DataSheet.jp

1N5376B の電気的特性と機能

1N5376BのメーカーはTRSYSです、この部品の機能は「GLASS PASSIVATED JUNCTION SILICON ZENER DIODE」です。


製品の詳細 ( Datasheet PDF )

部品番号 1N5376B
部品説明 GLASS PASSIVATED JUNCTION SILICON ZENER DIODE
メーカ TRSYS
ロゴ TRSYS ロゴ 




このページの下部にプレビューと1N5376Bダウンロード(pdfファイル)リンクがあります。

Total 5 pages

No Preview Available !

1N5376B Datasheet, 1N5376B PDF,ピン配置, 機能
1N5348B THRU 1N5388B
GLASS PASSIVATED JUNCTION SILICON ZENER DIODE
VOLTAGE - 11 TO 200 Volts Power - 5.0 Watts
FEATURES
l Low profile package
l Built-in strain relief
l Glass passivated junction
l Low inductance
l Typical ID less than 1 A above 13V
l High temperature soldering :
260 /10 seconds at terminals
l Plastic package has Underwriters Laboratory
Flammability Classification 94V-O
DO-201AE
MECHANICAL DATA
Case: JEDEC DO-201AE Molded plastic over passivated junction
Terminals: Solder plated, solderable per MIL-STD-750,
method 2026
Standard Packaging: 52mm tape
Weight: 0.04 ounce, 1.1 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ambient temperature unless otherwise specified.
DC Power Dissipation @ TL=75 , Measure at Zero Lead Length(Fig. 1)
Derate above 75 (Note 1)
Peak forward Surge Current 8.3ms single half sine-wave superimposed on rated
load(JEDEC Method) (Note 1,2)
Operating Junction and Storage Temperature Range
SYMBOL
PD
IFSM
TJ,TSTG
VALUE
5.0
40.0
See Fig. 5
UNITS
Watts
mW/
Amps
-55 to +150
NOTES:
1. Mounted on 8.0mm2 copper pads to each terminal.
2. 8.3ms single half sine-wave, or equivalent square wave, duty cycle = 4 pulses per minute maximum.

1 Page





1N5376B pdf, ピン配列
3. SURGE CURRENT (Ir) - Surge current is specified as the maximum allowable peak, non-recurrent square-wave
current with a pulse width, PW, of 8.3 ms. The data given in Figure 5 may be used to find the maximum surge
current for a quare wave of any pulse width between 1 ms and 1000ms by plotting the applicable points on
logarithmic paper. Examples of this, using the 6.8v and 200V zeners, are shown in Figure 6. Mounting
contact located as specified in Note 3. (TA=25 ).
4. VOLTAGE REGULATION ( Vz) - Test conditions for voltage regulation are as follows: Vz measurements are made
at 10% and then at 50% of the Iz max value listed in the electrical characteristics table. The test currents are the
same for the 5% and 10% tolerance devices. The test current time druation for each Vz measurement is 40±10 ms.
(TA=25 ). Mounting contact located as specified in Note2.
5. MAXIMUM REGULATOR CURRENT (IZM) - The maximum current shown is based on the maximum voltage of a
5% type unit. Therefore, it applies only to the B-suffix device. The actual IZM for any device may not exceed the
value of 5 watts divided by the actual Vz of the device. TL=75 at maximum from the device body.
RATING AND CHARACTERISTICS CURVES
1N5348B THRU 1N5388B
TEMPERATURE COEFFICIENTS
Fig. 1-POWER TEMPERATURE DERATING CURVE Fig. 2-TEMPERATURE COEFFICIENT RANGE
FOR UNITS 6 TO 220 VOLTS
Fig. 3-TYPICAL THERMAL RESPONSE


3Pages





ページ 合計 : 5 ページ
 
PDF
ダウンロード
[ 1N5376B データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
1N5376

Diode Zener Single 87V 20% 5W 2-Pin Case T-18

New Jersey Semiconductor
New Jersey Semiconductor
1N5376

Diode Zener Single 87V 20% 5W 2-Pin Case T-18

New Jersey Semiconductor
New Jersey Semiconductor
1N5376

Diode Zener Single 87V 20% 5W 2-Pin Case T-18

New Jersey Semiconductor
New Jersey Semiconductor
1N5376

Diode Zener Single 87V 20% 5W 2-Pin Case T-18

New Jersey Semiconductor
New Jersey Semiconductor


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap