DataSheet.jp

K2960TT460 の電気的特性と機能

K2960TT460のメーカーはIXYSです、この部品の機能は「Medium Voltage Thyristor」です。


製品の詳細 ( Datasheet PDF )

部品番号 K2960TT460
部品説明 Medium Voltage Thyristor
メーカ IXYS
ロゴ IXYS ロゴ 




このページの下部にプレビューとK2960TT460ダウンロード(pdfファイル)リンクがあります。
Total 11 pages

No Preview Available !

K2960TT460 Datasheet, K2960TT460 PDF,ピン配置, 機能
WESTCODE
An IXYS Company
Date:- 9 Oct, 2003
Data Sheet Issue:- 2
Provisional Data
Medium Voltage Thyristor
Types K2960T#450 to K2960T#520
Old Type No.: P1263DH45-52
Absolute Maximum Ratings
VDRM
VDSM
VRRM
VRSM
VOLTAGE RATINGS
Repetitive peak off-state voltage, (note 1)
Non-repetitive peak off-state voltage, (note 1)
Repetitive peak reverse voltage, (note 1)
Non-repetitive peak reverse voltage, (note 1)
MAXIMUM
LIMITS
4500-5200
4500-5200
4500-5200
4600-5300
UNITS
V
V
V
V
OTHER RATINGS
IT(AV)M
IT(AV)M
IT(AV)M
IT(RMS)
IT(d.c.)
ITSM
ITSM2
I2t
I2t
(di/dt)cr
VRGM
PG(AV)
PGM
Tj op
Tstg
Maximum average on-state current, Tsink=55°C, (note 2)
Maximum average on-state current. Tsink=85°C, (note 2)
Maximum average on-state current. Tsink=85°C, (note 3)
Nominal RMS on-state current, Tsink=25°C, (note 2)
D.C. on-state current, Tsink=25°C, (note 4)
Peak non-repetitive surge tp=10ms, Vrm=0.6VRRM, (note 5)
Peak non-repetitive surge tp=10ms, Vrm10V, (note 5)
I2t capacity for fusing tp=10ms, Vrm=0.6VRRM, (note 5)
I2t capacity for fusing tp=10ms, Vrm10V, (note 5)
Critical rate of rise of on-state current (continuous, 50Hz), (Note 6)
Critical rate of rise of on-state current (repetitive, 50Hz, 60s), (Note 6)
Critical rate of rise of on-state current (non-repetitive), (Note 6)
Peak reverse gate voltage
Mean forward gate power
Peak forward gate power
Operating temperature range
Storage temperature range
Notes:-
1) De-rating factor of 0.13% per °C is applicable for Tj below 25°C.
2) Double side cooled, single phase; 50Hz, 180° half-sinewave.
3) Single side cooled, single phase; 50Hz, 180° half-sinewave.
4) Double side cooled.
5) Half-sinewave, 125°C Tj initial.
6) VD=67% VDRM, IFG=2A, tr0.5µs, Tcase=125°C.
MAXIMUM
LIMITS
2960
2044
1248
5825
5095
32.5
36
5.28×106
6.48×106
150
300
600
5
5
50
-40 to +125
-40 to +150
UNITS
A
A
A
A
A
kA
kA
A2s
A2s
A/µs
A/µs
A/µs
V
W
W
°C
°C
Provisional Data Sheet. Types K2960T#450 to K2960T#520 Issue 2
Page 1 of 11
October, 2003

1 Page





K2960TT460 pdf, ピン配列
WESTCODE An IXYS Company
Medium Voltage Thyristor Types K2960T#450 to K2960T#520
Notes on Ratings and Characteristics
1.0 Voltage Grade Table
Voltage Grade
45
46
48
50
52
VDRM VDSM VRRM
V
4500
4600
4800
5000
5200
VRSM
V
4600
4700
4900
5100
5300
VD VR
DC V
2100
2120
2160
2200
2240
2.0 Extension of Voltage Grades
This report is applicable to other voltage grades when supply has been agreed by Sales/Production.
3.0 De-rating Factor
A blocking voltage de-rating factor of 0.13%/°C is applicable to this device for Tj below 25°C.
4.0 Repetitive dv/dt
Standard dv/dt is 1000V/µs.
5.0 Gate Drive
The nominal requirement for a typical gate drive is illustrated below. An open circuit voltage of at least 30V
is assumed. This gate drive must be applied when using the full di/dt capability of the device.
IGM
4A/µs
IG
tp1
The magnitude of IGM should be between five and ten times IGT, which is shown on page 2. Its duration
(tp1) should be 20µs or sufficient to allow the anode current to reach ten times IL, whichever is greater.
Otherwise, an increase in pulse current could be needed to supply the necessary charge to trigger. The
‘back-porch’ current IG should remain flowing for the same duration as the anode current and have a
magnitude in the order of 1.5 times IGT.
6.0 Frequency Ratings
The curves illustrated in figures 17 & 18 are for guidance only and are superseded by the maximum
ratings shown on page 1. For operation above line frequency, please consult the factory for assistance.
7.0 Rate of rise of on-state current
The maximum un-primed rate of rise of on-state current must not exceed 1000A/µs at any time during
turn-on on a non-repetitive basis. For repetitive performance, the on-state rate of rise of current must not
exceed 500A/µs at any time during turn-on. Note that these values of rate of rise of current apply to the
total device current including that from any local snubber network.
8.0 Square wave frequency ratings
These ratings are given for load component rate of rise of on-state current of 50A/µs.
Provisional Data Sheet. Types K2960T#450 to K2960T#520 Issue 2
Page 3 of 11
October, 2003


3Pages


K2960TT460 電子部品, 半導体
WESTCODE An IXYS Company
Curves
Figure 1 - On-state characteristics of Limit device
10000
K2960T#450-520
Issue 2
Tj = 125°C
Medium Voltage Thyristor Types K2960T#450 to K2960T#520
Figure 2 - Transient thermal impedance
0.1
K2960T#450-520
Issue 2
SSC
0.017K/W
0.01
DSC
0.0085K/W
1000
0.001
0.0001
0.00001
100
0
0.5 1 1.5 2 2.5 3
Instantaneous on-state voltage - VT (V)
3.5
Figure 3 - Gate characteristics - Trigger limits
8
K2960T#450-520
Issue 2
Tj=25°C
7
6
Max VG dc
5
4
IGT, VGT
3
2
1
IGD, VGD
0
0
Min VG dc
0.25 0.5 0.75 1 1.25
Gate Trigger Current - IGT (A)
1.5
0.000001
1E-05 0.0001 0.001 0.01 0.1 1 10 100
Figure 4 - Gate characteristics - Power curves
20
K2960T#450-520
Issue 2
18 Tj=25°C
16
Max VG dc
14
12
10
PG Max 50W dc
8
6
4 PG 5W dc
Min VG dc
2
0
0 2 4 6 8 10
Gate Trigger Current - IGT (A)
Provisional Data Sheet. Types K2960T#450 to K2960T#520 Issue 2
Page 6 of 11
October, 2003

6 Page



ページ 合計 : 11 ページ
 
PDF
ダウンロード
[ K2960TT460 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
K2960TT460

Medium Voltage Thyristor

IXYS
IXYS


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap