|
|
PDF ISL78206 Data sheet ( Hoja de datos )
| Número de pieza | ISL78206 | |
| Descripción | 40V 2.5A Buck Controller | |
| Fabricantes | Intersil | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ISL78206 (archivo pdf) en la parte inferior de esta página. Total 19 Páginas | ||
|
No Preview Available !
DATASHEET
40V 2.5A Buck Controller with Integrated High-side
MOSFET
ISL78206
The ISL78206 is an AEC-Q100 qualified 40V, 2.5A synchronous
buck controller with a high-side MOSFET and low-side driver
integrated. The ISL78206 supports a wide input voltage range
from 3V to 40V, output current up to 2.5A, and can be
operated in synchronous and non-synchronous buck
topologies. The ISL78206 provides a low system cost, high
efficiency, single part buck solution for automotive
applications for a wide variety of input voltages. For vehicle
systems that must be kept powered during cold-cranking or
start-stop operation, the ISL78206 can be replaced by its
pin-to-pin alternative, the ISL78201 which offers boost-buck
operation. Together, these devices offer two functional
alternatives on the same PCB layout, providing convenience,
flexibility, and facilitating extensive design reuse.
The ISL78206 offers the most robust current protections. It
uses peak current mode control with cycle-by-cycle current
limiting. It is implemented with frequency foldback
undercurrent limit conditions. In addition, the hiccup
overcurrent mode is also implemented to guarantee reliable
operations under harsh short conditions.
The ISL78206 has comprehensive protections against various
faults, including overvoltage, undervoltage, programmable
overcurrent and over-temperature. Built-in soft-start allows the
IC to start-up smoothly and is reactivated during hiccup mode
fault recovery.
Features
• Ultra wide input voltage range 3V to 40V (refer to “Input
Voltage” on page 12 for more details)
• Less than 5µA (max) shutdown input current (IC disabled)
• Temperature range -40°C to +105°C
• Integrated high-side MOSFET
• Operational topologies
- Synchronous buck
- Non-synchronous buck
• Programmable frequency from 200kHz to 2.2MHz and
frequency synchronization capability
• ±1% tight voltage regulation accuracy
• Reliable cycle-by-cycle overcurrent protection
- Temperature compensated current sense
- Frequency foldback
- Programmable OC limit
- Hiccup mode protection in worst case short condition
• 20 Ld HTSSOP package, pin-to-pin compatible with
ISL78201 boost buck
• AEC-Q100 qualified
• Pb-free (RoHS compliant)
Applications
• Automotive applications
• General purpose power regulator
• 24V bus power
• Battery power
• Embedded processor and I/O supplies
PGOOD
EN
SYNC
FS
VCC
ILIMIT
SS
ISL78206
VIN
BOOT
PHASE
LGATE
DGND
SGND
PGND
FB
COMP
VIN
VOUT
FIGURE 1. TYPICAL APPLICATION SCHEMATIC I - SYNCHRONOUS
BUCK
100
95 6V
90
85
80
75
70
65
60
55
50
45
40
35
300.0
12V
0.5
24V
40V
1.0 1.5
LOAD CURRENT (A)
2.0
2.5
FIGURE 2. EFFICIENCY, SYNCHRONOUS BUCK, 500kHz, VOUT 5V,
TA = +25°C
March 25, 2015
FN8618.2
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2013-2015. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.
1 page  
ISL78206
Typical Application Schematic I - Synchronous Buck
PGOOD
EN
SYNC
FS
VCC
ILIMIT
SS
ISL78206
VIN
BOOT
PHASE
LGATE
DGND
SGND
PGND
FB
COMP
VIN
VOUT
FIGURE 4. TYPICAL APPLICATION SCHEMATIC I - SYNCHRONOUS BUCK
Typical Application Schematic II - Non-Synchronous Buck
PGOOD
EN
SYNC
FS
VCC
ILIMIT
SS
ISL78206
VIN
BOOT
PHASE
LGATE
PGND
DGND
SGND
FB
COMP
VIN
VOUT
FIGURE 5. TYPICAL APPLICATION SCHEMATIC II - NON-SYNCHRONOUS BUCK
Submit Document Feedback
5
FN8618.2
March 25, 2015
5 Page 
ISL78206
Typical Performance Curves (Continued)
VOUT 100mV/DIV (5V OFFSET)
IOUT 1A/DIV
PHASE 20V/DIV
1ms/DIV
FIGURE 17. VIN 24V, 0A TO 2A STEP LOAD
PHASE 5V/DIV
VOUT 10mV/DIV (5V OFFSET)
20µs/DIV
FIGURE 18. NON-SYNCHRONOUS BUCK, FORCE PWM MODE,
VIN 12V, NO LOAD
PHASE 10V/DIV
VOUT 10mV/DIV (5V OFFSET)
5µs/DIV
FIGURE 19. NON-SYNCHRONOUS BUCK, FORCE PWM MODE, VIN 12V, 2A
Submit Document Feedback 11
FN8618.2
March 25, 2015
11 Page | ||
| Páginas | Total 19 Páginas | |
| PDF Descargar | [ Datasheet ISL78206.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ISL78200 | 2.5A Regulator |  Intersil Corporation |
| ISL78201 | 40V 2.5A Regulator | Intersil |
| ISL78205 | 2.5A Buck Controller | Intersil Corporation |
| ISL78206 | 40V 2.5A Buck Controller | Intersil |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |