DataSheet.jp

AV0332C の電気的特性と機能

AV0332CのメーカーはApuls Intergrated Circuitsです、この部品の機能は「single-chip synthesizing CMOS VLSI」です。


製品の詳細 ( Datasheet PDF )

部品番号 AV0332C
部品説明 single-chip synthesizing CMOS VLSI
メーカ Apuls Intergrated Circuits
ロゴ Apuls Intergrated Circuits ロゴ 




このページの下部にプレビューとAV0332Cダウンロード(pdfファイル)リンクがあります。
Total 13 pages

No Preview Available !

AV0332C Datasheet, AV0332C PDF,ピン配置, 機能
APLUS 巨華積体電路股份有限公司 AVxxx-TGx8 Series
GENERAL DESCRIPTION:
The AV0332C, AV0632E, AV0932B, AV0932C, AV1232D, AV1832C, AV2432B, AV3032, AV4232,is a single-chip
synthesizing CMOS VLSI that can synthesize voice up to 3,6,9,12,18,24,30,42 seconds ,using APLUS qualified coding algorithm
(LOGPCM).Customer speech data will be edited and programmed into ROM by changing one mask during the device fabrication.
FEATURES:
1. Single power supply can operate from 2.4v through 5v.
2. The total voice duration is about 3, 6, 9, 12, 18, 24, 30, 42 seconds could be partitioned up to 32 voice sections .
each voice section could have 4 playing_length , the longest one is the original voice+mute length .
3. Voice + mute length could up to 22 seconds ( 6k sample rate ) for each voice section .
4. One 255 voice-steps table ,could be partitioned up to 32 groups of voice-step .
For each voice-step, could specify one length of one voice section and one of 5 levels playback speed and STS1,STS2,STS3,
STS4 enable options .
playback speed : 1>4.3k ; 2>5k ; 3>6k ; 4>7.5k ; 5>10khz .
STS4,3,2,1 enable options : each with one control bit . ( dec to bin ; '0' -> enable , '1' -> disable )
5. Three mask option trigger input mode : MATRIX , ALONE ( with mode selection ,priority and debounce )
one mode control input 'MODE' , could be used as mode selection or STS4 . ( mask option )
MATRIX : 4x4 matrix inputs ; M1-- M16 ( MODE=0 -> subtable1 - 16 ; MODE=1 -> subtable17 - 32 )
priority : M1>M2>M3>M4 ; M5>M6>M7>M8 ; M9>M10>M11>M12 ; M13>M14>M15>M16 .
debounce : 11ms or 1ms .
ALONE : 8 alone inputs ; A1 -- A8 ( MODE=0 -> subtable1 - 8 ; MODE=1 -> subtable9 - 16 )
each input could be one of 3 resistive type input :
1>10Mohm to GND ; 2>schmitt (270k - 1M) for CDS interface ; 3>schmitt ( 270k - 10M ) for CDS interface .
A1 could be trigger input or control outputs ( COUT , PWM , STS ) enable ( '1' ) or disable ( '0' ) .
priority : A1>A2>A3>A4>A5>A6>A7>A8 .
debounce : 10ms or 50us
If MODE/STS4 is in STS4 mode , MATRIX only ( subtable1 - 16 ) , ALONE only ( subtable1 - 8 )
In both mode , all the trigger input could be assign as different playing mode with following options :
EDGE/LEVEL ; HOLD/UNHOLD ; RETRIGGER/IRRETRIGGER .
CPU_INTERFACE : addressing access mode by input pulse count , in this mode A1 - A7 were disable ,could be access up to
32 subtables .
6. A8 or M16 could be mask_selected as NORMAL , SEQUENTIAL or CPU_INTERFACE .
NORMAL : normal mode as in item 5 .
SEQUENTIAL : could be mask_selected as combined with MODE input or not .
If A8 or M16 is in SEQUENTIAL and combined with MODE input :
MODE=1 -> the device will response by one subtable sequentially and cyclically , from subtable1 7 to user _specify
end subtable.
MODE=0 -> the device will response by one subtable sequentially and cyclically , from subtable 1 to user _specify
end subtable.
The number of subtables (used in sequence) in MODE=1 and MODE=0 must be equal ; this number must less than 16 .
If A8 or M16 is in SEQUENTIAL and not combined with MODE input :
The device will response by one subtable sequentially and cyclically , from subtable1 to user defined end subtable.
The relationship between SEQUENTIAL ( A8/M16 ) and other inputs ( A1-A7 / M1-M15 ) could be mask_selected as
RESET or UNRESET .
RESET : once the other inputs were triggered the SEQUENTIAL sequence will reset to subtable 1.
UNRESET : sequential sequence and other inputs are indenpent .
7. 4 OUT pins with following options :
OUT1 : COUT or STS1 OUT2 : PWM1 or STS2 OUT3 : PWM2 or STS3 OUT4 : MODE or STS4
COUT has 3 current output levels : 1>1.5mA ; 2>3mA ; 3>4.5mA . ( full scale ; Vdd=3v )
PWM1 and PWM2 must be selected on the same time , can direct driving BUZZER or 8 or 32 or 64 ohm SPEAKER .
www.aplusinc.com.tw
Page 1 / 13
2002 Ver.2

1 Page





AV0332C pdf, ピン配列
APLUS 巨華積体電路股份有限公司 AVxxx-TGx8 Series
BLOCK DIAGRAM:
㆒般規格:
AV0332C, AV0632E, AV0932B, AV0932C, AV1232D, AV1832C, AV2432B, AV3032, AV4232
㆒單晶CMOS VLSI 語音合成器,它以LOGPCM編碼方式,合成長達3,6,9,12,18,24,30,42秒之語
音。藉由製造過程㆗更換光罩,將客戶需要之語音資料編寫入ROM㆗。
特性:
1. 單㆒工作電壓範圍為2.4 - 5 伏特。
2. 語音總長度可達3,6,9,12,18,24,30,42秒,且可被分割成32語音段(section),每段長度
可不同。每㆒段有㆕種不同播放時間的選擇,但是任何㆒種播放時間皆不可長於原段
(語音+靜音)時間。
3. 其㆗每㆒段的長度 (語音+靜音時間) 最多可達22秒。 (6kHz取樣頻率㆘)
www.aplusinc.com.tw
Page 3 / 13
2002 Ver.2


3Pages


AV0332C 電子部品, 半導体
APLUS 巨華積体電路股份有限公司 AVxxx-TGx8 Series
STS3輸出的選擇
STS4輸出的選擇
A) PWM2聲音輸出
A) MODE選擇
B) 停止播放時送出高位準脈衝.
B) 停止播放時送出高位準脈衝.
C) 停止播放時送出低位準脈衝.
C) 停止播放時送出低位準脈衝.
D) 播放時送出高位準訊號
D) 播放時送出高位準訊號.
E) 播放時送出低位準訊號
E) 播放時送出低位準訊號.
F) LED 6HZ(靜音時閃爍).
F) LED 6HZ(靜音時閃爍).
G) LED 3HZ(靜音時閃爍).
G) LED 3HZ(靜音時閃爍).
H) LED 1.5HZ(靜音時閃爍).
H) LED 1.5HZ(靜音時閃爍).
I) LED 0.75HZ(靜音時閃爍).
I) LED 0.75HZ(靜音時閃爍).
J) LED 6HZ(靜音時熄滅).
J) LED 6HZ(靜音時亮著).
K) LED 3HZ(靜音時熄滅).
K) LED 3HZ(靜音時亮著).
L) LED 1.5HZ(靜音時熄滅).
L) LED 1.5HZ(靜音時亮著).
M) LED 0.75HZ(靜音時熄滅).
M)LED 0.75HZ(靜音時亮著).
N) LED動態送出低位準脈衝 0.34( 每㆒語音格 ).
N) LED 6HZ(靜音時熄滅).
O) LED動態送出低位準脈衝 0.68( 每㆒語音格 ).
O) LED 3HZ(靜音時熄滅).
P) LED動態送出低位準脈衝 1.02( 每㆒語音格 ).
P) LED 1.5HZ(靜音時熄滅).
Q) 播放時 (靜音除外) 送出高位準訊號.
Q) LED 0.75HZ(靜音時熄滅).
R) 播放時 (靜音除外) 送出低位準訊號.
R) LED動態 1/4位準訊號.
S) LED動態 2/4位準訊號.
T) LED動態 3/4位準訊號.
STS1(STS3)STS2(STS4)選擇相同LED 6HZLED 3HZLED 1.5HZLED
0.75 HZ之模式時它們將交互閃爍。
STS1STS3同時選擇 LED動態送出低位準脈衝( 每㆒語音格 ),須選擇同㆒秒數。
※若STS2STS4同時選擇 LED動態位準訊號,須選擇 同㆒位準。
STS1STS2STS3STS4可由光罩選擇對每㆒語音格( voice step)致能或非致能。
※狀態輸出方式請以時序圖為準。
※選擇 STS1(STS3) 的靜音閃爍時 , 可選擇 3HZ , 1.5HZ 0.75HZ的輸出.
※選擇 STS2(STS4) 的靜音閃爍時 , 可選擇 3HZ , 1.5HZ 0.75HZ的輸出.
※選擇 STS1( STS2,STS3,STS4 )的靜音時熄滅和選擇 STS2( STS4) 的靜音時熄滅
或 靜音時亮著, 僅可選擇單㆒位準 3HZ , 1.5HZ 0.75HZ的輸出.
9.自動選擇振盪電阻(光罩選擇)
A). 致能 - 如果有接外部振盪電阻,則優先使用外部振盪電阻;如果沒有,則使用內部
已選擇之振盪電阻(振盪電阻的狀態須在觸發前決定)
B). 非致能 - 只能使用外部振盪電阻。
C). 內部振盪電阻選擇:(光罩選擇)
For AV0332C, AV0632E, AV0932B, AV0932C, AV1232D, AV1832C, AV2432B, AV3032, AV4232
電阻選選擇
AB C D E F GH I
J KL
4.3 8.9 8.6 7.9 7 6.3 5.8 5.4 5.1 4.7 4.3 4.1 3.9
5 10.3 10 9.2 8.2 7.3 6.8 6.3 5.9 5.5 5 4.8 4.6
6 12.4 12 11 9.8 8.8 8.1 7.5 7.1 6.6 6 5.7 5.5
7.5 15.5 15 13.8 12.3 11 10.1 9.4 8.9 8.3 7.5 7.1 6.9
10 20.7 20 18.3 16.3 14.7 13.5 12.5 11.8 11 10 9.5 9.2
M
3.6
4.2
5
6.3
8.3
www.aplusinc.com.tw
Page 6 / 13
2002 Ver.2

6 Page



ページ 合計 : 13 ページ
 
PDF
ダウンロード
[ AV0332C データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
AV0332C

single-chip synthesizing CMOS VLSI

Apuls Intergrated Circuits
Apuls Intergrated Circuits
AV0332E

3/ 7/ 14 Seconds Complicate Pure Speech

Apuls Intergrated Circuits
Apuls Intergrated Circuits


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap