DataSheet.jp

N0795YN180 の電気的特性と機能

N0795YN180のメーカーはIXYSです、この部品の機能は「Phase Control Thyristor」です。


製品の詳細 ( Datasheet PDF )

部品番号 N0795YN180
部品説明 Phase Control Thyristor
メーカ IXYS
ロゴ IXYS ロゴ 




このページの下部にプレビューとN0795YN180ダウンロード(pdfファイル)リンクがあります。

Total 12 pages

No Preview Available !

N0795YN180 Datasheet, N0795YN180 PDF,ピン配置, 機能
Date:- 6th December, 2012
Data Sheet Issue:- A1
Phase Control Thyristor
Types N0795YN100 to N0795YN180
Absolute Maximum Ratings
VDRM
VDSM
VRRM
VRSM
VOLTAGE RATINGS
Repetitive peak off-state voltage, (note 1)
Non-repetitive peak off-state voltage, (note 1)
Repetitive peak reverse voltage, (note 1)
Non-repetitive peak reverse voltage, (note 1)
OTHER RATINGS
IT(AV)M
IT(AV)M
IT(AV)M
IT(RMS)M
IT(d.c.)
ITSM
ITSM2
I2t
I2t
(di/dt)cr
VRGM
PG(AV)
PGM
Tj op
Tstg
Maximum average on-state current, Tsink=55°C, (note 2)
Maximum average on-state current. Tsink=85°C, (note 2)
Maximum average on-state current. Tsink=85°C, (note 3)
Nominal RMS on-state current, Tsink=25°C, (note 2)
D.C. on-state current, Tsink=25°C, (note 4)
Peak non-repetitive surge tp=10ms, Vrm=60%VRRM, (note 5)
Peak non-repetitive surge tp=10ms, Vrm10V, (note 5)
I2t capacity for fusing tp=10ms, Vrm=60%VRRM, (note 5)
I2t capacity for fusing tp=10ms, Vrm10V, (note 5)
(continuous, 50Hz)
Critical rate of rise of on-state current (note 6) (repetitive, 50Hz, 60s)
(non-repetitive)
Peak reverse gate voltage
Mean forward gate power
Peak forward gate power
Operating temperature range
Storage temperature range
Notes:-
1) De-rating factor of 0.13% per °C is applicable for Tj below 25°C.
2) Double side cooled, single phase; 50Hz, 180° half-sinewave.
3) Anode side cooled, single phase; 50Hz, 180° half-sinewave.
4) Double side cooled.
5) Half-sinewave, 125°C Tj initial.
6) VD=67% VDRM, ITM=1000A, IFG=2A, tr0.5µs, Tcase=125°C.
Data Sheet. Types N0795YN100 to N0795YN180 Issue A1
Page 1 of 12
MAXIMUM
LIMITS
1000-1800
1100-1900
1000-1800
1100-1900
MAXIMUM
LIMITS
795
540
300
1580
1340
9450
10500
444×103
551×103
250
500
1000
5
3
30
-60 to +125
-60 to +125
UNITS
V
V
V
V
UNITS
A
A
A
A
A
A
A
A2s
A2s
A/µs
V
W
W
°C
°C
December, 2012

1 Page





N0795YN180 pdf, ピン配列
Phase Control Thyristor Types N0795YN100 to N0795YN180
Notes on Ratings and Characteristics
1.0 Voltage Grade Table
Voltage Grade
10
12
14
16
18
VDRM VRRM
V
1000
1200
1400
1600
1800
VDSM VRSM
V
1100
1300
1500
1700
1900
VD VR
DC V
750
900
1050
1200
1350
2.0 Extension of Voltage Grades
This report is applicable to other voltage grades when supply has been agreed by Sales/Production.
3.0 De-rating Factor
A blocking voltage de-rating factor of 0.13%/°C is applicable to this device for Tj below 25°C.
4.0 Repetitive dv/dt
Standard dv/dt is 1000V/µs.
5.0 Snubber Components
When selecting snubber components, care must be taken not to use excessively large values of snubber
capacitor or excessively small values of snubber resistor. Such excessive component values may lead to
device damage due to the large resultant values of snubber discharge current. If required, please consult
the factory for assistance.
6.0 Rate of rise of on-state current
The maximum un-primed rate of rise of on-state current must not exceed 400A/µs at any time during turn-
on on a non-repetitive basis. For repetitive performance, the on-state rate of rise of current must not
exceed 200A/µs at any time during turn-on. Note that these values of rate of rise of current apply to the
total device current including that from any local snubber network.
7.0 Gate Drive
The nominal requirement for a typical gate drive is illustrated below. An open circuit voltage of at least
30V is assumed. This gate drive must be applied when using the full di/dt capability of the device.
IGM
4A/µs
tp1
IG
The magnitude of IGM should be between five and ten times IGT, which is shown on page 2. Its duration
(tp1) should be 20µs or sufficient to allow the anode current to reach ten times IL, whichever is greater.
Otherwise, an increase in pulse current could be needed to supply the necessary charge to trigger. The
‘back-porch’ current IG should remain flowing for the same duration as the anode current and have a
magnitude in the order of 1.5 times IGT.
Data Sheet. Types N0795YN100 to N0795YN180 Issue A1
Page 3 of 12
December, 2012


3Pages


N0795YN180 電子部品, 半導体
Phase Control Thyristor Types N0795YN100 to N0795YN180
9.0 Reverse recovery ratings
(i) Qra is based on 50% Irm chord as shown in Diagram
1
(ii) Qrr is based on a 150µs integration time i.e.
(iii) K Factor = t1
t2
150 µs
Qrr = irr .dt
0
Diagram 1
Data Sheet. Types N0795YN100 to N0795YN180 Issue A1
Page 6 of 12
December, 2012

6 Page



ページ 合計 : 12 ページ
 
PDF
ダウンロード
[ N0795YN180 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
N0795YN180

Phase Control Thyristor

IXYS
IXYS


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap