|
|
PDF XCST50 Data sheet ( Hoja de datos )
| Número de pieza | XCST50 | |
| Descripción | CCD B/W VIDEO CAMERA MODULE | |
| Fabricantes | Sony Corporation | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de XCST50 (archivo pdf) en la parte inferior de esta página. Total 31 Páginas | ||
|
No Preview Available !
CCD B/W VIDEO
CAMERA MODULE
XC-ST50/50CE
XC-ST30/30CE
User’s
Guide
(Ver. 1.0) — English —
1 page  
MAIN SPECIFICATIONS
XC-ST50/50CE
XC-ST30/30CE
Image pickup device
XC-ST50/50CE: 1/2-inch interline transfer CCD
XC-ST30/30CE: 1/3-inch interline transfer CCD
Number of effective pixels
XC-ST50/ST30: 768(H) x 494(V)
XC-ST50CE/ST30CE: 752(H) x 582(V)
CCD horizontal driving frequency
XC-ST50/ST30: 14.318 MHz
XC-ST50CE/ST30CE: 14.187 MHz
CCD vertical driving frequency
XC-ST50/ST30: 15.734 kHz
XC-ST50CE/ST30CE: 15.625 kHz
Signal system
EIA/CCIR
Cell size
XC-ST50:
8.4(H) x 9.8(V) um
XC-ST50CE:
8.6(H) x 8.3(V) um
XC-ST30:
6.35(H) x7.4(V) um
XC-ST30CE:
6.5(H) x6.25(V) um
Lens mount
C mount
Flange back
17.526 mm
Synchronization system
Internal/external
(Selected automatically)
External sync input/output
HD/VD (2 to 5 Vp-p)
VS (Sync level: 0.3 Vp-p+0.3V )
–0.15 V
* Automatically selected according
to the existence of an input signal
when the selection switch on the
rear panel is set to EXT.
Allowable frequency deviation of external synchronization
±1%
(in horizontal synchronous frequency)
Jitter
Within ± 50 nsec
Scanning system
2:1 interlaced
Non-interlaced
(during external sync input)
Horizontal resolution
XC-ST50/ST30: 570 TV lines
XC-ST50CE/ST30CE: 560 TV lines
Sensitivity
XC/ST50/50CE: 400 lx F8 (r=ON,0 dB)
XC/ST30/30CE: 400 lx F5.6 (r=ON,0 dB)
S/N ratio
XC-ST50/50CE: 60 dB/58dB
XC-ST30/30CE: 56 dB/54dB
Minimum illuminance 0.3 lx (F1.4, AGC ON)
Gain
AGC/Manual/Fixed
(Can be selected using the
switch on the rear panel.)
Gamma correction
ON/OFF
(Can be selected using the
switch on the rear panel.)
Electronic shutter
XC-ST50/ST30: 1/100 to 1/10,000 seconds
XC-ST50CE/ST30CE: 1/120 to 1/10,000 seconds
External trigger shutter
XC-ST50/ST30: 1/4 to 1/10,000 seconds
XC-ST50CE/ST30CE: 1/4 to 1/8,000 seconds
* Set using the DIP switch on the rear panel, or
continuously variable with the trigger pulse width.
Supply voltage
+12 VDC (+10.5 V to 15V)
Power consumption XC-ST50/50CE: 2.0 W
XC-ST30/30CE: 1.9 W
Operating temperature –5 ˚C to +45 ˚C
Storage temperature –30 ˚C to +60 ˚C
Performance assurance temperature
0 ˚C to +40 ˚C
Operating humidity 20 to 80 % (Non-condensing)
Storage humidity
20 to 95 % (Non-condensing)
Vibration resistance 10G
(For 20 minutes in the X, Y, and
Z directions at 20 to 200 Hz)
Shock resistance
70G
Outside dimensions 44(W) x 29(H) x 57.5(D) mm
Weight
110 g
Standards
UL1492, FCC Class A Digital
Device, and CE (EN50081-2 +
EN50082-2)
Other
Restart Reset function
Frame or field integration can be
selected.
Conforms to new 12-pin EIAJ
assignment.
Accessories
Lens mount cap (1)
Instruction Manual (1)
External synchronization for each mode
Mode
Normal
Normal shutter
Mode 1
Internal sync
External sync
HD/VD
VS
×
Mode 2
Restart Reset
Trigger signal
generates an
internal VD
(single) signal.
×
××
×
: Can be used.
×: Cannot be used.
3
5 Page 
ELECTRONIC SHUTTER
XC-ST50/50CE
XC-ST30/30CE
Specifications of trigger pulse
When using a trigger pulse like shown below, set the TRIG polarity selector switch on the rear panel to + :
A
B
T
A: 2 to 5.0 V
B: 0 to 0.6 V
T: 2 µs to 1/4 s, 100 µs to 1/4 s when setting the shutter speed using DIP switch
When using a trigger pulse like shown below, set the TRIG polarity selector switch on the rear panel to – :
A
B
T
A: 4.0 to 5.0 V
B: 0 to 2.0 V
T: 2 µs to 1/4 s, 100 µs to 1/4 s when setting the shutter speed using DIP switch
* Input impedance: 10 kΩ or more
* The voltage and pulse width used are measured at pin 11 of a 12-pin multi-connector on the rear panel.
Specifications of WEN (Write ENable Pulse)
A
B
T
A: 5.0 V
B: 0 V
T: 15.875 ms (XC-ST50/30), 18.752 ms (XC-ST50CE/30CE)
* Output impedance: 10 kΩ or more
9
11 Page | ||
| Páginas | Total 31 Páginas | |
| PDF Descargar | [ Datasheet XCST50.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| XCST50 | CCD B/W VIDEO CAMERA MODULE | Sony Corporation |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |