IS52SM32400H PDF Data sheet ( 特性 )

部品番号 IS52SM32400H
部品説明 1M x 32Bits x 4Banks Mobile Synchronous DRAM
メーカ ISSI
ロゴ ISSI ロゴ 

Total 30 pages

No Preview Available !

IS52SM32400H Datasheet, IS52SM32400H PDF,ピン配置, 機能
Advanced Information
1M x 32Bits x 4Banks Mobile Synchronous DRAM
These IS42/45SM/RM/VM32400H are mobile 134,217,728 bits CMOS Synchronous DRAM organized as 4 banks of 1,048,576 words x 32
bits. These products are offering fully synchronous operation and are referenced to a positive edge of the clock. All inputs and outputs
are synchronized with the rising edge of the clock input. The data paths are internally pipelined to achieve high bandwidth. All input
and output voltage levels are compatible with LVCMOS.
JEDEC standard 3.3V, 2.5V, 1.8V power supply
Auto refresh and self refresh
All pins are compatible with LVCMOS interface
4K refresh cycle / 64ms
Programmable Burst Length and Burst Type
1, 2, 4, 8 or Full Page for Sequential Burst
4 or 8 for Interleave Burst
Programmable CAS Latency : 2,3 clocks
All inputs and outputs referenced to the positive edge of the
system clock
Data mask function by DQM
Internal 4 banks operation
Burst Read Single Write operation
Special Function Support
PASR(Partial Array Self Refresh)
Auto TCSR(Temperature Compensated Self Refresh)
Programmable Driver Strength Control
Full Strength or 1/2, 1/4, 1/8 of Full Strength
Deep Power Down Mode
Automatic precharge, includes CONCURRENT Auto Precharge
Mode and controlled Precharge
Copyright © 2014 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its
products at any time without notice. ISSI assumes no liability arising out of the application or use of any information, products or services
described herein. Customers are advised to obtain the latest version of this device specification before relying on any published information
and before placing orders for products.
Integrated Silicon Solution, Inc. does not recommend the use of any of its products in life support applications where the failure or
malfunction of the product can reasonably be expected to cause failure of the life support system or to significantly affect its safety or
effectiveness. Products are not authorized for use in such applications unless Integrated Silicon Solution, Inc. receives written assurance to
its satisfaction, that:
a.) the risk of injury or damage has been minimized;
b.) the user assume all such risks; and
c.) potential liability of Integrated Silicon Solution, Inc is adequately protected under the circumstances
Rev. 00A | Nov. 2014 -

1 Page

ページ 合計 : 30 ページ
[ IS52SM32400H.PDF ]


Link :



1M x 32Bits x 4Banks Mobile Synchronous DRAM

ISSI    |   2020   |  メール    |   最新    |   Sitemap