DataSheet.jp

ISL8485E PDF Datasheet ( 特性, スペック, ピン接続図 )

部品番号 ISL8485E
部品説明 ESD Protected to 15kV/ 5V/ Low Power/ High Speed or Slew Rate Limited/ RS-485/RS-422 Transceivers
メーカ Intersil Corporation
ロゴ Intersil Corporation ロゴ 



Total 14 pages
		

No Preview Available !

ISL8485E Datasheet, ISL8485E PDF,ピン配置, 機能
®
Data Sheet
ISL8483E, ISL8485E
December 2003
FN6048.3
ESD Protected to ±15kV, 5V, Low Power,
High Speed or Slew Rate Limited,
RS-485/RS-422 Transceivers
These Intersil RS-485/RS-422 devices are ESD protected,
BiCMOS 5V powered, single transceivers that meet both the
RS-485 and RS-422 standards for balanced communication.
Each driver output/receiver input is protected against ±15kV
ESD strikes, without latch-up. Unlike competitive devices,
this Intersil family is specified for 10% tolerance supplies
(4.5V to 5.5V).
The ISL8483E utilizes slew rate limited drivers which reduce
EMI, and minimize reflections from improperly terminated
transmission lines, or unterminated stubs in multidrop and
multipoint applications.
Data rates up to 5Mbps are achievable by using the
ISL8485E which features higher slew rates.
Both devices present a “single unit load” to the RS-485 bus,
which allows up to 32 transceivers on the network.
Receiver (Rx) inputs feature a “fail-safe if open” design,
which ensures a logic high Rx output, if Rx inputs are
floating.
Driver (Tx) outputs are short circuit protected, even for
voltages exceeding the power supply voltage. Additionally,
on-chip thermal shutdown circuitry disables the Tx outputs to
prevent damage if power dissipation becomes excessive.
These half duplex configurations multiplex the Rx inputs and
Tx outputs to allow transceivers with Rx and Tx disable
functions in 8 lead packages.
Features
• RS-485 I/O Pin ESD Protection . . . . . . . . . . . . . ±15kV HBM
- Class 3 ESD Level on all Other Pins . . . . . . >7kV HBM
• Specified for 10% Tolerance Supplies
• High Data Rate Version (ISL8485E) . . . . . . up to 5Mbps
• Slew Rate Limited Version for Error Free Data
Transmission (ISL8483E) . . . . . . . . . . . . . .up to 250kbps
• Single Unit Load Allows up to 32 Devices on the Bus
• 1nA Low Current Shutdown Mode (ISL8483E)
• Low Quiescent Current:
- 160µA (ISL8483E)
- 340µA (ISL8485E)
• -7V to +12V Common Mode Input Voltage Range
• Three State Rx and Tx Outputs
• 30ns Propagation Delays, 5ns Skew (ISL8485E)
• Operate from a Single +5V Supply (10% Tolerance)
• Current Limiting and Thermal Shutdown for driver
Overload Protection
Applications
• Factory Automation
• Security Networks
• Building Environmental Control Systems
• Industrial/Process Control Networks
• Level Translators (e.g., RS-232 to RS-422)
• RS-232 “Extension Cords”
TABLE 1. SUMMARY OF FEATURES
PART HALF/FULL NO. OF DEVICES DATA RATE SLEW-RATE RECEIVER/DRIVER QUIESCENT LOW POWER PIN
NUMBER DUPLEX ALLOWED ON BUS (Mbps)
LIMITED?
ENABLE?
ICC (µA) SHUTDOWN? COUNT
ISL8483E
Half
32
0.25 Yes
Yes
160 Yes 8
ISL8485E
Half
32
5 No
Yes 340 No 8
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2003. All R ights Reserved.
All other trademarks mentioned are the property of their respective owners.

1 Page





ページ 合計 : 14 ページ
PDF
ダウンロード
[ ISL8485E.PDF ]

共有リンク

Link :

おすすめデータシート

部品番号部品説明メーカ
ISL8485

5V/ Low Power/ High Speed or Slew Rate Limited/ RS-485/RS-422 Transceivers

Intersil Corporation
Intersil Corporation
ISL8485E

ESD Protected to 15kV/ 5V/ Low Power/ High Speed or Slew Rate Limited/ RS-485/RS-422 Transceivers

Intersil Corporation
Intersil Corporation

www.DataSheet.jp    |   2019   |  メール    |   最新    |   Sitemap