DataSheet.jp

NSNJ9200 の電気的特性と機能

NSNJ9200のメーカーはNew Japan Radioです、この部品の機能は「SAW FILTER」です。


製品の詳細 ( Datasheet PDF )

部品番号 NSNJ9200
部品説明 SAW FILTER
メーカ New Japan Radio
ロゴ New Japan Radio ロゴ 




このページの下部にプレビューとNSNJ9200ダウンロード(pdfファイル)リンクがあります。
Total 4 pages

No Preview Available !

NSNJ9200 Datasheet, NSNJ9200 PDF,ピン配置, 機能
NSNJ9200 Apr. 2014
New JRC SAW FILTER
NSNJ9200
Application
1582.471MHz GPS / GLONASS / Beidou
Electrical Specification: (Table 1)
The device characteristics are measured in the circuit shown in Fig.1.
Table 1. Electrical Specifications
Item
Spec.
Typical
Input and Output Impedance
- 50
Nominal Center Frequency (f0)
-
Insertion Loss
1559.052~1563.144MHz 3.5dB max.(*1)
1582.471MHz
2.5dB
1574.42~1576.42MHz
1597.55~1605.89MHz
4.0dB max.
3.0dB max.
3.5dB max. (*1)
2.0dB
2.5dB
Ripple Deviation
Input and Output VSWR
Group Delay Time Deviation
Out of Band Rejection
(Relative to
Through Level)
Maximum Rating: (Table 2)
4.0dB max.
1559.052~1563.144MHz 2.0dB max.
0.5dB
1574.42~1576.42MHz
1.5dB max.
0.3dB
1597.55~1605.89MHz
2.0dB max.
0.5dB
1559.052~1563.144MHz
2.5 max.
1.4
1574.42~1576.42MHz
2.5 max.
1.4
1597.55~1605.89MHz
2.5 max.
1.7
1597.55~1605.89MHz
15ns max.
5ns
0.3~960MHz
34dB min.
43dB
1427~1463MHz
35dB min.
41dB
1625~1660MHz
15dB min.
27dB
1710~1785MHz
40dB min.
47dB
1850~1910MHz
40dB min.
43dB
1920~1980MHz
35dB min.
42dB
2400~2496MHz
30dB min.
33dB
2496~2690MHz
25dB min.
30dB
(*1) (Operating Temperature Range: -40~+85ºC)
(Operating Temperature Range: -40~+105ºC)
Table 2. Maximum Ratings
Item Rating
Maximum Input Power
+10dBm
Maximum DC Voltage
Operating Temperature Range
Storage Temperature
7.5V
-40~+105ºC
-40~+110ºC
Mechanical Specifications: (Fig.2)
Package is designed as small as 2.0x1.6x0.65[mm3] for SMD (Surface Mount Device) type.
Notice:
This part is electrostatic discharge sensitive and may be damaged by improper handling.
http://www.njr.co.jp/products/device/index.html
http://www.njr.com/products/device/index.html

1 Page





NSNJ9200 pdf, ピン配列
NSNJ9200 Apr. 2014
Notice
1. Use this component within operating temperature range. It might not be
satisfied with electrical specification without operating temperature range.
When it is used less than -40ºC or more than +105ºC, it might be a cause of
degradation or destruction of the component. Even if it endures during a short
time, it causes degradation of qualification.
2. When soldering iron is used, solder with the temperature at the tip of soldering
iron: 350ºC max., the time of soldering: 10 seconds max., the power of
soldering iron: 30W max..
3. Notice that the allowed time of soldering with soldering iron is accumulated
time, when soldering is repeated.
4. As rapid temperature change for cleaning after reflow soldering might be a
cause of destruction clean this component after confirming that temperature of
this component goes down to room temperature.
5. Confirm that there are not any influence for qualification to this component in
mounting on PCB when this component is cleaned.
6. As it might be a cause of degradation of destruction to apply static electricity to
this component, do not apply static electricity or excessive voltage while
assembling and measuring. And do not transport this component with bare
hand.
7. As it might be a cause of degradation or destruction to apply D.C. voltage
between each terminal, apply D.C. voltage 7.5V max. in actual circuit.
Note
1. This specification specifies the quality of this component as a single unit. Make
sure that this component is evaluated and confirmed against this specification
when it is mounted to your products.
2. The information contained herein may be changed without prior notice. It is
therefore advisable to contact New Japan Radio Company before proceeding
with the design of equipment incorporating this product.
3. The products are designed to be used with ordinary electronic equipment (data
and communications equipment, office equipment, audio-video equipment,
measuring instruments, etc). New Japan Radio Company does not assume any
liability for the case using the products with the application required high
reliability or safety extremely (such as space equipment, sea-bottom equipment,
medical equipment etc). When intending to use any our product please contact
our sales representatives in advance.


3Pages





ページ 合計 : 4 ページ
 
PDF
ダウンロード
[ NSNJ9200 データシート.PDF ]


データシートを活用すると、その部品の主な機能と仕様を詳しく理解できます。 ピン構成、電気的特性、動作パラメータ、性能を確認してください。


共有リンク

Link :


部品番号部品説明メーカ
NSNJ9200

SAW FILTER

New Japan Radio
New Japan Radio


www.DataSheet.jp    |   2020   |  メール    |   最新    |   Sitemap