|
|
PDF STK5C4U332J-E Data sheet ( Hoja de datos )
| Número de pieza | STK5C4U332J-E | |
| Descripción | Intelligent Power Module | |
| Fabricantes | ON Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de STK5C4U332J-E (archivo pdf) en la parte inferior de esta página. Total 14 Páginas | ||
|
No Preview Available !
STK5C4U332J-E
Advance Information
Intelligent Power Module (IPM)
600 V, 3 A
The STK5C4U332J-E is a fully-integrated inverter power stage consisting
of a high-voltage driver, six IGBT’s and a thermistor, suitable for driving
permanent magnet synchronous (PMSM) motors, brushless-DC (BLDC)
motors and AC asynchronous motors. The IGBT’s are configured in a 3-
phase bridge with separate emitter connections for the lower legs for
maximum flexibility in the choice of control algorithm.
The power stage has a full range of protection functions including cross-
conduction protection, external shutdown and under-voltage lockout
functions. An internal comparator and reference connected to the over-
current protection circuit allows the designer to set the over-current
protection level.
Features
Three-phase 3 A / 600 V IGBT module with integrated drivers
Typical values : VCE(sat) = 1.3 V, VF = 1.3 V, ESW = 115 J at 1.5 A
Compact 29.6 mm 18.2 mm dual in-line package
Cross-conduction protection
Adjustable over-current protection level
Integrated bootstrap diodes and resistors
Enable pin
Certification
UL1557 (File number : E339285)
Typical Applications
Industrial Pumps
Industrial Fans
Industrial Automation
Home Appliances
www.onsemi.com
PACKAGE PICTURE
MODULE 29.6x18.2 DIP S
MARKING DIAGRAM
STK5C4U332J = Specific Device Code
A = Year
B = Month
C = Production Site
DD = Factory Lot Code
Device marking is on package underside
ORDERING INFORMATION
Device
STK5C4U332J-E
Package
MODULE
29.6x18.2 DIP S
(Pb-Free)
Shipping
(Qty / Packing)
16 / Tube
Figure 1. Functional Diagram
This document contains information on a new product. Specifications and information
herein are subject to change without notice.
© Semiconductor Components Industries, LLC, 2016
October 2016 - Rev. P5
1
Publication Order Number :
STK5C4U332J-E/D
1 page  
STK5C4U332J-E
ABSOLUTE MAXIMUM RATINGS (Notes 1, 2)
Rating
Symbol
Conditions
Value
Unit
Supply voltage
VCC
VP to NU,NV,NW, surge < 500 V (Note 3) 450 V
Collector-emitter voltage
VCE max
VP to U,V,W; U to NU; V to NV; W to NW
600 V
Output current
Output peak current
Gate driver supply voltages
Input signal voltage
FAULT terminal voltage
RCIN terminal voltage
Io
Iop
VBS
VIN
VFAULT
VRCIN
VP,U,V,W,NU,NV,NW terminal current
VP,U,V,W,NU,NV,NW terminal current,
Tc = 100C
VP,U,V,W,NU,NV,NW terminal current,
pulse width 1ms
VBU to U, VBV to V, VBW to W, VDD to GND
(Note 4)
HINU, HINV, HINW, LINU, LINV, LINW
FAULT terminal
RCIN terminal
±3
±1.5
±6
0.3 to +20.0
0.3 to VDD
0.3 to VDD
0.3 to VDD
A
A
A
V
V
V
V
ITRIP terminal voltage
VITRIP
ITRIP terminal
0.3 to +10.0
V
ENABLE terminal voltage
VENABLE
ENABLE terminal
0.3 to VDD
V
Maximum power dissipation
Pd
IGBT per 1 channel
11.3 W
Junction temperature
Tj
IGBT, Gate driver IC
150 C
Storage temperature
Tstg
40 to +125
C
Operating case temperature
Tc
IPM case temperature
20 to +100
C
Package mounting torque
Case mounting screw
0.6 Nm
Isolation voltage
Vis
50 Hz sine wave AC 1 minute (Note 5)
2000
Vrms
1. Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device
functionality should not be assumed, damage may occur and reliability may be affected.
2. Refer to ELECTRICAL CHARACTERISTICS, RECOMMENDED OPERATING RANGES and/or APPLICATION INFORMATION for
Safe Operating parameters.
3. This surge voltage developed by the switching operation due to the wiring inductance between VP and NU,NV,NW terminals.
4. VBS = VBU to U, VBV to V, VBW to W.
5. Test conditions : AC 2500 V, 1 s.
RECOMMENDED OPERATING RANGES (Note 6)
Rating
Symbol
Min Typ Max
Unit
Supply voltage
VCC
VP to NU,NV,NW
0 280 450
V
Gate driver supply voltage
VBS
VDD
VBU to U, VBV to V, VBW to W
VDD to GND (Note 4)
12.5 15 17.5
13.5 15 16.5
V
V
ON-state input voltage
OFF-state input voltage
VIN(ON)
VIN(OFF)
HINU, HINV, HINW, LINU, LINV, LINW
2.5
0
VDD
0.8
V
PWM frequency
fPWM
1 20 kHz
Dead time
DT Turn-off to turn-on (external)
1.3
μs
Allowable input pulse width
PWIN
ON and OFF
1 μs
Package mounting torque
‘M3’ type screw
0.4 0.6
6. Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to
stresses beyond the Recommended Operating Ranges limits may affect device reliability.
Nm
www.onsemi.com
5
5 Page 
Mounting Instructions
STK5C4U332J-E
Item
Pitch
Screw
Washer
Recommended Condition
26.0 ±0.1 mm (Please refer to Package Outline Diagram)
Diameter : M3
Screw head types : pan head, truss head, binding head
Plane washer dimensions (Figure 14)
D = 7 mm, d = 3.2 mm and t = 0.5 mm JIS B 1256
Heat sink
Torque
Grease
Material: Aluminum or Copper
Warpage (the surface that contacts IPM ) : 50 to 50 μm
Screw holes must be countersunk.
No contamination on the heat sink surface that contacts IPM.
Temporary tightening : 50 to 60% of final tightening on first screw
Temporary tightening : 50 to 60% of final tightening on second screw
Final tightening : 0.4 to 0.6 Nm on first screw
Final tightening : 0.4 to 0.6 Nm on second screw
Silicone grease.
Thickness : 50 to 100 μm
Uniformly apply silicone grease to whole back.
Thermal foils are only recommended after careful evaluation. Thickness, stiffness and
compressibility parameters have a strong influence on performance.
Recommended
Not Recommended
Silicone grease
Figure 15. Module Mounting details : components ; washer drawing ; need for even spreading of thermal grease
www.onsemi.com
11
11 Page | ||
| Páginas | Total 14 Páginas | |
| PDF Descargar | [ Datasheet STK5C4U332J-E.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| STK5C4U332J-E | Intelligent Power Module | ON Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |