP5748KG Hoja de datos, Descripción, Manual

SP5748
2.4GHz Very Low Phase Noise PLL
Advance Information
DS4875 - 1.3 November 1998
The SP5748 is a single chip frequency synthesiser
designed for tuning systems up to 2.4 GHz and is
optimized for low phase noise with comparison
frequencies up to 4 MHz. It is designed to be downwards
software compatible with the SP5658.
The RF programmable divider contains a front end dual
modulus 16/17 functioning over the full operating range
and allows for coarse tuning in the upconverter
application and fine tuning in the downconverter.
CHARGE PUMP
CRYSTAL CAP
CRYSTAL
ENABLE
DATA
CLOCK
PORT P1/OC
14 DRIVE
VEE
RF INPUT
RF INPUT
VCC
REF
PORT P0/OP
Comparison frequencies are obtained either from a
crystal controlled on-chip oscillator or from an external
source. a buffered reference frequency output is also
available to drive a second SP5748.
MP14
Figure1 Pin connections - top view
The device also contains 2 switching ports.
FEATURES
q Complete 2.4 GHz single chip system
(for faster device refer to to SP5768)
q Optimised for low phase noise, with comparison
frequencies up to 4 MHz
q No RF prescaler
q Selectable reference division ratio
q Reference frequency output
q Selectable charge pump current
q Integrated loop amplifier
q Two switching ports
q Low power replacement for SP5658 and 5668
q Downwards software compatible with SP5658
q ESD protection, (Normal ESD handling
procedures should be observed)
APPLICATIONS
q TV, VCR and Cable tuning systems
q Communications systems
ORDERING INFORMATION
SP5748/KG/MP1S (Tubes)
SP5748/KG/MP1T (Tape and Reel)

1 page




SP5748KG pdf
ABSOLUTE MAXIMUM RATINGS
All voltages are referred to VEE at 0V
Characteristic
Pin
Supply voltage, Vcc
10
RF input voltage
11,12
RF input DC offset
11,12
Port voltage
7,8
Charge pump DC offset
1
Varactor drive DC offset
14
Crystal DC offset
2,3
Buffered ref output
9
Data, clock & enable
DC offset
5,6,4
Storage temperature
Junction temperature
MP14 thermal resistance,
chip to ambient
chip to case
Power consumption at
Vcc=5.5V
ESD protection
Min
-0.3
-0.3
-0.3
-0.3
-0.3
-0.3
-0.3
-0.3
-55
2
SP5748 Advance Information
Typ Max Units
Conditions
7V
2.5
Vcc+0.3
Vcc+0.3
Vcc+0.3
Vcc+0.3
Vcc+0.3
Vcc+0.3
Vcc+0.3
Vp-p
V
V
V
V
V
V
V
Differential across pins
11 and 12
+125
+150
°C
°C
81
27
TBC
°C/W
°C/W
mW
All ports off
kV Mil-std 883B latest revision
method 3015 cat.1.
Functional description
The SP5748 contains all the elements necessary, with
the exception of a frequency reference, loop filter and
external high voltage transistor, to control a varicap
tuned local oscillator, so forming a complete PLL
frequency synthesised source. The device allows for
operation with a high comparison frequency and is
fabricated in high speed logic, which enables the
generation of a loop with excellent phase noise
performance, even with high comparison frequencies.
The package and pin allocation is shown in Figure 1 and
the block diagram in Figure 2.
The SP5748 is controlled by a standard 3-wire bus
comprising data, clock and enable inputs. The
programming word contains 26 bits, two of which are
used for port selection, 17 to set the programmable
divider ratio, four bits to select the reference division
ratio, bits RD & R0-R2, see Figure 7, two bits to set
charge pump current, bit C0 and C1, see Figure 5, and
the remaining bit to access test modes, bit T0, see
Figure 8. The programming format is shown in Figure 4.
The clock input is disabled by an enable low signal, data
is therefore only loaded into the internal shift registers
during an enable high and is clocked into the controlling
buffers by an enable high to low transition. This load is
also synchronised with the programmable divider so
giving smooth fine tuning.
The RF signal is fed to an internal preamplifier, which
provides gain and reverse isolation from the divider
signals. The output of the preamplifier is fed to the 17 bit
fully programmable counter, which is of MN+A
architecture. The M counter is 13 bit and the A counter
4
The output of the programmable counter is fed to the
phase comparator where it is compared in both phase
and frequency domain with the comparison frequency.
This frequency is derived either from the on board
crystal controlled oscillator or from an external
reference source. In both cases the reference
frequency is divided down to the comparison frequency
by the reference divider which is programmable into1 of
16 ratios as descried in Figure 7.
The output of the phase detector feeds the charge pump
and loop amplifier section, which when used with an
external high voltage transistor and loop filter integrates
the current pulses into the varactor line voltage. The
charge pump current setting is described in Figure 5,
A buffered crystal reference frequency suitable for
driving further synthesisers is available from pin 9. If not
required this output can be disabled by connecting to
Vcc
The programmable divider output divided by 2, Fpd/2
and comparison frequency, Fcomp can be switched to
ports P0 and P1 respectively by switching the device
into test mode. The test modes are described in Figure
8. 5

5 Page





SP5748KG arduino
SP5748 Advance Information
Top view
Bottom view
Figure 13
11

11 Page







PáginasTotal 15 Páginas
PDF Descargar[ Datasheet SP5748KG.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
SP5748KG2.4GHz Very Low Phase Noise PLLMitel Networks
Mitel Networks
SP5748KGMP1S2.4GHz Very Low Phase Noise PLLMitel Networks
Mitel Networks
SP5748KGMP1T2.4GHz Very Low Phase Noise PLLMitel Networks
Mitel Networks

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar