DataSheet.jp

V42100 PDF Data sheet ( 特性 )

部品番号 V42100
部品説明 Surface Mount Voltage Controlled Oscillator WLAN 2050 - 2150 MHz
メーカ Tyco Electronics
ロゴ Tyco Electronics ロゴ 



Total 2 pages
		

No Preview Available !

V42100 Datasheet, V42100 PDF,ピン配置, 機能
Surface Mount Voltage Controlled Oscillator
V42100
V42100
Surface Mount Voltage Controlled Oscillator
WLAN 2050 - 2150 MHz
Features
Miniature SMT Package
Low Phase Noise
Highly Linear Tuning
+3V Operation
Description
The V42100 is a fundamental single ended oscillator designed for
use in cost sensitive wireless applications. The VCO integrates a
bipolar transistor, varactor diode and high Q resonator in a surface
mount package. The standard SMT packaging provides electrical
shielding and easy PCB assembly. The circuit design and com-
ponent device selection have been optimised for low phase noise
and highly linear tuning performance.
M/A-COM VCOs are manufactured in facilities using advanced
surface mount assembly and automated electrical test equipment.
This ensures consistent electrical performance and product quality
over volume manufacturing quantities.
LSM4 Package
2.0
0.5
IDENT
7.6
6.9
VCC
M/ A- COM
VT PART NO.
RF
1.3
PLATED AREA
0.7
1.3
DETAIL A.
12
1
3
DETAIL A.
3.0
Electrical Specifications1, TA = +25°C, VCC = +3V (unless otherwise stated)
Parameter
Frequency Range (FOUT)
Tuning Voltage (VT)2
RF Output Power (POUT)3
Harmonic Output4
Phase Noise5
Average Tuning Sensitivity6
Tuning Linearity7
Frequency Pushing
Frequency Pulling
Frequency Drift
Tune Input Capacitance
Supply Current (ICC)
Supply Voltage (VCC)
Over TOP
Over TOP
Over TOP
Test Conditions
SSB at 10 kHz offset from carrier
SSB at 100 kHz offset from carrier
VCC +3V ± 0.15V
Over all phases of a 1.14:1 VSWR load
Over TOP
Recommended operating limit
Units
MHz
V
dBm
dBc
dBc/Hz
dBc/Hz
MHz/V
Ratio
MHz/V
MHz
MHz/°C
pF
mA
V
Min.
2050
+0.6
+5.0
+2.85
Typ.
-20
-87
-108
100
1.4
5
10
-0.51
13
Max.
2150
+4.0
+10.0
-82
-103
10
12
50
18
+3.15
1. All specification limits are indicated values and apply over FOUT and
for 50 load impedance.
2. Tuning voltages shown are the minimum and maximum voltages
required to tune the frequency range, including temperature effects
over 0°C to +70°C. Devices will oscillate normally with tuning volt-
ages from 0V to +6V.
3. Output power window includes variation over operating temperature
range (TOP) 0°C to +70°C and output frequency range (FOUT).
4. Non harmonic spurious less than -70 dBc.
5. See plot for typical phase noise at other offset frequencies.
6. Defined as (2150 - 2050) / (VT 2150 - VT 2050) MHz/V.
7. The max/min ratio of tuning sensitivity over FOUT, see plot for typi-
cal tuning linearity measured over 0.5V intervals
V2.00
www.macom.com
M/A-COM Division of AMP Incorporated s North America: Tel. (800) 366-2266, Fax (800) 618-8883 s Asia/Pacific: Tel.+85 2 2111 8088,
Fax +85 2 2111 8087 s Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
AMP and Connecting at a Higher Level are trademarks.
Specifications subject to change without notice.

1 Page





ページ 合計 : 2 ページ
PDF
ダウンロード
[ V42100.PDF ]

共有リンク

Link :

おすすめデータシート

部品番号部品説明メーカ
V42100

Surface Mount Voltage Controlled Oscillator WLAN 2050 - 2150 MHz

Tyco Electronics
Tyco Electronics

www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap