DataSheet.jp

HS-508ARH-T の電気的特性と機能

HS-508ARH-TのメーカーはIntersil Corporationです、この部品の機能は「Radiation Hardened 8 Channel CMOS Analog Multiplexer with Overvoltage Protection」です。


製品の詳細 ( Datasheet PDF )

部品番号 HS-508ARH-T
部品説明 Radiation Hardened 8 Channel CMOS Analog Multiplexer with Overvoltage Protection
メーカ Intersil Corporation
ロゴ Intersil Corporation ロゴ 




このページの下部にプレビューとHS-508ARH-Tダウンロード(pdfファイル)リンクがあります。
Total 3 pages

No Preview Available !

HS-508ARH-T Datasheet, HS-508ARH-T PDF,ピン配置, 機能
Data Sheet
HS-508ARH-T
July 1999 File Number 4605.1
Radiation Hardened 8 Channel CMOS
Analog Multiplexer with Overvoltage
Protection
Intersil‘s Satellite Applications FlowTM (SAF) devices are
fully tested and guaranteed to 100kRAD total dose. This
QML Class T device is processed to a standard flow
intended to meet the cost and shorter lead-time needs of
large volume satellite manufacturers, while maintaining a
high level of reliability.
The HS-508ARH-T is a dielectrically isolated, radiation
hardened, CMOS analog multiplexer incorporating an
important feature; it withstands analog input voltages much
greater than the supplies. This is essential in any system
where the analog inputs originate outside the equipment.
They can withstand a continuous input up to 10V greater
than either supply, which eliminates the possibility of
damage when supplies are off, but input signals are present.
Equally important, it can withstand brief input transient
spikes of several hundred volts; which otherwise would
require complex external protection networks. Necessarily,
ON resistance is somewhat higher than similar unprotected
devices, but very low leakage current combine to produce
low errors. Reference Application Notes 520 and 521,
available from the Semiconductor Products Division of
Intersil, for further information on the HS-508ARH-T
multiplexer in general.
Specifications
Specifications for Rad Hard QML devices are controlled by
the Defense Supply Center in Columbus (DSCC). The SMD
numbers listed below must be used when ordering.
Detailed Electrical Specifications for the HS-508ARH-T
are contained in SMD 5962-96742. A “hot-link” is provided
from our website for downloading.
www.intersil.com/spacedefense/newsafclasst.asp
Intersil‘s Quality Management Plan (QM Plan), listing all
Class T screening operations, is also available on our
website.
www.intersil.com/quality/manuals.asp
Ordering Information
ORDERING
NUMBER
PART
NUMBER
TEMP.
RANGE
(oC)
5962R9674201TEC
HS1-508ARH-T
-55 to 125
5962R9674201TXC
HS9-508ARH-T
-55 to 125
NOTE: Minimum order quantity for -T is 150 units through
distribution, or 450 units direct.
Features
• QML Class T, Per MIL-PRF-38535
• Radiation Performance
- Gamma Dose (γ) 1 x 105 RAD(Si)
- No Latch-Up, Dielectrically Isolated Device Islands
- SEP LET > 110MeV/mg/cm2
• Analog/Digital Overvoltage Protection
• Fail Safe with Power Loss (No Latchup)
• Break-Before-Make Switching
• DTL/TTL and CMOS Compatible
• Analog Signal Range ±15V
• Fast Access Time
• Supply Current at 1MHz Address Toggle (Typ) 4mA
• Standby Power (Typ.) 7.5mW
Pinouts
HS1-508ARH-T (SBDIP), CDIP2-T16
TOP VIEW
AO 1
EN 2
V- 3
IN 1 4
IN 2 5
IN 3 6
IN 4 7
OUT 8
16 A1
15 A2
14 GND
13 V+
12 IN 5
11 IN 6
10 IN 7
9 IN 8
HS9-508ARH-T (FLATPACK), CDFP4-F16
TOP VIEW
A0
EN
V-
IN1
IN2
IN3
IN4
OUT
1 16
2 15
3 14
4 13
5 12
6 11
7 10
89
A1
A2
GND
V+
IN5
IN6
IN7
IN8
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
www.intersil.com or 407-727-9207 | Copyright © Intersil Corporation 1999
Satellite Applications Flow™ (SAF) is a trademark of Intersil Corporation.

1 Page





HS-508ARH-T pdf, ピン配列
Die Characteristics
DIE DIMENSIONS:
(2108µm x 2743µm x 279µm ±25.4µm)
83 x 108 x 11mils ±1mil
METALLIZATION:
Type: Al Si
Thickness: 12.5kÅ ±2kÅ
SUBSTRATE POTENTIAL:
Unbiased (DI)
BACKSIDE FINISH:
Silicon
Metallization Mask Layout
HS-508ARH-T
PASSIVATION:
Type: Silox (SiO2)
Thickness: 8.0kÅ ±1.0kÅ
WORST CASE CURRENT DENSITY:
6.68e4 A/cm2
TRANSISTOR COUNT:
253
PROCESS:
CMOS-DI
HS-508ARH-T
IN3
IN4
OUT
IN8
IN7
IN6
EN
A0
A1
A2
All Intersil semiconductor products are manufactured, assembled and tested under ISO9000 quality systems certification.
Intersil semiconductor products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design and/or specifications at any time with-
out notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and
reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result
from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see web site http://www.intersil.com
3


3Pages





ページ 合計 : 3 ページ
 
PDF
ダウンロード
[ HS-508ARH-T データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
HS-508ARH-T

Radiation Hardened 8 Channel CMOS Analog Multiplexer with Overvoltage Protection

Intersil Corporation
Intersil Corporation


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap