DataSheet.jp

A42U0616V-80 の電気的特性と機能

A42U0616V-80のメーカーはAMIC Technologyです、この部品の機能は「1M X 16 CMOS DYNAMIC RAM WITH EDO PAGE MODE」です。


製品の詳細 ( Datasheet PDF )

部品番号 A42U0616V-80
部品説明 1M X 16 CMOS DYNAMIC RAM WITH EDO PAGE MODE
メーカ AMIC Technology
ロゴ AMIC Technology ロゴ 




このページの下部にプレビューとA42U0616V-80ダウンロード(pdfファイル)リンクがあります。
Total 25 pages

No Preview Available !

A42U0616V-80 Datasheet, A42U0616V-80 PDF,ピン配置, 機能
A42U0616 Series
Preliminary
1M X 16 CMOS DYNAMIC RAM WITH EDO PAGE MODE
Document Title
1M X 16 CMOS DYNAMIC RAM WITH EDO PAGE MODE
Revision History
Rev. No. History
0.0 Initial issue
Issue Date
June 13, 2001
Remark
Preliminary
Preliminary (June, 2001, Version 0.0)
AMIC Technology, Inc.

1 Page





A42U0616V-80 pdf, ピン配列
Selection Guide
Symbol
tRAC
tAA
tCAC
tOEA
tRC
tPC
Description
Maximum RAS Access Time
Maximum Column Address Access Time
Maximum CAS Access Time
Maximum Output Enable ( OE ) Access Time
Minimum Read or Write Cycle Time
Minimum EDO Cycle Time
Functional Description
The A42U0616 reads and writes data by multiplexing an
20-bit address into a 10-bit row and 10-bit column address.
RAS and CAS are used to strobe the row address and the
column address, respectively.
The A42U0616 has two CAS inputs: LCAS controls I/O0-
I/O7, and UCAS controls I/O8 - I/O15, UCAS and LCAS
function in an identical manner to CAS in that either will
generate an internal CAS signal. The CAS function and
timing are determined by the first CAS ( UCAS or
LCAS ) to transition low and by the last to transition high.
Byte Read and Byte Write are controlled by using LCAS
and UCAS separately.
A Read cycle is performed by holding the WE signal high
during RAS / CAS operation. A Write cycle is executed by
holding the WE signal low during RAS / CAS operation;
the input data is latched by the falling edge of WE or
CAS , whichever occurs later. The data inputs and outputs
are routed through 16 common I/O pins, with RAS , CAS ,
WE and OE controlling the in direction.
EDO Page Mode operation all 1024(1K) columns within a
selected row to be randomly accessed at a high data rate.
A EDO Page Mode cycle is initiated with a row address
latched by RAS followed by a column address latched by
CAS . While holding RAS low, CAS can be toggled to
strobe changing column addresses, thus achieving shorter
cycle times.
The A42U0616 offers an accelerated Fast Page Mode
cycle through a feature called Extended Data Out, which
A42U0616 Series
-50 -60 -80 Unit
50 60 80 ns
25 30 40 ns
13 15 20 ns
13 15 20 ns
84 104 134 ns
20 25 35 ns
keeps the output drivers on during the CAS precharge
time (tcp). Since data can be output after CAS goes high,
the user is not required to wait for valid data to appear
before starting the next access cycle. Data-out will remain
valid as long as RAS and OE are low, and WE is high;
this is the only characteristic which differentiates Extended
Data Out operation from a standard Read or Fast Page
Read.
A memory cycle is terminated by returning both RAS and
CAS high. Memory cell data will retain its correct state by
maintaining power and accessing all 1024(1K)
combinations of the 10-bit row addresses, regardless of
sequence, at least once every 16ms through any RAS
cycle (Read, Write) or RAS Refresh cycle ( RAS -only,
CBR, or Hidden). The CBR Refresh cycle automatically
controls the row addresses by invoking the refresh counter
and controller.
Power-On
The initial application of the VCC supply requires a 200 µs
wait followed by a minimum of any eight initialization cycles
containing a RAS clock. During Power-On, the VCC
current is dependent on the input levels of RAS and CAS .
It is recommended that RAS and CAS track with VCC or
be held at a valid VIH during Power-On to avoid current
surges.
PRELIMINARY (June, 2001, Version 0.0)
2
AMIC Technology, Inc.


3Pages


A42U0616V-80 電子部品, 半導体
A42U0616 Series
Absolute Maximum Ratings*
Input Voltage (Vin) . . . . . . . . . . . . . . . -0.5V to VCC+0.5V
Output Voltage (Vout) . . . . . . . . . . . . . -0.5V to VCC+0.5V
Power Supply Voltage (VCC) . . . . . . . -0.5V to VCC+0.5V
Operating Temperature (TOPR) . . . . . . . . . . 0°C to +70°C
Storage Temperature (TSTG) . . . . . . . . . -55°C to +150°C
Soldering Temperature X Time (TSOLDER) . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C X 10sec
Power Dissipation (PD) . . . . . . . . . . . . . . . . . . . . . . . . 1W
Short Circuit Output Current (Iout) . . . . . . . . . . . . . . 50mA
Latch-up Current . . . . . . . . . . . . . . . . . . . . . . . . . . 200mA
*Comments
Stresses above those listed under "Absolute Maximum
Ratings" may cause permanent damage to this device.
These are stress ratings only. Functional operation of
this device at these or any other conditions above
those indicated in the operational sections of these
specification is not implied or intended. Exposure to
the absolute maximum rating conditions for extended
periods may affect device reliability.
DC Electrical Characteristics (VCC = 2.5V ± 10%, VSS = 0V, Ta = 0°C to +70°C)
Symbol
Parameter
IIL Input Leakage
Current
IOL Output Leakage
Current
ICC1 Operating Power
Supply Current
ICC2 TTL Standby Power
Supply Current
ICC3 Average Power
Supply Current,
RAS Refresh Mode
ICC4 EDO Page Mode
Average Power
Supply Current
ICC5 CAS -before- RAS
Refresh Power
Supply Current
ICC6 CMOS Standby
Power Supply
Current
ICC7 Self Refresh Mode
Current
VOH
Output Voltage
VOL
-50 -60
Min. Max. Min. Max.
-5 +5 -5 +5
-5 +5 -5 +5
- 120 - 110
-1-1
- 120 - 110
- 100 -
90
- 110 - 100
- 0.2 - 0.2
- 250 - 250
2.0 - 2.0 -
- 0.4 - 0.4
-80
Min. Max.
-5 +5
-5 +5
- 100
-1
Unit
µA
µA
mA
mA
Test Conditions
0V Vin Vin + 0.2V
Pins not under
Test = 0V
DOUT disabled,
0V Vout + VCC
RAS ,UCAS ,LCAS
Address cycling; tRC = min.
RAS =UCAS =LCAS =VIH
Notes
1, 2
- 100 mA RAS cycling,
UCAS =LCAS = VIH,
tRC = min.
- 80 mA RAS = VIL,
UCAS ,LCAS Address
cycling; tPC = min.
- 90 mA RAS , UCAS , LCAS
cycling; tRC = min.
1
1, 2
1
- 0.2 mA RAS =UCAS =LCAS =
VCC - 0.2V
- 250 µA RAS = CAS VSS+0.2V
All other input high levels
are VCC-0.2V or input low
levels are VSS +0.2V
2.0 -
V IOUT = -2mA
- 0.4 V IOUT = 2mA
PRELIMINARY (June, 2001, Version 0.0)
5
AMIC Technology, Inc.

6 Page



ページ 合計 : 25 ページ
 
PDF
ダウンロード
[ A42U0616V-80 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
A42U0616V-80

1M X 16 CMOS DYNAMIC RAM WITH EDO PAGE MODE

AMIC Technology
AMIC Technology


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap