DataSheet.jp

7805SRH-C の電気的特性と機能

7805SRH-CのメーカーはmuRataです、この部品の機能は「3.3V/5V/12V Outputs High-Effi ciency Switching Regulators」です。


製品の詳細 ( Datasheet PDF )

部品番号 7805SRH-C
部品説明 3.3V/5V/12V Outputs High-Effi ciency Switching Regulators
メーカ muRata
ロゴ muRata ロゴ 




このページの下部にプレビューと7805SRH-Cダウンロード(pdfファイル)リンクがあります。

Total 7 pages

No Preview Available !

7805SRH-C Datasheet, 7805SRH-C PDF,ピン配置, 機能
www.murata-ps.com
78xxSR Series
3.3V/5V/12V Outputs High-Efficiency
Switching Regulators with LM78xx Pinouts
FEATURES
3.3V/0.5A, 5V/0.5A or 12V/0.4A outputs; Pin and
size-compatible with LM7805 & LM7812 regulators
Up to 95% efficiency – no heat sinks or thermal
derating required
Two SIP-packages fit existing TO-220 footprints:
- Vertical-pin models occupy less than 0.1 square in.
- Optional horizontal pins provide 0.350 in. installed
height
+7.5-36Vdc operating input range; Low 3mA
quiescent current
Built-in filter capacitors – no external components
required
–40 to +70°C operation at full load; Short-circuit
protection
Excellent load (±0.2%) and line (±0.3%) regulation
Ideal for powering instrumentation from
9V/12V/24V/28V supplies or batteries
Can be used with unregulated dc supplies
protection
Ordering Information
MPS Part No.
Output
Voltage
Standard Pin Package
7803SR-C
+3.3Vdc
7805SR-C
+5.0Vdc
7812SR-C
+12.0Vdc
Horizontal Pin Package
7803SRH-C
+3.3Vdc
7805SRH-C
+5.0Vdc
7812SRH-C
+12.0Vdc
Output
Current
0.5A
0.5A
0.4A
0.5A
0.5A
0.4A
Input
Voltage
+7.5-36Vdc
+7.5-36Vdc
+15-36Vdc
+7.5-36Vdc
+7.5-36Vdc
+15-36Vdc
For full details go to
www.murata-ps.com/rohs
www.murata-ps.com/support
Murata Power Solutions’ 7805SR-C (5V output), 7812SR-C (12V output) and 7803SR-C
(3.3V output) step-down switching regulators are modern drop-in replacements for older,
inefficient, LM7805 and LM7812 linear regulators. The 78XXSR's are pin- and size-compat-
ible with industry-standard TO-220 SIP packages. A 260kHz switching frequency provides
for efficiencies as high as 95%. Full-load (up to 0.5A) operation from 9V, 12V, 24V, or 36V
supplies at ambient temperatures up to +70°C requires no heat sinks, no temperature
derating, no forced-air cooling, and no external capacitors.
78SR switching regulators provide many significant improvements over their linear coun-
terparts: lower quiescent current (3mA vs. 5 mA), higher input voltage (40V vs. 32V), and
better output accuracy (±2% vs. ±5%). All these features combine to make 78SR regulators
ideal for new or existing LM7805 & LM7812 applications requiring full-load operation at
elevated voltages.
TECHNICAL NOTES
1. Input/Output (I/O) Filtering: As shown in the noise and ripple graphs, 78SR switching
regulators exhibit excellent low-noise performance with no external I/O capacitors.
However, if additional noise reduction is required, be sure to use low-ESR capacitors
that are rated for continuous operation (with an additional 20% safety margin) at the
highest system voltages and temperatures. Adding external output capacitors will also
improve the unit’s load-transient response.
Applications in which 78SR regulators are located more than 24 inches (61cm) from
the input power supply should include an external 47uF/50V (or greater) aluminum
electrolytic capacitor, connected as close as possible to the regulator’s +Vin and
GND terminals (pins 1 and 2). An external input capacitor is particularly important if
the input voltage is applied to the regulator via a mechanical switch or relay. Contact
bounce at turn-on can produce large inductive current-spikes, and these current
spikes can generate damaging voltage transients at the regulator’s input terminals.
2. Input Fusing: 78SR switching regulators are not internally fused. If fusing their input
and/or output terminals is required, use the data shown in the Efficiency Curves as a
guide to selecting an appropriate slow-blow fuse.
3. Input-Output Isolation: 78SR regulators’ internal input and output circuits share a
common connection (GND, pin 2); there is no electrical isolation between the INPUT
(pin 1) and OUTPUT (pin 3) terminals.
4. Overvoltage Protection: 78SR switching regulators do not provide input or output
overvoltage protection. In the extremely rare situation in which a catastrophic failure
occurs, the output voltage may rise to excessively high levels. If your load must be
protected against all possible overvoltage situations, external voltage-limiting circuitry
must be provided.
5. Operation at 40Vdc: Operating with inputs up to 40Vdc is permissible if, for inputs
between 36 and 40Vdc, the maximum load current is reduced to 0.35A for 7805SR-C
and 7803SR-C, and to 0.3A for 7812SR-C. Under no circumstances should the input
voltage be allowed to exceed 45Vdc.
30 Oct 2015 MDC_78xxSR Series.B07 Page 1 of 7

1 Page





7805SRH-C pdf, ピン配列
Typical Performance Curves TA = +25°C, VIN as indicated
78xxSR Series
3.3V/5V/12V Outputs High-Efficiency
Switching Regulators with LM78xx Pinouts
Noise and Ripple - 10% and 100% Load, 20MHz Bandwidth
7803SR-C Vin = 12V, ILOAD = 50mA
7805SR-C Vin = 12V, ILOAD = 50mA
7812SR-C Vin = 24V, ILOAD = 40mA
7803SR-C Vin = 12V, ILOAD = 500mA
7805SR-C Vin = 12V, ILOAD = 500mA
7812SR-C Vin = 24V, ILOAD = 400mA
www.murata-ps.com/support
30 Oct 2015 MDC_78xxSR Series.B07 Page 3 of 7


3Pages


7805SRH-C 電子部品, 半導体
SHIPPING TRAYS AND BOXES
78xxSR Series
3.3V/5V/12V Outputs High-Efficiency
Switching Regulators with LM78xx Pinouts
EACH FOAM TRAY (2300276) CONTAINS 50 UNITS IN FULL MPQ
QUANTITIES, TWO TRAYS EQUAL TO A TOTAL OF 100(2x50) UNITS PER
CARTON.
www.murata-ps.com/support
30 Oct 2015 MDC_78xxSR Series.B07 Page 6 of 7

6 Page



ページ 合計 : 7 ページ
 
PDF
ダウンロード
[ 7805SRH-C データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
7805SRH-C

3.3V/5V/12V Outputs High-Effi ciency Switching Regulators

muRata
muRata


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap