DataSheet.jp

AH118 の電気的特性と機能

AH118のメーカーはWJ Communicationです、この部品の機能は「High Linearity InGaP HBT Amplifier」です。


製品の詳細 ( Datasheet PDF )

部品番号 AH118
部品説明 High Linearity InGaP HBT Amplifier
メーカ WJ Communication
ロゴ WJ Communication ロゴ 




このページの下部にプレビューとAH118ダウンロード(pdfファイル)リンクがあります。

Total 8 pages

No Preview Available !

AH118 Datasheet, AH118 PDF,ピン配置, 機能
AH118
¼ Watt, High Linearity InGaP HBT Amplifier
The Communications Edge TM
Product Information
Product Features
60 – 3500 MHz
+24.7 dBm P1dB
+40.5 dBm Output IP3
20.4 dB Gain @ 900 MHz
16.5 dB Gain @ 1900 MHz
+5V Single Positive Supply
Lead-free/Green/RoHS-
compliant SOT-89 Package
Applications
Final stage amplifiers for
Repeaters
Mobile Infrastructure
DBS / WLL / W-LAN
Defense / Homeland Security
Product Description
The AH118 is a high dynamic range driver amplifier in a
low-cost surface mount package. The InGaP/GaAs HBT is
able to achieve high performance across a broad range with
+40.5 dBm OIP3 and +24.7 dBm of compressed 1dB
power. The AH118 is available in a lead-free/green/RoHS-
compliant SOT-89 package. All devices are 100% RF and
DC tested.
The AH118 is targeted for use as a driver amplifier in
wireless infrastructure where high linearity and medium
power is required. Internal biasing allows the AH118 to
maintain high linearity over temperature and operate
directly off a single +5V supply. This combination makes
the device an excellent candidate for transceiver line cards
in current and next generation multi-carrier 3G base
stations.
Functional Diagram
GND
4
1
RF IN
2
GND
3
RF OUT
Function
Input / Base
Output / Collector
Ground
Pin No.
1
3
2, 4
Specifications (1)
Typical Performance (3)
Parameter
Operational Bandwidth
Test Frequency
Gain
Input Return Loss
Output Return Loss
Output P1dB
Output IP3 (2)
IS-95A Channel Power
@ -45 dBc ACPR
wCDMA Channel Power
@ -45 dBc ACLR, 2140 MHz
Noise Figure
Operating Current Range
Device Voltage
Units
MHz
MHz
dB
dB
dB
dBm
dBm
dBm
dBm
dB
mA
V
Min
60
13.5
+23
+39.5
140
Typ
1900
16.5
12
20
+24.7
+40.5
+18
+16.7
4.3
160
+5
Max
3500
175
1. Test conditions unless otherwise noted: 25ºC, Vsupply = +5 V, in tuned application circuit.
2. 3OIP measured with two tones at an output power of +11 dBm/tone separated by 1 MHz. The
suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule.
Parameter
Frequency
S21 - Gain
S11 - Input R.L.
S22 - Output R.L.
Output P1dB
Output IP3
IS-95A Channel Power
@ -45 dBc ACPR,
wCDMA Channel Power
@ -45 dBc ACLR
Noise Figure
Supply Bias
Units
MHz
dB
dB
dB
dBm
dBm
dBm
dBm
dB
Typical
900 1900 2140
20.4 16.5 16.3
-15 -12 -15
-12 -20 -16
+24.2 +24.7 +24.7
+40 +40.5 +40.5
+18.2 +18
+16.7
4.0 4.3 4.8
+5 V @ 160 mA
3. Typical parameters reflect performance in a tuned application circuit: Vsupply = +5 V, 160 mA,
+25 °C
Absolute Maximum Rating
Parameter
Operating Case Temperature
Storage Temperature
RF Input Power (continuous)
Device Voltage
Device Current
Junction Temperature
Rating
-40 to +85 °C
-65 to +150 °C
+15 dBm
+6 V
220 mA
+250 °C
Ordering Information
Part No.
AH118-89G
AH118-89PCB900
AH118-89PCB1900
AH118-89PCB2140
Description
High Linearity InGaP HBT Amplifier
(lead-free/green/RoHS-compliant SOT-89 package)
900 MHz Evaluation Board
1900 MHz Evaluation Board
2140 MHz Evaluation Board
Operation of this device above any of these parameters may cause permanent damage.
Specifications and information are subject to change without notice
WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: [email protected] Web site: www.wj.com
Page 1 of 8 May 2006

1 Page





AH118 pdf, ピン配列
AH118
¼ Watt, High Linearity InGaP HBT Amplifier
The Communications Edge TM
Product Information
900 MHz Application Circuit (AH118-89PCB900)
Frequency
Gain
Input Return Loss
Output Return Loss
Output P1dB
Output IP3
(+11 dBm / tone, 1 MHz spacing)
Channel Power
(@-45 dBc ACPR, IS-95 9 channels fwd)
Noise Figure
Device / Supply Voltage
Quiescent Current
900 MHz
20.4 dB
15 dB
12 dB
+24.2 dBm
+40 dBm
+18.2 dBm
4 dB
+5 V
160 mA
Vcc = +5 V
All passive components are of size 0603 unless otherwise noted.
The diode D1 is used as over-voltage protection on the evaluation
boards. It is not specifically required in the final circuit layout in
a system using a DC regulator.
Component R1 is shown in the silkscreen but is not used for this
configuration.
L2 - the 0 ohm resistor - can be removed (with a thru line) in the
final circuit layout.
DIODE1
5.6 V
ID=C4
C=100 pF
ID=L2
R=0 Ohm
ID=C7
C=8.2 pF
C7 should be placed at the silk screen
marker 'C' on the WJ evaluation board.
The capacitor should be placed
6.1° @ 0.9GHz from pin 1 of the AH118
NET="AH118"
IND
ID=L1
L=33 nH
size 0805
ID=C1
C=1e5 pF
size 1206
ID=C2
C=1000 pF
size 0805
ID=C3
C=56 pF
ID=C5
C=100 pF
ID=L3
L=2.7 nH
ID=C9
C=2 pF
C9 should be placed at the
silk screen marker '7' on the
WJ evaluation board.
The capacitor should be placed
15.8° @ 0.9GHz from pin 3
of the AH118.
S21 vs. Frequency
22
21
20
19
18
+25°C -40°C +85°C
17
800 850 900 950
Frequency (MHz)
1000
S11 vs. Frequency
0
+25°C
-40°C
+85°C
-5
-10
-15
-20
-25
-30
800
850 900 950
Frequency (MHz)
1000
ACPRvs. Channel Power
IS-95, 9Ch. Fwd, ±885 kHz offset, 30kHz Meas BW, 900MHz
-40
-50
-60
-70
12
13 14 15 16 17 18
Output Channel Power (dBm)
19
S22 vs. Frequency
0
-5
-10
-15
-20
-25
-30
800
+25°C -40°C +85°C
850 900 950
Frequency (MHz)
1000
Specifications and information are subject to change without notice
WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: [email protected] Web site: www.wj.com
Page 3 of 8 May 2006


3Pages


AH118 電子部品, 半導体
AH118
¼ Watt, High Linearity InGaP HBT Amplifier
The Communications Edge TM
Product Information
Frequency
Gain
Input Return Loss
Output Return Loss
Output P1dB
Output IP3
(+11 dBm / tone, Df=1 MHz)
Noise Figure
Supply Voltage
Current
70 MHz
24.2 dB
17 dB
16 dB
+23.6 dBm
+41 dBm
4.8 dB
+5 V
160 mA
70 MHz Reference Design
Vcc = +5 V
Gain / Return Loss
26 0
DB(|S(1,1)|) (R) DB(|S(2,2)|) (R) DB(|S(2,1)|) (L)
24 -5
22 -10
5.6 V
The diode D1 is used as over-voltage protection on the evaluation
boards. It is not specifically required in the final circuit layout in
a system using a DC regulator.
C=100000 pF
C=1000 pF
L=180 nH
NET="AH118"
C=1000 pF
L=47 nH
C=1000 pF
20 -15
18
16
50
60 70 80
Frequency (MHz)
-20
-25
90
C=100 pF
Frequency
Gain
Input Return Loss
Output Return Loss
Output P1dB
Output IP3
(+11 dBm / tone, Df=1 MHz)
Noise Figure
Supply Voltage
Current
150 MHz
23 dB
21 dB
14 dB
+23.5 dBm
+40 dBm
4.9 dB
+5 V
160 mA
150 MHz Reference Design
Vcc = +5 V
Gain / Return Loss
24 0
DB(|S(1,1)|) (R) DB(|S(2,2)|) (R) DB(|S(2,1)|) (L)
23 -5
5.6 V
The diode D1 is used as over-voltage protection on the
evaluation boards. It is not specifically required in the
final circuit layout in a system using a DC regulator.
22 -10
C=100000 pF
C=1000 pF
L=82 nH
NET="AH118"
21
-15 C=82 pF
C=1000 pF
20 -20
19 -25
120 130 140 150 160 170 180
Frequency (MHz)
L=18 nH
Frequency
Gain
Input Return Loss
Output Return Loss
Output P1dB
Output IP3
(+11 dBm / tone, Df=1 MHz)
Noise Figure
Supply Voltage
Current
340 MHz
20.6 dB
14 dB
13 dB
+24 dBm
+41.4 dBm
5.1 dB
+5 V
160 mA
340 MHz Reference Design
Gain / Return Loss
22 5
DB(|S(1,1)|) (R) DB(|S(2,1)|) (L) DB(|S(2,2)|) (R)
21 0
20 -5
19 -10
+5V
C=1e5 pF
5.6 V
The diode D1 is used as over-voltage protection on the
evaluation boards. It is not specifically required in the
final circuit layout in a system using a DC regulator.
C=1000 pF
L=8.2 nH
R=1.8 Ohm
NET="AH118"
C=1000 pF
L=100 nH
18 -15
17 -20
260 280 300 320 340 360 380 400 420
Frequency (MHz)
C=18 pF
L=15 nH
C=1000 pF
C=5.6 pF
Specifications and information are subject to change without notice
WJ Communications, Inc Phone 1-800-WJ1-4401 FAX: 408-577-6621 e-mail: [email protected] Web site: www.wj.com
Page 6 of 8 May 2006

6 Page



ページ 合計 : 8 ページ
 
PDF
ダウンロード
[ AH118 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
AH11

High Dynamic Range Dual Amplifier

WJ Communication
WJ Communication
AH11

High Dynamic Range Dual Amplifier

TriQuint Semiconductor
TriQuint Semiconductor
AH110

High Linearity InGaP HBT Amplifier

WJ Communication
WJ Communication
AH114

High Linearity InGaP HBT Amplifier

WJ Communication
WJ Communication


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap