DataSheet.jp

HI-1582 の電気的特性と機能

HI-1582のメーカーはHOLTICです、この部品の機能は「3.3V Single Transceiver」です。


製品の詳細 ( Datasheet PDF )

部品番号 HI-1582
部品説明 3.3V Single Transceiver
メーカ HOLTIC
ロゴ HOLTIC ロゴ 




このページの下部にプレビューとHI-1582ダウンロード(pdfファイル)リンクがあります。

Total 11 pages

No Preview Available !

HI-1582 Datasheet, HI-1582 PDF,ピン配置, 機能
February 2016
DESCRIPTION
The HI-1582 low power CMOS transceiver is designed to
meet the requirements of the MIL-STD-1553 and MIL-
STD-1760 specifications. It is a pin-compatible, form and fit
drop-in replacement for the Data Device Corporation MIL-
STD-1553 transceiver, BU-63133L8.
The transmitter section of each bus takes complementary
CMOS / TTL Manchester II bi-phase data and converts it to
differential voltages suitable for driving the bus isolation
transformer. A transmitter inhibit control signal is provided.
The receiver section converts the 1553 bus bi-phase data
to complementary CMOS / TTL data suitable for input to a
Manchester decoder. The receiver has a separate enable
input pin, STROBE, which, when low, forces the receiver
outputs to logic "0".
The HI-1582 is packaged in a 32-pin plastic chip-carrier
package (QFN) with an integral exposed heatsink on the
package bottom. The heatsink may be soldered to the PCB
ground plane for optimal thermal dissipation. The HI-1582
is available in industrial (-40°C to +85°C) or extended
(-55°C to +125°C) temperature range options.
HI-1582
MIL-STD-1553 / MIL-STD-1760
3.3V Single Transceiver
PIN CONFIGURATIONS
TX DATA OUT 1
VCC 2
GROUND 3
SLEEP 4
-5
-6
VCC 7
RX DATA 8
1582PCI
1582PCT
24 -
23 TX DATA OUT
22 VCC
21 GROUND
20 TX DATA IN
19 TX DATA IN
18 TX INHIBIT
17 RX DATA IN
32 Pin Plastic 7mm x 7mm
Chip-scale package
FEATURES
! Compliant to MIL-STD-1553A and B,
MIL-STD-1760 and ARINC 708A
! 3.3V single supply operation
! Small 7mm x 7mm 32-pin plastic chip-scale
package
! Less than 0.5W maximum power dissipation
! Single Transceiver allows full dual redundancy
! Drop in replacement for Data Device
Corporation BU-63133L8
(DS1582 Rev. B)
HOLT INTEGRATED CIRCUITS
www.holtic.com
02/16

1 Page





HI-1582 pdf, ピン配列
TX DATA IN
TX DATA IN
TX INHIBIT
SLEEP
RX DATA OUT
RX DATA OUT
STROBE
HI-1582
HI-1582
+3.3V
VDD
SHAPING
NETWORK
SHAPING
NETWORK
TX DATA OUT
TX DATA OUT
FILTER
LIMITER
RX DATA IN
RX DATA IN
GND
Figure 1. Block Diagram
0.1 µF
10 µF
MIL-STD-1553
BUS
Isolation
Transformer
1:2.5
SHORT OR
LONG STUB
COUPLING
TX DATA IN
TX DATA IN
TX DATA OUT - TX DATA OUT
Figure 2. Transmit Waveform - Example Pattern
HOLT INTEGRATED CIRCUITS
3


3Pages


HI-1582 電子部品, 半導体
HI-1582
DC ELECTRICAL CHARACTERISTICS (cont.)
VCC = 3.3 V, GND = 0V, TA =Operating Temperature Range (unless otherwise specified).
` TRANSMITTER (Measured at Point “AD” in Figure 5 unless otherwise specified)
Output Voltage
Direct coupled
Transformer coupled
VOUT
VOUT
35 ohm load
(Measured at Point “AD“ in Figure 5)
70 ohm load
(Measured at Point “AT“ in Figure 6)
Output Noise
VON Differential, inhibited
Output Dynamic Offset Voltage Direct coupled
Transformer coupled
VDYN
VDYN
35 ohm load
(Measured at Point “AD“ in Figure 5)
70 ohm load
(Measured at Point “AT“ in Figure 6)
Output resistance
ROUT
Differential, not transmitting
Output Capacitance
COUT
1 MHz sine wave
6.0
20.0
-90
-250
10
9.0 Vp-p
27.0 Vp-p
10.0 mVp-p
90 mV
250 mV
Kohm
15 pF
AC ELECTRICAL CHARACTERISTICS
VCC = 3.3 V, GND = 0V, TA =Operating Temperature Range (unless otherwise specified).
PARAMETER
SYMBOL TEST CONDITIONS
RECEIVER
(Measured at Point “AT” in Figure 6)
Receiver Delay (Note 1)
tDR From input signal zero crossing to corresponding
zero crossing in RX DATA OUT or RX DATA OUT
Receiver output pulse width
tPW
(Note 1)
Receiver gap time (Note 1)
tRG
Spacing between RX DATA OUT
and RX DATA OUT pulses
MIN
70
Note 3
90
Note 2
Receiver Enable Delay
tREN From STROBE rising or falling edge to
RX DATA OUT or RX DATA OUT
TYP
MAX UNITS
450
Note 4
430
Note 3
40
ns
ns
ns
ns
Note 1. This parameter varies with receive signal amplitude. See Receiver Waveforms, Figure 3.
Note 2. Measured using a 1 MHz sinusoid, 20 V peak to peak, line-to-line at Point "AT" (Guaranteed but not tested.)
Note 3. Measured transformer-coupled mode using a 1 MHz sinusoid, 860 mV peak to peak line-to-line at Point "AT" (100% tested).
Note 4. Measured transformer-coupled mode using a 1 MHz sinusoid 860 mV peak to peak, line-to-line at Point "AT".
TRANSMITTER (Measured at Point “AT” in Figure 6)
Driver Delay
tDT TX DATA IN, TX DATA IN to
TX DATA OUT, TX DATA OUT
Rise time
tr 70 ohm resistive load
Fall Time
tf 70 ohm resistive load
Transmit Inhibit Delay
tDI-H
Disable bus output
tDI-L Enable bus output
100
100
150 ns
300 ns
300 ns
100 ns
150 ns
HOLT INTEGRATED CIRCUITS
6

6 Page



ページ 合計 : 11 ページ
 
PDF
ダウンロード
[ HI-1582 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
HI-1581

3.3V Monolithic Dual Transceivers

HOLTIC
HOLTIC
HI-1582

3.3V Single Transceiver

HOLTIC
HOLTIC


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap