DataSheet.jp

A42L2604S-50 の電気的特性と機能

A42L2604S-50のメーカーはAMIC Technologyです、この部品の機能は「4M X 4 CMOS DYNAMIC RAM WITH EDO PAGE MODE」です。


製品の詳細 ( Datasheet PDF )

部品番号 A42L2604S-50
部品説明 4M X 4 CMOS DYNAMIC RAM WITH EDO PAGE MODE
メーカ AMIC Technology
ロゴ AMIC Technology ロゴ 




このページの下部にプレビューとA42L2604S-50ダウンロード(pdfファイル)リンクがあります。

Total 25 pages

No Preview Available !

A42L2604S-50 Datasheet, A42L2604S-50 PDF,ピン配置, 機能
A42L2604 Series
Preliminary
4M X 4 CMOS DYNAMIC RAM WITH EDO PAGE MODE
Document Title
4M X 4 CMOS DYNAMIC RAM WITH EDO PAGE MODE
Revision History
Rev. No.
0.0
0.1
0.2
0.3
History
Initial issue
Modify symbol HE dimensions in TSOP 24L package information
Add -45 grade and modify the AC, DC data
Add -U type spec.
Modify DC data and all parts guarantee self-refresh mode
Issue Date
June 13, 2001
July 10, 2001
November 30, 2001
June 10, 2002
Remark
Preliminary
PRELIMINARY (June, 2002, Version 0.3)
AMIC Technology, Inc.

1 Page





A42L2604S-50 pdf, ピン配列
Selection Guide
Symbol
tRAC
tAA
tCAC
tOEA
tRC
tPC
Description
Maximum RAS Access Time
Maximum Column Address Access Time
Maximum CAS Access Time
Maximum Output Enable ( OE ) Access Time
Minimum Read or Write Cycle Time
Minimum EDO Cycle Time
Functional Description
The A42L2604 reads and writes data by multiplexing an
22-bit address into a 11-bit(2K) row and column address.
RAS and CAS are used to strobe the row address and the
column address, respectively.
A Read cycle is performed by holding the WE signal high
during RAS / CAS operation. A Write cycle is executed by
holding the WE signal low during RAS / CAS operation;
the input data is latched by the falling edge of WE or
CAS , whichever occurs later. The data inputs and outputs
are routed through 4 common I/O pins, with RAS , CAS ,
WE and OE controlling the in direction.
EDO Page Mode operation all 2048(2K) columns within a
selected row to be randomly accessed at a high data rate.
A EDO Page Mode cycle is initiated with a row address
latched by RAS followed by a column address latched by
CAS . While holding RAS low, CAS can be toggled to
strobe changing column addresses, thus achieving shorter
cycle times.
The A42L2604 offers an accelerated Fast Page Mode
cycle through a feature called Extended Data Out, which
keeps the output drivers on during the CAS precharge
time (tcp). Since data can be output after CAS goes high,
the user is not required to wait for valid data to appear
before starting the next access cycle. Data-out will remain
A42L2604 Series
-45 -50 Unit
45 50 ns
20 22 ns
12 13 ns
12 13 ns
76 84 ns
18 20 ns
valid as long as RAS and OE are low, and WE is high;
this is the only characteristic which differentiates Extended
Data Out operation from a standard Read or Fast Page
Read.
A memory cycle is terminated by returning both RAS and
CAS high. Memory cell data will retain its correct state by
maintaining power and accessing all 2048(2K)
combinations of the 11-bit(2K) row addresses, regardless
of sequence, at least once every 32ms through any RAS
cycle (Read, Write) or RAS Refresh cycle ( RAS -only,
CBR, or Hidden). The CBR Refresh cycle automatically
controls the row addresses by invoking the refresh counter
and controller.
Power-On
The initial application of the VCC supply requires a 200 µs
wait followed by a minimum of any eight initialization cycles
containing a RAS clock. During Power-On, the VCC
current is dependent on the input levels of RAS and CAS .
It is recommended that RAS and CAS track with VCC or
be held at a valid VIH during Power-On to avoid current
surges.
PRELIMINARY (June, 2002, Version 0.3)
2
AMIC Technology, Inc.


3Pages


A42L2604S-50 電子部品, 半導体
Absolute Maximum Ratings*
Input Voltage (Vin) . . . . . . . . . . . . . . . . . . . -0.5V to +4.6V
Output Voltage (Vout) . . . . . . . . . . . . . . . . -0.5V to +4.6V
Power Supply Voltage (VCC) . . . . . . . . . . . -0.5V to +4.6V
Operating Temperature (TOPR) . . . . . . . . . . 0°C to +70°C
Storage Temperature (TSTG) . . . . . . . . . -55°C to +150°C
Soldering Temperature X Time (TSOLDER) . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C X 10sec
Power Dissipation (PD) . . . . . . . . . . . . . . . . . . . . . . . . 1W
Short Circuit Output Current (Iout) . . . . . . . . . . . . . 50mA
Latch-up Current . . . . . . . . . . . . . . . . . . . . . . . . . . 200mA
A42L2604 Series
*Comments
Stresses above those listed under "Absolute Maximum
Ratings" may cause permanent damage to this device.
These are stress ratings only. Functional operation of
this device at these or any other conditions above
those indicated in the operational sections of these
specification is not implied or intended. Exposure to
the absolute maximum rating conditions for extended
periods may affect device reliability.
DC Electrical Characteristics (VCC = 3.3V ± 0.3V, VSS = 0V, Ta = 0°C to +70°C or -40°C to +85°C)
Symbol
Parameter
-45 -50
Unit
Min. Max. Min. Max.
Test Conditions
IIL Input Leakage Current -5 +5 -5 +5 µA 0V Vin Vin + 0.3V
Pins not under
Test = 0V
IOL Output Leakage Current -5 +5 -5 +5 µA DOUT disabled,
0V Vout + VCC
ICC1 Operating Power Supply - 80 - 75 mA RAS ,UCAS ,LCAS and
Current
Address cycling; tRC = min.
ICC2 TTL Standby Power
Supply Current
- 1.5 - 1.5 mA RAS =UCAS =LCAS =VIH
ICC3 Average Power
Supply Current,
RAS Refresh Mode
- 80 - 75 mA RAS and Address cycling,
UCAS =LCAS = VIH,
tRC = min.
ICC4 EDO Page Mode
Average Power
Supply Current
ICC5 CAS -before- RAS
Refresh Power
Supply Current
- 80 - 75 mA RAS = VIL,
UCAS ,LCAS and Address
cycling; tPC = min.
- 80 - 75 mA RAS , UCAS and LCAS
cycling; tRC = min.
ICC6 CMOS Standby Power
Supply Current
- 1.0 - 1.0 mA RAS =UCAS =LCAS =
VCC - 0.2V
ICC7 Self Refresh Mode
Current
- 350 - 350 µA RAS = CAS VSS+0.2V
All other input high levels are
VCC-0.2V or input low levels
are VSS +0.2V
VOH
Output Voltage
VOL
2.4 - 2.4 -
- 0.4 - 0.4
V IOUT = -2.0mA
V IOUT =2.0mA
Notes
1, 2
1
1, 2
1
PRELIMINARY (June, 2002, Version 0.3)
5
AMIC Technology, Inc.

6 Page



ページ 合計 : 25 ページ
 
PDF
ダウンロード
[ A42L2604S-50 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
A42L2604S-50

4M X 4 CMOS DYNAMIC RAM WITH EDO PAGE MODE

AMIC Technology
AMIC Technology


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap