|
|
PDF STK402-020 Data sheet ( Hoja de datos )
| Número de pieza | STK402-020 | |
| Descripción | Two-Channel Class AB Audio Power Amplifier IC 20 W + 20 W | |
| Fabricantes | Sanyo | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de STK402-020 (archivo pdf) en la parte inferior de esta página. Total 5 Páginas | ||
|
No Preview Available !
Ordering number : ENN7061A
Thick-Film Hybrid IC
STK402-030
Two-Channel Class AB Audio Power Amplifier IC
20 W + 20 W
Overview
The STK402-000 series products are audio power
amplifier hybrid ICs that consist of optimally-designed
discrete component power amplifier circuits that have
been miniaturized using SANYO's unique insulated metal
substrate technology (IMST). SANYO has adopted a new
low thermal resistance substrate in these products to
reduce the package size by about 60% as compared to the
earlier SANYO STK407-000 series.
Features
Package Dimensions
unit: mm
4189-SIP15
[STK402-030]
• Series of pin compatible power amplifiers ranging from
20 W × 2 channels to 120 W × 2 channels (10%/1 kHz)
devices. The same printed circuit board can be used
depending on the output power grade.
• The pin arrangement is compatible with that of the 3-
channel STK402-200 series. This means that 3-channel
printed circuit boards can also be used for 2-channel
products.
• Miniature packages
— 15 W/ch to 40 W/ch (THD = 0.4%, f = 20 Hz to
20 kHz); 46.6 mm × 25.5 mm × 8.5 mm *
— 50 W/ch to 80 W/ch (THD = 0.4%, f = 20 Hz to
20 kHz); 59.2 mm × 31.0 mm × 8.5 mm *
*: Not including the pins.
• Output load impedance: RL = 6 Ω
• Allowable load shorted time: 0.3 seconds
• Supports the use of standby, muting, and load shorting
protection circuits.
SANYO: SIP15
Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s
control systems, or other applications whose failure can be reasonably expected to result in serious
physical and/or material damage. Consult with your SANYO representative nearest you before using
any SANYO products described or contained herein in such applications.
SANYO assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other
parameters) listed in products specifications of any and all SANYO products described or contained
herein.
SANYO Electric Co.,Ltd. Semiconductor Company
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
D1602AS (OT) No. 7061-1/5
1 page  
STK402-030
50
RL = 6 Ω
f = 1kHz
Rg = 600 Ω
40 2ch drive
VCC = ±22 V
30
Pd -- PO
20
10
0
0.1 2 3 5 7 1.0 2 3 5 7 10 2 3 5 7 100
Output power, PO / ch -- W
ITF02141
PO -- f
50
Tc = 25°C
VG = 30 dB
Rg = 600
40
RL = 6 Ω, VCC = ± 22V, THD = 10%
30 RL = 6 Ω, VCC = ± 22 V, THD = 0.4%
20
10
0
10 2 3 5 7 100 2 3 5 7 1k 2 3 5 710k 2 3 5 7100k
Frequency, f - Hz
ITF02144
10
7 Tc = 25°C
5
3
VCC = ±22 V
2 VG = 30 dB
1.0 RL = 6 Ω
7 Rg = 600 Ω
5
3
2
THD -- PO
0.1
7 20 kHz
5
3
2
0.01
7
5
1 kHz
20 Hz
3
2
0.001
0.1
2 3 5 7 1.0
2 3 5 7 10
2 3 5 7 100
0
Tc = 25°C
--10 No loaded
Output power, PO -- W
VCC -- VN
ITF02142
--20
--30
--40
--50
--60
--70
--80
--90
--100
--110
--120
--130
0
5 10 15 20 25 30 35 40
Supply voltage, ±VCC -- V
ITF02146
Specifications of any and all SANYO products described or contained herein stipulate the performance,
characteristics, and functions of the described products in the independent state, and are not guarantees
of the performance, characteristics, and functions of the described products as mounted in the customer’s
products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,
the customer should always evaluate and test devices mounted in the customer’s products or equipment.
SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all
semiconductor products fail with some probability. It is possible that these probabilistic failures could
give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire,
or that could cause damage to other property. When designing equipment, adopt safety measures so
that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective
circuits and error prevention circuits for safe design, redundant design, and structural design.
In the event that any or all SANYO products (including technical data, services) described or contained
herein are controlled under any of applicable local export control laws and regulations, such products must
not be exported without obtaining the export license from the authorities concerned in accordance with the
above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system,
or otherwise, without the prior written permission of SANYO Electric Co., Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the “Delivery Specification”
for the SANYO product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not
guaranteed for volume production. SANYO believes information herein is accurate and reliable, but
no guarantees are made or implied regarding its use or any infringements of intellectual property rights
or other rights of third parties.
This catalog provides information as of December, 2002. Specifications and information herein are
subject to change without notice.
PS No. 7061-5/5
5 Page | ||
| Páginas | Total 5 Páginas | |
| PDF Descargar | [ Datasheet STK402-020.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| STK402-020 | Two-Channel Class AB Audio Power Amplifier IC 20 W + 20 W | Sanyo |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |